钛胶的制备条件和物性关系

钛胶是新型有广泛用途的催化剂载体。本实验测定了钛胶的孔容、比表面积、铁含量和晶型结构；研究了钛胶的制备条件和物性关系，得到一些有实用价值的实验结果。     

Pt/HM和Pd/HM催化剂表面氧的恢复与供出活化能测定

催化氧化是最重要的工业催化反应之一。七十年代以来,关于氧化催化剂的基础研究取得了长足的进步,采用各种手段对氧化催化剂的表面及体相氧种进行了考察。本文作者根据研究实用氧化催化剂的经验,结合控制论方法,亦提出了多相催化氧化反应的集团结构适应性规律。近年来,作者用TPD和吸附平衡法研究了V_2O_5/SiO_2催化剂表面氧的种类、数目和供出活性,较好地关联了催化氧化的一些事实,使以上规律更趋于半定量化。在多相氧化反应中,催化剂表面活性氧不断处于供出和恢复的循环之中,催化剂表面氧中心的供     

Thermal degradation of polystyrene in the presence of hydrogen by catalyst in solution

For the first time, low temperature degradation (170-240 °C) of polystyrene in benzene is carried out in the presence of hydrogen using iron(III) oxide catalyst. The effect of temperature, catalyst loading and polymer loading on degradation are studied in hydrogen atmosphere. Degradation is also carried out at different initial hydrogen partial pressure. The time dependent molecular weight is calculated using viscosity average method. It is found that the degradation is enhanced considerably in the presence of hydrogen and followed random degradation chain scission. A random degradation kinetic model of Kelen [Kelen T. Polymer degradation. New York: Van Nostrand Reinhold Company; 1983.] is used to estimate the degradation rate constants. Empirical correlations are proposed to account for the effect of catalyst loading and initial hydrogen partial pressure on degradation. The true thermal degradation rate constants are calculated using these proposed correlations at given catalyst loading and initial hydrogen partial pressure with varying temperature. The frequency factor and activation energy are also determined using Arrhenius equation considering the true thermal degradation rate constants.     

铱(III)离子催化铈(IV)离子氧化四氢糠醇的动力学及机理

在酸性介质中用氧化还原滴定法研究了铈(IV)离子在痕量铱(III)离子催化作用下，于298~313 K区间氧化四氢糠醇(THFA)的反应动力学. 结果表明，反应对铈(IV)离子为一级，对铱(III)离子也为一级，对四氢糠醇的表观反应级数为正分数. 准一级速率常数kobs随[H+]增加而增大，而随[HSO₄－]增加而减小. 在氮气保护下，反应能引发丙烯腈聚合，说明在反应中有自由基产生. 通过kobs与[HSO₄－]的依赖关系，找到本反应体系的动力学活性物种是Ce(SO₄)₂，并计算出平衡常数，速控步骤的速率常数及相应的活化参数.     

Palladium catalyzed ligand-free Suzuki cross-coupling reactions of benzylic halides with aryl boronic acids under mild conditions

A highly efficient Suzuki cross-coupling reaction between benzylic halides and aryl boronic acids using palladium chloride as catalyst in acetone:water (3:1) as the solvent system has been developed. High yields of products, mild reaction conditions and short reaction times in the absence of ligand are important features of this method.     

Ester interchange reactions catalyzed by tin compounds in reactive processing: NMR contribution via reactions with model compounds

Interchange reactions involving esters were used in reactive processing with a view to obtaining polymer blends with stabilized morphology. Dibutyltinoxide (DBTO) appeared to be an excellent catalyst for these reactions. In fact, it was shown that the true catalytic entity is a dimeric alkoxy, acyloxy distannoxane entity formed in situ, during processing, by the reaction of the DBTO with the polymer ester groups. This compound was first obtained with model esters and characterized by multinuclear NMR analysis (¹H, ¹³C, ¹¹⁹Sn). The catalytic efficiency of the in situ polymeric distannoxane was compared with other added parent distannoxanes. Later on – still with model compounds – ligand exchanges at the tin sites were investigated and it was shown that these exchanges are not essential to the catalyst activity, but when they take place it increases the catalytic efficiency. Then, this type of catalysis was successfully used for interchange reactions in reactive extrusion of different polymer blends, some applications are briefly presented. To cite this article: M.-F. Llauro and A. Michel, C. R. Chimie 9 (2006).     

Preparation and Properties of Composite Polypyrrole/Pt Catalyst Systems

Three different methods for the preparation and modification of conducting polymer/noble metal catalyst systems consisting of polypyrrole (PPy) and platinum (Pt) are described for the anodic oxidation of methanol. The first method consists of the electrochemical deposition of a thin PPy film on glassy carbon substrate, which is modified with Pt either by electroreduction of hexachloroplatinate, codeposition from a nanodispersed Pt solution, or incorporation of tetrachloroplatinate as counterion followed by cathodic reduction. A second method is based on the preparation of nanoscale PPy(PSS) particles by chemical polymerization with polystyrenesulfonate PSS^– as the counterion. This material is a favorable catalyst support for nanodispersed Pt due to its mixed electronic and cationic conductivity. To study the electrochemical properties, the particulate system PPy(PSS)/Pt is fixed in a carbon fiber electrode. A third method was developed which brings the polypyrrole in close contact to a proton exchanger membrane (Nafion) using a special chemical deposition procedure. This method is useful for preparing a membrane electrode assembly (MEA) consisting of Nafion/PPy/Pt. The structural, morphological, and electrocatalytic properties for methanol oxidation were studied depending on the preparation method applied using surface analytical techniques (TEM, SEM, and EDX) and electrochemical measurements (cyclic voltammetry and transient techniques).     

Fe(II) and Co(II) pyridinebisimine complexes bearing different substituents on ortho- and para-position of imines: synthesis, characterization and behavior of ethylene polymerization

A series of 2,6-bis(imino)pyridyl iron(II) and cobalt(II) complexes [2,6-(ArNCMe)₂C₅H₃N]MCl₂ (Ar = 2,6-i-Pr₂C₆H₃, M = Fe: 3a, M = Co: 4a; Ar = 2,4,6-i-Pr₃C₆H₂, M = Fe: 3b, M = Co: 4b; Ar = 2,6-i-Pr₂-4-BrC₆H₂, M = Fe: 3c, M = Co: 4c; Ar = 2,4-i-Pr₂-6-BrC₆H₂, M = Fe: 3d, M = Co: 4d) has been synthesized, characterized, and investigated as precatalysts for the polymerization of ethylene in the presence of modified methylaluminoxane (MMAO). The substituents of pyridinebisimine ligands and their positions located significantly influence catalyst activity and polymer property. It is found that the catalytic activities of the iron complexes/MMAO systems are mainly dominated by electronical effect, while those of the cobalt complexes/MMAO systems are primarily controlled by hindering effect.     

Reaction of Trimethylbenzene over Alumina-Pillared Montmorillonite

The reaction of trimethylbenzene (TMB) over alumina-pillared montmorillonite (Al-PM) had been investigated in a fixed-bed flow reactor at 300 °C and atmospheric pressure. Al-PM calcined in the range 300-500 °C exhibited decreased layer distance, surface area and acid amount. The strong acid sites of Al-PM calcined at 500 °C were greatly diminished according to measurements of ammonia temperature-programmed desorption. Under our conditions the reaction proceeded mainly via isomerization and disproportionation with little dealkylation. The conversion of reactant decreased in the order 1,2,3-TMB ≥ 1,2,4-TMB > 1,3,5-TMB and the selectivity of isomerization in the order 1,2,3-TMB > 1,3,5-TMB > 1,2,4-TMB, corresponding to the order of diminishing thermal instability. Both the catalytic activity and the selectivity ratio of disproportionation to isomerization decreased with increased calcined temperature and time-on-stream. o-Xylene content in the total xylene produced from 1,2,4-TMB or 1,2,3-TMB greatly exceeded the composition at thermodynamic equilibrium. These results arc consistent with the decrease of both the strong acid sites and the pore size of Al-PM which exhibits the restricted transition state selectivity.     

内分子DIELS-ALDER反应合成DRIMANE类倍半萜化合物DRIMENIN, POLYGODIAL及CINNAMOLIDE的全合成

近年来有不少报道从事于生理活性Drimane类倍半萜的合成,较多采用了分子间Diels-Alder反应来建立Drimane的骨架。本文首次采用内分子Diels-Alder反应作为关键反应合成了Drimane类化合物。同时还在引入了手性诱导基团后,首次完成了从无手性的原料化合物β-紫罗兰酮至光学活性(-)-drimenin1的不对称合成。