Adsorption of arsenate on lanthanum-impregnated activated alumina: In situ ATR-FTIR and two-dimensional correlation analysis study

Lanthanum modified materials have been widely used for the removal of hazardous anions.In this study,in situ ATR-FTIR and two-dimensional correlation analysis were employed to investigate the adsorption mechanism of arsenate（As（V）） on lanthanum-impregnated activated alumina（LAA）.Our results showed that electrostatic interaction attracted As（V） anions to the LAA surface,and then As（V） could form monodentate configuration on the LAA surface at pH 5-9.The result of 2D-COS showed that two coexistent adsorbed As（V） species,H₂AsO₄^- and HAsO₄^2-,were adsorbed on the LAA surface without specific sequence at different pH conditions,indicating a negligible role of the incorporated protons of As（V） on the adsorption affinity to LAA surface.The results of this study reveal insights into LAA surface complexes on the molecular scale and provide theoretical support to new metal oxides design for efficient arsenic removal.     

ICP-AES法测定烟花爆竹药物中的砷、汞、铅

为了禁止含砷、汞、铅物质应用到烟花爆竹药物中,建立ICP-AES方法,在烟花爆竹药物经乙醇、丙酮及硝酸处理后,选用As 189.042 nm、Hg 194.227 nm、Pb 220.353 nm分析线同时测定这3种元素的含量,结果:相对标准偏差为1.97%~2.71%,回收率为98.5%~101%.方法操作简单快速,检出限低、干扰小,结果准确可靠.     

Multicommutation flow techniques in the hydride generation-atomic fluorescence determination of arsenic

This review outlines automated methodologies developed for measuring arsenic in environmental samples. We report the state of the art of the most significant methods exploiting multicommutation flow techniques coupled to hydride generation-atomic fluorescence determination. We review analytical methods used and present a comparative evaluation of them. We also discuss the on-line pre-concentration procedure as being of particular interest in the development of fully automated methods.     

磷酸超声提取大气颗粒物中砷的多种形态

以H<,3>PO<,4> 为提取剂,利用高效液相色谱与氢化物发生原子荧光光谱联用(HPLC-HG-AFS)实现了大气颗粒物中砷形态的温和提取测定,并通过标准样品的形态加标实验确定了最佳提取方法.在优化的色谱及光谱条件下,As(Ⅲ),As(Ⅴ),MMA(甲基胂酸)和DMA(二甲基胂酸)均可达基线分离,其方法检出限分别为1...     

天然磁铁矿吸附-电感耦合等离子体质谱测定砷

基于天然磁铁矿对砷的选择性吸附作用,建立了以天然磁铁矿为除砷吸附剂、电感耦合等离子体质谱法(ICP-MS)测定饮用水中砷的方法.考察了吸附剂用量、溶液酸度、吸附时间、竞争共存离子等因素对As(Ⅲ)和As(Ⅴ)吸附效率的影响.结果表明.在pH 5时,选取0.5 g天然磁铁矿,振荡48 h后,吸附反应基本达到平衡,此时可定...     

Simultaneous speciation of inorganic arsenic and antimony in water samples by hydride generation-double channel atomic fluorescence spectrometry with on-line solid-phase extraction using single-walled carbon nanotubes micro-column

A new method was developed for the simultaneous speciation of inorganic arsenic and antimony in water by on-line solid-phase extraction coupled with hydride generation-double channel atomic fluorescence spectrometry (HG-DC-AFS). The speciation scheme involved the on-line formation and retention of the ammonium pyrrolidine dithiocarbamate complexes of As(III) and Sb(III) on a single-walled carbon nanotubes packed micro-column, followed by on-line elution and simultaneous detection of As(III) and Sb(III) by HG-DC-AFS; the total As and total Sb were determined by the same protocol after As(V) and Sb(V) were reduced by thiourea, with As(V) and Sb(V) concentrations obtained by subtraction. Various experimental parameters affecting the on-line solid-phase extraction and determination of the analytes species have been investigated in detail. With 180 s preconcentration time, the enrichment factors were found to be 25.4 for As(III) and 24.6 for Sb(III), with the limits of detection (LODs) of 3.8 ng L^− 1 for As(III) and 2.1 ng L^− 1 for Sb(III). The precisions (RSD) for five replicate measurements of 0.5 μg L⁻¹ of As(III) and 0.2 μg L⁻¹ of Sb(III) were 4.2 and 4.8%, respectively. The developed method was validated by the analysis of standard reference materials (NIST SRM 1640a), and was applied to the speciation of inorganic As and Sb in natural water samples.     

Direct determination of arsenic in petroleum derivatives by graphite furnace atomic absorption spectrometry: A comparison between filter and platform atomizers

In the present work a direct method for the determination of arsenic in petroleum derivatives has been developed, comparing the performance of a commercial transversely heated platform atomizer (THPA) with that of a transversely heated filter atomizer (THFA). The THFA results in a reduction of background absorption and an improved sensitivity as has been reported earlier for this atomizer. The mixture of 0.1% (m/v) Pd + 0.03% (m/v) Mg + 0.05% (v/v) Triton X-100 was used as the chemical modifier for both atomizers. The samples (naphtha, gasoline and petroleum condensate) were stabilized in the form of a three-component solution (detergentless microemulsion) with the sample, propan-1-ol and 0.1% (v/v) HNO₃ in a ratio of 3.0:6.4:0.6. The characteristic mass of 13 pg found in the THFA was about a factor of two better than that of 28 pg obtained with the THPA; however, the limits of detection (LOD) and quantification (LOQ) were essentially the same for both atomizers (1.9 and 6.2 μg L⁻¹, respectively, for THPA, and 1.8 and 5.9 μg L⁻¹, respectively, for THFA) due to the increased noise observed with the THFA. A possible explanation for that is a partial blockage of the radiation from the hollow cathode lamp by the narrow inner diameter of this tube and the associated loss of radiation energy. Due to the lack of an appropriate certified reference material, recovery tests were carried out with inorganic and organic arsenic standards and the results were between 89% and 111%. The only advantage of the THFA found in this work was a reduction of the total analysis time by about 20% due to the ‘hot injection’ that could be realized with this furnace. The arsenic concentrations varied from < LOQ to 43.3 μg L⁻¹ in the samples analyzed in this work.     

Determination of As(III) by anodic stripping voltammetry using a lateral gold electrode: experimental conditions, electron transfer and monitoring of electrode surface

The aim of this work is to evaluate the efficiency of the determination of As(III) by anodic stripping voltammetry (ASV) using a lateral gold electrode and to study the modifications of the electrode surface during use. Potential waveforms (differential pulse and square wave), potential scan parameters, deposition time, deposition potential and surface cleaning procedure were examined for they effect on arsenic peak intensity and shape. The best responses were obtained with differential pulse potential wave form and diluted 0.25 M HCl as supporting electrolyte. The repeatability, linearity, accuracy and detection limit of the procedure and the interferences of cations and anions in solution were evaluated. The applicability of the procedure for As(III) determination in drinking waters was tested. Cyclic voltammetry (CV) was used to study the electrochemical behaviour of As(III) and for the daily monitoring of electrode surface. Also scanning electron microscopy (SEM) analysis was used to control the electron surface. Finally we evaluated the possibility to apply the equations valid for flow systems also to a stirred system, in order to calculate the number of electrons transferred per molecule during the stripping step.     

Determination of seven arsenic species in seafood by ion exchange chromatography coupled to inductively coupled plasma-mass spectrometry following microwave assisted extraction: method validation and occurrence data

The determination of seven arsenic species in seafood was performed using ion exchange chromatography on an IonPac AS7 column with inductively coupled plasma mass spectrometry detection after microwave assisted extraction. The effect of five parameters on arsenic extraction recoveries was evaluated in certified reference materials. The recoveries of total arsenic and of arsenic species with the two best extraction media (100% H₂O and 80% aqueous MeOH) were generally similar in the five seafood certified reference materials considered. However, because MeOH co-elutes with arsenite, which would result in a positively biased arsenite concentration, the 100% H₂O extraction conditions were selected for validation of the method. Figures of merit (linearity, LOQs (0.019-0.075 mg As kg⁻¹), specificity, trueness (with recoveries between 82% (As(III)) and 104% (As(V) based on spikes or certified concentrations), repeatability (3-14%), and intermediate precision reproducibility (9-16%) of the proposed method were satisfactory for the determination of arsenite, monomethylarsonic acid, dimethylarsinic acid, arsenate, arsenobetaine and arsenocholine in fish and shellfish. The performance criteria for trimethylarsine oxide, however, were less satisfactory. The method was then applied to 65 different seafood samples. Arsenobetaine was the main species in all samples. The percentage of inorganic arsenic varied between 0.4-15.8% in shellfish and 0.5-1.9% at the utmost in fish. The main advantage of this method that uses only H₂O as an extractant and nitric acid as gradient eluent is its great compatibility with the long-term stability of both IEC separation and ICP-MS detection.     

HPLC-ICP/MS联用同时分析中药材中的多种形态砷

利用高效液相色谱-电感耦合等离子体质谱(HPLC-ICP/MS)对中药材中的6种砷的形态(三价砷(As(Ⅲ))、五价砷(As(Ⅴ))、二甲基砷酸(DMA)、甲基砷酸(MMA)、砷甜菜碱(AsB)和砷胆碱(AsC))进行了同时分析.采用1.2mol/,L HCl浸提,Hamilton PRP-X100阴离子交换色谱柱分离...