阳离子型聚合物对低温低浊水的絮凝效果与形态学特性

采用微絮凝-深床直接过滤工艺,以西安市曲江水厂低温低浊水质为原水(水温低于10 ℃,初始浊度低于10NTU),投加阳离子型聚合物(简称CP)作主混凝剂或助凝剂,借助分形数学理论与图像分析技术,对滤料粒径、原水浊度、原水温度、药剂种类、聚合物分子量及投加量、混合强度等因素对处理效果的影响进行了研究,分析探讨了不同药剂处理低温低浊水的作用机理、絮凝形态学特征以及絮体结构的分形特性.结果表明,①当温度低于4 ℃、初始浊度小于4NTU时,不宜单独采用Al2(SO4)3或PAC作为絮凝剂;当温度为4～10 ℃、初始浊度小于10NTU时,如果只投加Al2(SO4)3或PAC作为絮凝剂,宜用细砂滤料过滤;低温低浊条件下,无机混凝剂形成的絮体粒径小、结构松散脆弱、有效质量密度低、沉速慢,但表征絮体分形特性的分维值较高.②CP作絮凝剂能显著改善低温低浊水的絮凝效果与过滤性能,但混合强度需增大,宜用粗砂滤料过滤;③单独用CP作絮凝剂时,宜投加分子量较低的弱阳性聚合物或投加低剂量较高分子量的强阳性聚合物;CP用作助凝剂时,能显著减少主混凝剂用量,但宜投加强阳性聚合物或增加弱阳性聚合物的剂量.④CP兼备电性中和与吸附架桥絮凝作用,能形成粒径较大、吸附性能与过滤性能良好的网状絮体构型,其有效质量密度高,产生的污泥量少,污泥沉降速度快,脱水效果好,但分维值低.⑤各种水处理药剂的处理效果为:Al2(SO4)3(或PAC) CP＞CP＞PAC＞Al2(SO4)3,这种差别由絮体的形态学特性与构型特征各异引起.     

多热源分散程度的数学模拟及对置换通风影响

通过建立多污染热源置换通风的三维数学模型,根据数值解分析三热源位置变化对多污染源置换通风效果的影响,结果表明:热源的位置变化对多污染热源置换通风效果的影响是很大的,房间内热源应紧凑布置以利于提高通风效果和节能。     

聚氨酯泡沫材料阴燃发展过程的特性分析

分析对比了相同加热条件下的聚氨酯泡沫材料在有氧和无氧气氛下的升温过程,并对不同加热条件下的聚氨酯泡沫材料的阴燃传播速度进行研究.结果表明:沿着反应进行的方向,分离点的温度越来越低,不同热流条件下的温度分离曲线斜率在实验稳定发展段的变化规律表现得很相似,并在分离点出现后,有氧气氛中的该位置温度在短时间内急剧上升;在阴燃不稳定传播阶段时,热解前锋的速度小于氧化前锋的速度,在稳定传播阶段时,热解前锋速度与氧化前锋速度近乎相等.     

热真空试验系统温度均匀度试验研究

热真空试验是航天器研制过程中非常重要的一项试验,作为满足热真空试验必不可少的工具,好的热真空试验系统可以保证试验件在不失真的情况下试验,使试验受控,而热真空试验系统温度均匀度不好,会造成过试验或欠试验的产生。文中以某型热真空试验设备为例,通过试验研究分析其温度均匀度,可以提高热真空试验的精度。     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

Analysis of long-term changes in the dates of seasonal phenomena in plants and insects of the Il’men Reserve as related to climatic factors

The results of monitoring the dates of the onset of flowering and leaf budding in eight herbaceous and woody plant species and the first appearance of three insect species in the Il’men Reserve (1972–2005) were processed by means of regression and correlation analyses. No significant changes in test parameters were revealed in the majority of these species. Only two early spring plants, coltsfoot (Tussilago farfara L.) and goat willow (Salix caprea L.), showed a weak tendency toward earlier flowering in the 1980s and 1990s. This is explained primarily by the absence of any significant trends in spring and summer air temperatures in the study region over the observation period. On the other hand, interannual fluctuations in the dates of plant flowering and insect appearance were well manifested not only in early spring but also in late-spring species. These fluctuations proved to depend largely on spring temperatures: in years with early and warm springs, flowering and leaf budding in plants and the appearance of first individuals in insects were recorded on significantly earlier dates.     

吨量煤体的自燃过程实验模拟研究

为更好地弄清矿井实际的煤自然发火规律,利用装煤量达5吨的大型实验台对两种烟煤分别进行了自燃模拟实验。大煤量的实验能够很好地模拟煤矿中煤低温氧化和传热传质共同作用导致的发火过程,实验得到的自然发火期与煤矿实际发火期也是一致的。实验中煤样从缓慢氧化变为快速氧化的临界温度为100～110℃。当煤温低于,临界温度时,煤样的升温受到空气流带走热量和向外界散热的影响很大,因此夹层水的保温作用就很关键。当煤温超过临界温度后,反应加快,温度急剧上升,散热的影响明显降低,反应主要受限于氧气的供应情况。     

细水雾中雾滴和高温环境的热质交换研究

由雾滴的表面的组分方程和能量方程入手,探讨雾滴在静止的高温环境中的热质交换及生存时间。应用折算薄膜理论,通过特征时间的比较,提出雾滴与高温环境主要通过沸腾机制实现热质交换;考虑滴径与速度变化的耦合作用,应用数值方法研究雾滴在强迫对流环境中与高温环境的热质交换情况。结果表明:对于滴径较小的雾滴不可能达到火焰区或可燃物表面实施火焰冷却和表面冷却,其灭火作用主要依赖于汽化吸热。     

抽穗期低温对杂交晚粳宁67A／K1722结实率的影响

利用人工气候箱研究了抽穗期低温对杂交晚粳新组合宁67A/K1722开花量、包颈率及结实率的影响。结果表明：低温使抽穗速度明显变慢,开花量减少,包颈率呈现上升趋势,不同温度处理对结实率的影响不同,17℃与21℃处理间差异极显著,而19℃与21℃间差异不显著,不同时期处理及不同处理天数（3d,5d,7d和12d）间结实率差异不显著,表明该组合对抽穗期低温的耐受力较强,对抽穗期耐低温的鉴定指标问题进行了讨论。     

Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.