合成氨扩能改造中锅炉存在的问题及采取的措施

针对天脊集团年产30万t合成氨扩能改造,给2台225t/h高压锅炉带来的除氧器热量过剩、锅炉给水温度升高、主蒸汽温度降低等一系列问题,分析了产生问题的原因,从节约能源、提高锅炉效率考虑,提出了相应的解决问题的办法:利用热量分流、改造省煤器管、增加二级过热器受热面积。经过3年多的生产实践证明,取得了良好的效果。     

Addition of pectolytic enzymes: an enological practice which improves the chromaticity and stability of red wines

Summary The effect of the addition of four commercial pectolytic preparations on the visual characteristics (colour and turbidity) of red wines has been evaluated. The effect of both clarifying and colour extracting enzymes and the effect of different doses used, were evaluated and compared. All the red wines treated enzymatically, independent of the type of enzyme and dose, present chromatic characteristics which can be considered better than those of the control wines. Also, those wines treated with enzymes had greater stability during 2 years storage in bottles, in particular the turbidity was better than untreated wines.     

Quality of Crude Fish Oil Extracted from Herring Byproducts of Varying States of Freshness

ABSTRACT: Herring byproducts were stored at 2 and 15 °C for up to 72 h. Over time, significant increases of total volatile bases (TVB), histamine, putrescine, cadaverine, and tyramine were detected. However, only tyramine and TVB levels were temperature-dependent. The level of total polyunsaturated fatty acids (PUFAs) was constant. Longer byproducts storage gave rise to an oil with higher levels of free fatty acids, eicosapentaenoic acid (EPA), docosahexaenoic acid (DHA), and total PUFAs, while fluorescent compounds were lower. A higher storage temperature led to oil higher in α-tocopherol and EPA levels and lower in anisidine value. Surprisingly, the oil with the highest content of PUFAs was not produced from the freshest byproducts, and oil with low oxidation products can be extracted from stored byproducts.     

Thermal-lens and photo-acoustic methods for the determination of SiC thermal properties

In this paper we report the use of photothermal techniques such as Thermal lens (TL) spectrometry, Photoacoustic and heat capacity, ρc_p, to determine the thermo-optical parameters, such as thermal conductivity (K), thermal diffusivity (D), specific heat (c_p) and the optical path dependence with temperature (ds/dT), of an undoped polycrystalline 3C-SiC. To our knowledge, this is the first time that Thermal lens technique is used for wide band-gap systems. Results obtained for the polycrystalline sample with TL technique indicates that ds/dT is negative at room temperature. Moreover, the obtained values of thermal diffusivity and thermal conductivity are in good agreement with that found in the literature, indicating that the phototermal techniques can be used to obtain the referred parameters in circumstances where other techniques cannot be used, for example, in harsh environments.     

液化天然气供气站的工艺设计

〗LNG供气站的设计核心是工艺设计，设计中应注意以下几点：正确处理技术先进性与经济合理性的关系，综合权衡设置费与运营费的比例，力求项目全寿命费用最低；大多数城市LNG供气站均利用空气气化LNG，单罐容积为100 m³的真空压力式储罐广泛用于储存量为1200 m³以下的LNG供气站；为正确设置储罐安全阀的开启压力和排放压力，必须根据储罐的最高工作压力按照规范正确确定储罐的设计压力；储罐上2套独立的液位计和高、低限报警自动切断装置可确保储罐安全运行；空温式气化器的气化能力按用气城市高峰小时计算流量的1.3~1.5倍确定，为便于自然化霜应设置2套空温式气化器切换使用；空温式气化器出口串接水浴式加热器可提高冬季或雨天出口天然气温度，保护碳钢管道并降低供销差；LNG储罐区应设置围堰，消防用水量为喷淋与水枪用水量之和。最后建议，必须尽快颁布国家LNG设计规范，以提高我国的LNG设计水平。     

Investigation of the impact of changes in demand forecasting method on the financial performance of an electricity supply undertaking

Peak demand forecasts obtained from six different univariate forecasting methods, under a range of conditions, were used to drive a capacity acquisition model of a large electrical supply system; and the resulting physical and financial performance of the model was observed for each set of forecasts. The results obtained are discussed in the context of their implications for the choice of load forecasting method used in capacity acquisition planning by a power supply undertaking.     

电容传感器在使用中存在的几个问题及处理方法

随着电容测量技术的迅速发展，电容传感器在非电量测量和自动检测中得到广泛应用，但它在使用过程中也存在一些问题，针对在使用电容传感器过程中存在的几个问题，从电容传感器的原理和工作过程两个方面进行了讨论，并提出行之有效的处理方法。     

Separating n-alkane mixtures by exploiting differences in the adsorption capacity within cages of CHA, AFX and ERI zeolites

The saturation capacity of n-alkanes in CHA, AFX and ERI zeolites, that consist of cages separated by windows, decreases with increasing carbon number. The major aim of the present communication is to demonstrate the possibility of separating n-alkane mixtures relying on differences in saturation capacities. To investigate this possibility, Configurational-Bias Monte Carlo simulations for adsorption of C3–nC6, nC4–nC6, and nC5–nC6 mixtures in CHA, AFX and ERI were carried out for equimolar bulk fluid phase. These mixture simulations show that for operation at fluid phase fugacities below about 1 MPa, the adsorbed phase in equilibrium with the bulk vapor phase is predominantly the alkane with the longer chain length, i.e. nC6. However, for operation at pressures in excess of 1 MPa, the adsorbed phase in equilibrium with the bulk liquid phase is richer in the component with the smaller chain length. In some cases, the nC6 is practically excluded from the zeolite.     

Behaviors of concrete-filled steel tubular members subjected to combined loading

The present study is an investigation on the behaviors of concrete-filled thin-walled steel tubular members subjected to combined loading, such as compression and torsion, bending and torsion, compression, bending and torsion. ABAQUS software is used in this paper for the finite element analysis (FEA). A comparison of results calculated using this modeling shows generally good agreement with test results. The FEA modeling is then used to investigate the influence of important parameters that determine the ultimate strength of the composite members under combined loading, such as compression and torsion, bending and torsion, compression, bending and torsion. The parametric studies provide information for the development of formulae for calculating the ultimate strength of the composite members subjected to combined loading.