助剂对Pd/树脂醚化催化剂催化性能的影响 Ⅰ.铝助剂的影响

研究了不同助剂对Ｐｄ／树脂醚化催化剂在临氢条件下对催化裂化汽油Ｃ５馏份与甲醇和Ｈ２反应的催化性能的影响。结果表明，在Ｐｄ／树脂醚化催化剂中引入Ｚｒ、Ｔｉ、Ｂ、Ｓｎ和Ａｌ等助剂后，都能改善催化剂的醚化、双键异构和二烯烃选择性加氢活性，其中以Ａｌ、Ｓｎ为最好。Ａｌ助剂的体积质量和负载方式对Ｐｄ－Ａｌ／树脂醚化催化剂的活性有影响。ＢＥＴ方法和Ｘ－射线荧光光谱分析（ＸＦＳＡ）表明，Ａｌ助剂对Ｐｄ－Ａｌ／树脂醚化催化剂的表面积、孔结构和Ｐｄ离子交换量影响较小。     

驱动压电陶瓷的高压放大器

概述了高压放大器的基本组成，以及采用高压稳压电源措施，提高高压放大器的性能，并简述了高压放大器输出级的工作原理，给出了过渡保护方法。     

低温粉碎系统中旋风分离器设计

旋风分离器是一种应用离心力进行粉体分离的设备。低温粉碎系统应用它分离粉体并起集粉作用。它的效率决定了物质回收率。本文从离心加速度与重力加速度的比值，筒体的高低，筒体直径，进口速度叙述对分离器效率的影响。着重叙述筒体直径确定方法，以及我们设计造长筒形旋风分离器的具体结构和令人满意的试验结果。     

Transdermal Iontophoretic Delivery of Thyrotropin-Releasing Hormone Across Excised Rabbit Pinna Skin

Enhanced transport of a model peptide drug thyrotropin-releasing hormone (TRH), a tripeptide of molar mass 362 g and a pK_a 6.2, through excised rabbit pinna skin was achieved by means of iontophoresis with continuous current or monophase periodically pulsed current. The resulting flux in the steady state was proportional to the applied current density. In the transdermal iontophoretic delivery of TRH, the pulsed iontophoretic flux exceeded that obtained with a continuous current. At a low ionic strength, an increased degree of protonation in TRH increased the rate of permeation. The flux of TRH in a buffer at pH 4 is greater than that at pH 8 when the ionic strength is 0.1 M. At a greater ionic strength, the trend is reversed. The enhanced flux of unprotonated TRH during transdermal iontophoresis is attributed largely to electro-osmotic volume flow. An increased rate of permeation of TRH crossing the skin is achieved at low ionic strength, moderate pH, and a large duly cycle of current; the frequency of pulsed current had no significant influence on the rate of transdermal iontophoretic delivery of TRH.     

A dislocation shielding prediction of the toughness transition during cleavage of semibrittle crystals

An interconnected set of observations assesses current equilibrium models of the ductile-brittle-transition temperature (DBTT). This involvesin situ transmission electron microscopy (TEM) studies of crack-tip dislocations in single and polycrystals and bulk fracture toughness tests at various temperatures. Beyond K_I values of 8 MPa · m^1/2 in both iron-base single and polycrystals, large numbers of redundant dislocations are created, as postulated recently by Weertman. [38] Still, the necessary shielding dislocations, as required by equilibrium, can be detected at values as high as 20 and 40 MPa · m^1/2 byex situ TEM and electron channeling, respectively. In addition, the close approach of dislocations to the crack tip in some of the studies, as opposed to others, suggests that large dislocation free zones (DFZ) are a thin-film artifact. However, a failure criterion based partly on the Rice-Thomson model’21 is both consistent with the absence of a large DFZ and observed fracture toughness variations with test temperature. It is emphasized that this toughness transition is entirely in the semibrittle regime where cleavage is the failure mode. Nevertheless,K _lc values increase from 3 to 60 MPa·m^1/2 with an increase in test temperature. This article is based on a presentation made in the symposium “Quasi-Brittle Fracture” presented during the TMS fall meeting, Cincinnati, OH, October 21–24, 1991, under the auspices of the TMS Mechanical Metallurgy Committee and the ASM/MSD Flow and Fracture Committee.     

PAA-PSF交联复合膜的制备及对低浓度有机醇水溶液反渗透分离性能研究

进行了ＰＡＡ（ＰｏｌｙａｃｒｙｌｉｃＡｃｉｄ）－ＰＳＦ（Ｐｏｌｙｓｕｌｆｏｎｅ）交联复合膜的制备，研究了交联剂、添加剂对膜性能的影响，并通过扫描电镜观察了膜的断面结构．研究了ＰＡＡ－ＰＳＦ交联复合膜对低浓度有机醇类水溶液反渗透分离性能．发现对于１０００×１０－６乙醇水溶液截留率达到６６．２％，透过流束可达０．９×１０－６（ｍ３·ｍ－２·ｓ－１）．随醇的分子量的增加，截留率不断上升，对戊醇的截留率达９４．３％，而透过流束则保持相对稳定．对不同结构醇类的分离性能研究表明，截留率存在有：ｔｅｒｔ－＞ｓｅｃ－＞ｉｓｏ－＞ｎ－的规律．     

新取代苯基荧光酮试剂的合成及其性质的研究Ⅱ．新型取代苯基荧光酮与金属离子显色反应的研究

研究了３，５－二溴－４－氨基苯基荧光酮、３，５－二溴－４－偶氮变色酸等８种苯基荧光酮在酸性介质中与高价金属离子Ｚｒ（Ⅳ）、Ｍｏ（Ⅵ）、Ｗ（Ⅵ）、Ａｌ（Ⅲ）、Ｇａ（Ⅲ）等的显色反应。３，５－位二溴取代的试剂的灵敏度高于未取代的灵敏度，摩尔吸光系数绝大多数在１０５Ｌ·ｍｏｌ－１·ｃｍ－１以上。     

钛容器的特点

根据钛材的化学、物理、力学和工艺性能介绍了钛容器在设计、制造、检验和应用方面的特点。     

TNT-RDX混合废水处理的实验研究——生物-吸附法

介绍了在２５￣３５℃的温度下，用厌氧－兼氧－水生生物－吸附组合工艺处理ＴＮＴ和ＲＤＸ混合废水的方法，进行了日处理量为６０￣９００Ｌ的实验室放大实验。当ＴＮＴ和ＲＤＸ混合废水总浓度为４￣１２ｍｇ／Ｌ时，经过该工艺处理后可达到国家排放标准。其中厌氧－兼氧能去除废水中８０％以上的ＴＮＴ和ＲＤＸ，水生生物（水葫芦）对ＴＮＴ及ＲＤＸ也有一定的降解效果，最后用活性炭吸附可以实现深度处理。