带有块间串扰MC-CDMA的时域信道估计和多用户检测

本文把带有IBI的MC-CDMA系统等效解释为特殊的直接序列码分多址（DS-CDMA）系统，并给出了相应的时域信道估计方法和时域线性最小均方误差（MMSE）多用户检测方法。仿真实验表明了本文方法的性能。     

浅谈变频器供电条件下电动机的温升与对策

随着变频调速技术的蓬勃发展，变频器供电电机的温升问题已引起人们的广泛关注。本文首先讨论了电动机的温升限度；然后结合感应电机温升实验的相关数据分析了变频器供电对电动机温升的影响及其原因；最后从降低发热量和提高散热能力两方面提出缓解电机温升的措施，并指出了实际应用中应注意的问题。     

Synthesis and aqueous solution behaviors of sodium sulfonate‐terminated dendritic poly(ester‐amine)

Sodium sulfonate‐terminated dendritic poly(ester‐amine) (SPEA) was synthesized by sulfonation of acrylic double bond‐terminated dendritic poly(ester‐amine) (APEA) with sodium hydrogen sulfite (NaHSO₃) in mixture of diglycol and 2‐butanone under normal pressure. The structure of SPEA was characterized by IR, ¹H‐NMR, and elemental analysis. SPEA was water‐soluble. 1.0–40.0% (mass) SPEA aqueous solutions appeared as dilatant fluid. When pH value varied from 1.5 to 12.0, the viscosity of 1–5% (mass) SPEA aqueous solutions changed very small, and the electric conductivity almost kept stable within pH 3.0–10.0. The relationship between the viscosity and the concentration of SPEA water solutions was similar to that of NaCl water solutions. The surface tension of SPEA water solutions was lower than that of polyethylene glycol 2000 water solutions with the same concentration. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Green and self-lubricating polyoxymethylene composites filled with low-density polyethylene and rice husk flour

Polyoxymethylene (POM) composites filled with low-density polyethylene (LDPE) and rice husk flour (RHF) were prepared by injection molding. The POM/5 wt % LDPE/7.5 wt % RHF composite exhibited the lowest wear rate, whereas the coefficient of friction remained low, and the POM/5 wt % LDPE/5 wt % RHF composite had the best mechanical properties. X-ray diffraction analysis was carried out, and the worn surfaces were examined with scanning electron microscopy. The results showed that the addition of the filler reduced the crystallinity degree of the POM composites. The main wear mechanism for unfilled POM was adhesion, whereas for the POM composites, wear seemed to occur mainly by fatigue and abrasion. It was experimentally confirmed that the POM composite filled with LDPE and RHF, which is well-performing, low-cost, and environmentally friendly, could be a potential material for tribological applications. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

饮用水中挥发性三卤甲烷(THM)_s测定方法的改进

本文使用吹扫捕集法来前处理水样,用带有电子捕获检测(ECD)的气相色谱仪来测定水中三卤甲烷(THM)_s。水样加标回收率在85%～115%之间,相对标准偏差在5%左右。实验结果表明,该法具有简单、快速、灵敏的特点。     

胨冻样芽孢杆菌(Bacillus mucilaginosus)对烟草灰霉病菌(Botrytis cinerea)的抑制作用

本文首次报道胨冻样芽孢杆菌XDB1和D4B1对烟草灰霉病菌(Botrytis cinerea)的抑制作用。实验表明,XDB1和D4B1的发酵原液和无细胞提取物具有相同的抑菌效果,而经121℃处理30分钟后,抑菌活性丧失。D481菌株的抑菌活性高于XDB1,钾长石作为基质时的活性高于土壤矿物。但是,XDB1和D481对立枯丝核病菌(R..solani)、西瓜尖孢镰刀菌(F.oxysporum)、腐霉(Pythium sp)、小麦全蚀病菌(G.graminis)、烟炭疽病菌(C.gloeosporides)、烟草赤星病菌(A.alternata)、烟草黑胫病菌(P.nicotianae、串珠镰刀病菌(F.moniliforme)和水稻稻瘟病菌(P.grisea)无抑制作用。     

以硅氧烷醇锂为催化剂的氟硅生胶的合成

介绍了单体三氟丙基甲基环三硅氧烷通过硅氧烷醇锂催化剂聚合成氟硅生胶,讨论了不同催化剂及其用量,原料中水分含量、不同乙烯基含量对氟硅生胶分子量的影响.     

盐湖沉积储层孔隙结构特征及演化模式--以马王庙油田为例

盐湖沉积条件下的沉积环境及储集层特征等具有与淡水沉积不同的特征,通过对江汉盐湖盆地马王庙地区储层孔隙结构特征的研究,揭示了孔隙结构的宏观及微观特征.该区新沟咀组下段砂岩储层孔隙类型以粒间溶孔为主,喉道主要为片状、弯片状及点状喉道.Ⅱ、Ⅲ油组的物性比Ⅰ油组好,平面上孔隙分布具分区性.孔喉配置主要为大孔中喉,次为大孔粗喉及中孔中喉.孔隙结构受沉积环境及成岩作用的影响.以马36井Ⅱ油组砂岩为例,建立了孔隙演化定量模式.     

Optically tuned superconductive-dielectric resonators with whispering-gallery modes

An analytical method is presented for calculating the resonant frequency andQ-factor of a superconducting dielectric disk resonator operating in millimeter-wave regime with whispering-gallery mode. Resonant frequency shift due to the optical generation of quasi-particles in superconducting film is investigated as a function of photon flux. An optically tunable resonant frequency of about 500 MHz is estimated, and good agreement is found between numerical results and experimental ones.