A straight-bladed vertical axis wind turbine with a directed guide vane row — Effect of guide vane geometry on the performance —

The objective of this study is to show the effect of guide vane geometry on the performance. In order to overcome the disadvantages of vertical axis wind turbine, a straight-bladed vertical axis wind turbine (S-VAWT) with a directed guide vane row has been proposed and tested by the authors. According to previous studies, it was clarified that the performance of the turbine can be improved by means of the directed guide vane row. However, the guide vane geometry of S-VAWT has not been optimized so far. In order to clarify the effect of guide vane geometry, the effects of setting angle and gap between rotor blade and guide vane on power coefficient and starting characteristic were investigated in the experiments. The experimental study of the proposed wind turbine was carried out by a wind tunnel. The wind tunnel with a diameter of 1.8m is open jet type. The wind velocity is 8 m/s in the experiments. The rotor has three straight blades with a profile of NACA0018 and a chord length of 100 mm, a diameter of 0.6 m and a blade height of 0.7 m. The guide vane row consists of 3 arc plates.     

A generation method of artificial fluctuation data of wind power output considering smoothing effect

To use realistic wind power fluctuation data is important in simulating frequency change of power systems. It is well known that the smoothing effect must be taken into account when generating the artificial wind power output. Therefore, this paper proposed a new method to generate fluctuation waveform considering smoothing effect based on random number to fulfill the correlation among multiple sites and autoregression model. The effectiveness of the proposed method was tested by using practical wind speed data measured in Tohoku district.     

A design and simulation tool for ground source heat pump system using energy piles with large diameter

Calculation of the underground temperature resulting from heat injection/extraction into/from ground heat exchangers (GHEXs) with hourly variation is one of the most noteworthy challenges to address when simulating and designing a ground source heat pump (GSHP). In order to overcome this challenge, the authors introduce a method to calculate the underground temperature, by considering heat injection/extraction into/from GHEXs with hourly variation. The method applies the superposition of the infinite cylindrical source (ICS) solution and the infinite line source (ILS) solution to calculate the temperature change due to heat injection/extraction into/from the considered GHEX and other neighboring GHEXs, respectively. The calculation method also considers heat injection/extraction from GHEXs with different heat injection/extraction rates and is able to accommodate GHEXs with large diameters such as energy piles. The calculation method was evaluated by applying it to calculate the temperature variation of the heat carrier fluid in a GSHP system with energy piles.     

Multiresidue determination of quinolones in animal and fishery products by HPLC

A simple and rapid multiresidue method was developed for the determination of twelve quinolones (ciprofloxacin, danofloxacin, difloxacin, enrofloxacin, flumequine, marbofloxacin, nalidixic acid, norfloxacin, ofloxacin, orbifloxacin, oxolinic acid and sarafloxacin) in muscle, liver, chicken eggs, milk, prawn and rainbow trout.The quinolones were extracted from a sample with acetonitrile-water (95 : 5). A fifth part of the filtered extract was diluted with water to keep the acetonitrile ratio at ca. 60%, and passed through a C18 mini-column. The eluate was evaporated to dryness, and the residues were dissolved in methanol-water (30 : 70) for HPLC analysis.The quinolones were separated on a Inertsil ODS-3V column (4.6 mm i.d.x250 mm) with a gradient system of 0.1% phosphoric acid-acetonitrile as the mobile phase, with fluorescence detection.No interfering peak was found on the chromatograms of animal and fishery products, except for milk. The recoveries of the quinolones were over 60% from the animal and fishery products fortified at 0.1 microg/g, and the quantification limits of the quinolones were 0.005 microg/g. This proposed method was found to be effective and suitable for the screening of the quinolones in animal and fishery products.     

Photoinduced Formation of Small Gold Particles in Silica Gels

AuCl⁻₄ ions in sol-gel-derived silica gels (Au/silica gels) were photoreduced by ultraviolet light irradiation at room temperature. In the presence of ethylene glycol in the silica gels, small Au particles were effectively formed by the irradiation. When the storage temperature of the gels was increased in the dark after the irradiation, the surface plas-mon resonance absorption peak of the Au particles was shifted to longer wavelengths, indicating that the Au particles became large. At a storage temperature below 9°C, Au particles could not be observed in the silica gels. The apparent activation energy of Au particle formation was estimated to be 17. 3 kcal·tmol⁻¹.     

Analysis of upgraded solvent-refined coal (SRC) liquid products

Upgraded coal-derived liquids obtained from catalytic hydroprocessing of a 30–70(wt%) blend of SRC-1 with SRC-II have been studied by infrared and proton magnetic resonance spectroscopy, and gel permeation chromatography techniques. Compared with the feed blend, the upgraded liquids exhibit a lower C/H ratio and decreased aromatic, heteroatom and pentane-insoluble contents, along with decreased specific gravity and viscosity. The amount of hydrogen-bonded structure in the upgraded liquid decreases with increases in residence time and processing temperature. The pseudo-first-order disappearance of phenolic OH and total nitrogen during processing indicates a relative reactivity of 2:1 of hydroxyl oxygen removal to total nitrogen removal in the upgrading process. Conversion of pentaneinsolubles to soluble oil also follows a pseudo-first-order reaction; under mild processing conditions, the heteroatom functionalities play a dominant role in the ease and extent of this conversion. Higher temperatures increase thermal cracking and hydrocracking of the ring structure resulting in more conversion of asphaltene to oil. The linear dependence of the logarithm of viscosity on the content of heteroatoms and toluene-insolubles (TI) indicates the importance of molecular interactions involving polar functional groups in defining the viscosity of coal-derived liquid.     

Modification of bismaleimide resin by poly(propylene phthalate), poly(butylene phthalate) and related (co)polyesters

Aromatic polyesters were prepared and used to decrease the brittleness of the bismaleimide resin composed of 4,4′-bismaleimidediphenyl methane (BMI) and o,o′-diallyl bisphenol A (DBA) (Matrimid 5292 resin). The aromatic polyesters included poly(propylene phthalate) (PPP), poly(2,2-dimethylpropylene phthalate) (PDPP), poly(butylene phthalate) (PBP) and poly(butylene phthalate-co-butylene terephthalate) (50mol% terephthalate unit) (PBPT). The polyesters were effective modifiers for decreasing the brittleness of the bismaleimide resin. For example, inclusion of 20wt% PPP (MW 18700) led to 50% increase in the fracture toughness (K_IC) with retention of flexural properties and a slight loss of the glass transition temperature, compared with the mechanical and thermal properties of the unmodified cured bismaleimide resin. Micro-structures of the modified resins were examined by scanning electron microscopy and dynamic viscoelastic analysis. The thermal stability of the modified resins was slightly lower than that of the unmodified resin as determined by thermogravimetric analysis. The toughening mechanism is discussed in terms of the morphological and dynamic viscoelastic behaviour of the modified bismaleimide resin system. © 1998 SCI.     

The effect of chemical reaction on the mixing flow between aqueous solutions of acetic acid and ammonia

The basic characteristics of the reacting mixing flow of two streams were investigated. The reaction between aqueous solutions of ammonia and acetic acid, which produces ammonium acetate, was investigated in terms of the effect on the fluid–fluid interface of the mixing flow relative to fluids that did not react. The reaction between these solutions was negligibly exothermic, and there were minimal differences in density. The velocity field in the reacting mixing flow was quantitatively measured using high-speed time-resolved particle image velocimetry (PIV) and the behavior of the mixing flow was qualitatively investigated using laser-induced fluorescence (LIF). The jet width, the velocity field, the kinetic energy and the turbulent intensities are qualitatively estimated and discussed. It was found that the chemical reaction resulted in the suppression of the mixing flow.