Bi2MoO6 hierarchical microflowers for electrochemical oxygen evolution reaction

Solvothermal Bi₂MoO₆ hierarchical microflowers synthesis has been successfully attempted. Methanol, ethanol and isopropanol have been mediated to synthesize three kinds of Bi₂MoO₆ hierarchical microflowers. Highly oriented (311) plane growth of orthorhombic Bi₂MoO₆ hierarchical microflowers have been confirmed. Interstitial vacancies and its role on electrochemical activity have been extensively discussed. Electrode fabrication was constructively done by using Ni foam substrate. Half cell arrangement of each electrode in alkaline medium has been designed to measure the electrochemical activity towards water oxidation. High current density of 356 mA/cm² was afforded by Bi₂MoO₆ hierarchical microflowers mediated by ethanol solvent during synthesis. Low Tafel slope value of 43 mV/dec has been reported to obtain 10 mA/cm² current density. Higher conductivity long with very good electron transportation has been achieved and is also adapted for 12 h long time stability test and achieved 86% of retention in its performance. Hence, optimally prepared Bi₂MoO₆ hierarchical microflowers could be an efficient electrode for clean energy fabrication.     

Effect of 100 KeV Ar+ ion beam irradiation on ZnO thin films – Influence of morphology vis-a-vis electrode/electrolyte interface and its impact on photoelectrochemical water splitting

The present study attempts quantitative determination of changes in the morphological surface features viz. fractal dimension, lower and upper cut off length scale through Power Spectral Density analysis prior to and after irradiation of 100 KeV Ar⁺ ion beam at incidence angles of 0°, 40° and 60° on ZnO thin films. All the unirradiated and irradiated samples are subjected to photoelectrochemical characterization and a correlation between photoelectrochemical performance and morphological parameters is established. Sample irradiated at 40° angle at the fluence of 5 × 10¹⁶ ions/cm² is found to possess maximum fractal dimension of 2.72, lower and upper cut off length scale of 3.16 nm and 63.00 nm respectively. This sample exhibits maximum photocurrent density of 3.19 mA/cm² and applied bias photon-to-current efficiency of 1.12% at 1.23 V/RHE. Hydrogen gas collected for duration of 1 h for the same sample was ~4.83 mLcm^?2.     

Design and analysis of a sleep and wake-up CMOS low noise amplifier for 5G applications

Telecommunication Systems - This brief proposes a two-stage cascoded CMOS LNA with common drain envelope detection based power reduction method for the 5G applications of 28 GHz frequency....     

An efficient two phase approach for solving reliability–redundancy allocation problem using artificial bee colony technique

The main goal of the present paper is to present a two phase approach for solving the reliability–redundancy allocation problems (RRAP) with nonlinear resource constraints. In the first phase of the proposed approach, an algorithm based on artificial bee colony (ABC) is developed to solve the allocation problem while in the second phase an improvement of the solution as obtained by this algorithm is made. Four benchmark problems in the reliability–redundancy allocation and two reliability optimization problems have been taken to demonstrate the approach and it is shown by comparison that the solutions by the new proposed approach are better than the solutions available in the literature.     

Role of carrier material in encapsulation of yeast (Saccharomyces cerevisiae) by spray drying

ABSTRACT

Yeast was encapsulated using different carrier materials and their combinations to explore the possible synergistic effect of carrier material during encapsulation using spray drying. Freeze-drying was performed for comparison. The dried cell powders were analyzed for the quality aspects (morphology, flowability, and storage stability). The best results were observed, with a combination of whey protein and corn starch (cell survival: 82.37% and yield: 56%, w/w) with a shelf life of 6 months (with only 10% reduction in cell survival). The survival was found to be 40% without any carrier material, which decreased to less than 25% within 4 weeks.     

Structural and thermodynamic consequences of introducing {{alpha}}-aminoisobutyric acid in the S peptide of ribonuclease S

The S protein–S peptide interaction is a model systemto study binding thermodynamics in proteins. We substitutedalanine at position 4 in S peptide by     

Structural investigation and giant dielectric response of CaCu<Subscript>3</Subscript>Ti<Subscript>4</Subscript>O<Subscript>12</Subscript> ceramic by Nd/Zr co-doping for energy storage applications

High performance dielectric materials are highly required for practical application for energy storage technologies. In this work, high-k pristine and modified calcium copper titanate having nominal formula Ca_0.95Nd_0.05Cu₃Ti_4?xZr_xO₁₂ (x?=?0.01, 0.03 & 0.10) were synthesized and characterized for structural and dielectric properties. Single phase formation of the synthesized compositions was confirmed by X-ray diffraction patterns and further analysed using Rietveld refinement technique. Phase purity of the synthesized ceramics was further confirmed by Energy-dispersive X-ray Spectroscopy (EDX) analysis. SEM images demonstrated that grain size of the modified CCTO ceramics was controlled by Zr⁴⁺ ions due to solute drag effect. Impedance spectroscopy was employed to understand the grain, grain boundaries and electrode contribution to the dielectric response. Nyquist plots were fitted with a 2R-CPE model which confirms the non-ideality of the system. Substitution of specific concentration of Nd and Zr improved the dielectric properties of high dielectric permittivity (ε′ ~?16,902) and minimal tanδ (≤?0.10) over a wide frequency range. The giant ε′ of the investigated system was attributed to internal barrier layer capacitance (IBLC) effect and reduced tanδ accredited to enhanced grain boundaries resistance due to substitution of Zr⁴⁺ ions at Ti⁴⁺ site.     

Heat transfer in micropolar boundary layer flow near a stagnation point

Using the micropolar theory, a set of boundary layer equations are obtained for the two dimensional flow of an incompressible micropolar fluid near a stagnation point. The boundary conditions of isothermal and insulated wall are taken with VISCOUS DISSIPATION effects. Numerical results for the temperature distribution has been shown graphically for different values of the material parameters and Prandtl number.