宁夏宁东供水工程主机设备形式参数选择与国际招标

宁东供水工程供水水泵共有卧式和立式离心泵2种方案可供选择,也是工程论证时争论的焦点,经综合比较及主机设备的国际招标,最终确定了奥地利安德里兹公司的卧式双吸中开式离心泵为宁东供水工程的供水水泵。     

HEGF中CO井筒流动及扩散规律研究

目前,高能气体压裂广泛的应用于低渗透油气田,可以有效清除近井地带由于钻井、射孔和各种措施造成的污染和堵塞,达到油气井增产、注水井增注的目的。但最近一些低渗透油气田却出现了频繁的CO气体中毒事件,给油田及员工带来巨大的损失。针对这一现象,运用现场数据以及物理模拟和数学模拟方法首次通过对CO气体流动、扩散等的综合研究,建立了CO井筒流动及大气扩散模型。同时,也考察了井筒压力、气油比、风速、气体泄放速率、大气稳定度等主要因素对CO气体扩散的影响。通过现场实例计算,证实模型具有较高的准确性。此项工作的完成为建立监控系统提供基础技术依据,同时对合理、有效的开发油气田以及煤层气的开发将具有重要的实际意义。     

纳米AlN粉末的制备与烧结

利用低温燃烧合成前驱物制备出平均粒度为100 nm的AlN陶瓷粉末,比较了该粉末的常压烧结和放电等离子烧结的特性.实验表明:以合成的AlN粉末为原料,添加5%(质量比)Y2O3作为烧结助剂,在常压、流动N2气氛下1600℃保温3 h,制备出平均晶粒尺寸为4～8 μm、密度为3.28 g·cm-3的AlN陶瓷;将同样的粉末不加任何烧结助剂,采用SPS技术在1600℃保温4 min,得到密度为3.26 g·cm-3的AlN陶瓷,晶粒度约为1～2μm.     

高分辨率阵列感应测井仪在河南油田的应用

文章介绍了美国Baker-Atlas公司研制生产的高分辨率阵列感应成像测井仪（HDIL）,简述了该仪器的工作原理和技术性能指标及主要应用范围,并介绍了高分辨率阵列感应测井（HDIL）资料在河南南阳油田的具体应用实例.     

Disciplinary and linguistic considerations for academic Web linking: An exploratory hyperlink mediated study with Mainland China and Taiwan

The Web has become an important means of academic information exchange and can be used to give new insights into patterns of informal scholarly communication. This study develops new methods to examine patterns of university Web linking, focusing on Mainland China and Taiwan, and including language considerations. Multiple exploratory investigations into Web links were conducted between universities in these two places. Firstly, inlinks were counted to each university Web site from its national peers using four alternative Web document models. The results were shown to correlate significantly with research productivity in Taiwan but not in the Mainland, although in the latter case less reliable institutional data could have been the cause. For Taiwan, this is the first evidence of a scholarly association with academic linking for a non-English speaking region. It was then ascertained that the same link counts associated more strongly with scientific than social scientific research productivity in Taiwan. This confirms the general assumption of greater Web use by the hard sciences. We then investigated Taiwan-Mainland university cross-links, and found that although English is extensively used on the Web, there was no evidence that it was the language of preference for informal scholarly communication between the two areas. This revised version was published online in August 2006 with corrections to the Cover Date.     

井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

集成电路生产中废气的污染及治理

介绍集成电路生产中产生各种废气的种类,废气中有害物质浓度及其危害性,并依据工程实践,评述了各类有害废气的各种处理方法。     

δ－Al_2O_3纤维／Al－12Si复合材料室温拉伸强度分析

对δ－Ａｌ２Ｏ３纤维／Ａｌ－１２Ｓｉ复合材料室温拉伸强度的分析表明，在实验条件下该复合材料存在δ－Ａｌ２Ｏ３纤维的最小体积分数Ｖｍｉｎ和临界体积分数Ｖｃｒｉｔ，并求出其基体强度σ＇ｍ和室温强度σｃ－δ－Ａｌ２Ｏ３纤维体积分数Ｖｆ直线方程及纤维的临界长度ｌｃ和复合材料的剪切应力τｉ．确定复合材料的ＲＯＭ预测曲线，应首先判断σ＇ｍ是否等于未增强合金的强度σｕｍ才能得出正确的结论     

On the corrosion fatigue crack initiation model and expression of metallic notched elements

In the present study, attempts are made to extend the application of the mechanical model for the fatigue crack initiation (FCI) and the FCI life formula of metallic notched elements in laboratory air to those in the corrosive environment. The test results and analysis of the corrosion FCI (CFCI) life of aluminum alloys and Ti---6A1---4V show that the expression of the CFCI life obtained by modifying the FCI life formula in laboratory air can give a good fit to the test results of the CFCI life. The salt water (3.5% NaCl) environment has no effects on the CFCI resistant coefficient compared with the FCI resistant coefficient in laboratory air. However, 3.5% NaCl environment greatly decreases the CFCI threshold of aluminum alloy, but has little effect on the CFCI threshold of Ti---6A1---4V. The loading frequency ranging from 1 Hz to 10 Hz has no appreciable effect on the CFCI life, and thus, the CFCI threshold of aluminum alloys investigated. Hence, the expression for the CFCI life of metallic notched elements proposed in this study is a better one, which reveals a correlation between the CFCI life and the governing parameters, such as, the geometry of the notched elements, the nominal stress range, the stress ratio, the tensile properties and the CFCI threshold. However, this new expression of the CFCI life needs to be verified by more test results.     

一种多晶硅高温压力传感器

制作压力传感器时，在二氧化硅层上淀积多晶硅膜，既可利用优良的机械特性，又可保证压敏电阻与衬底间具有良好的绝缘性，由此可大大提高器件的温度特性。介绍了一种多晶硅压力传感器的原理和设计。实验结果表明，这类传感器具有灵敏度好，精度高等特点，电路工作范围为０－２５０℃，且具有良好的温度稳定性。