Effect of polymer density on polyethylene hollow fiber membrane formation via thermally induced phase separation

Microporous high‐density polyethylene (HDPE) and low‐density polyethylene (LDPE) hollow fiber membranes were prepared from polyethylene–diisodecyl phthalate solution via thermally induced phase separation. Effect of the polyethylene density on the membrane structure and performance was investigated. The HDPE membrane showed about five times higher water permeability than the LDPE membrane because it had the larger pore and the higher porosity at the outer membrane surface. The formation of the larger pore was owing to both the initial larger structure formed by spinodal decomposition and the suppression of the diluent evaporation from the outer membrane surface due to the higher solution viscosity. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 93: 471–474, 2004     

Studies on phase separation rate in porous polyimide membrane formation by immersion precipitation

Phase separation rate during porous membrane formation by immersion precipitation was investigated by light scattering in a polyimide/N‐Methylpyrrolidone (NMP)/water system. In the light scattering measurement, plots of scattered intensity against scattered angle showed maxima in all cases, which indicated that phase separation occurred by a spinodal decomposition (SD). Characteristic properties of the early stage of SD, such as an apparent diffusion coefficient D_app and an interphase periodic distance Λ, were obtained. The growth process of Λ was also followed by light scattering. The growth rate had the same tendency as D_app when water content in the nonsolvent bath and the polymer concentration in the cast solution were changed. The pore size of the final membrane increased with decreasing water content, which was opposite to the tendency of Λ growth rate. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 292–296, 2003     

Metal recovery in a pilot-scale rotating cylindrical wiper-blade electrode system

The performance of an experimental pilot-scale electrochemical reactor using a rotating cylindrical electrode equipped with wiper blades is described. Data obtained from monopolar depositing and bipolar stripping—depositing of copper from dilute aqueous electrolytes are presented and certain economic aspects of metal recovery are discussed.     

High oxide ion conduction in sintered oxides of the system Bi2O3-Y2O3

The ionic conduction in sintered Bi₂O₂-Y₂O₃ was investigated by measuring the conductivity and the emf of an oxygen concentration cell using the specimen tablet as electrolyte. The face centred cubic phase in this system was found to show high oxide ion conduction accompanied by a little electronic conduction when exposed to air. This phase was stable with a composition of 25 ～ 43 mol % Y₂O₃ over a wide range of temperatures, and the oxide ion conductivity increased with decrease in Y₂O₃. The conductivities of (Bi₂O₃)_0.75 (Y₂O₃)_0.25 were 1.6×10^?1 Ω^?1 cm^?1 at 700°C and 1.2×10^?2 Ω^?1 cm^?1 at 500°C values which are many times higher than those of stabilized zirconia (ZrO₂)_0.90(Y₂O₃)_0.10 at corresponding temperatures. Specimens containing less than 25 mol % Y₂O₃ showed a phase transition at 700 ～ 580°C and the conductivities decreased remarkably below these temperatures. High oxide ion conduction in the fcc phase is attributed to the migration of oxide ion vacancies which were present in an appreciable amount.     

Performance of solvothermally prepared Ga2O3-Al2O3 catalysts for SCR of NO with methane

The solvothermal reaction of mixtures of aluminum isopropoxide (AIP) and gallium acetylacetonate (Ga(acac)₃) directly yielded the mixed oxides of γ-Ga₂O₃-Al₂O₃. In the solvothermal synthesis, the crystal structure of mixed oxides was controlled by the initial formation of γ-Ga₂O₃ nuclei. The mixed oxides prepared in diethylenetriamine have extremely high activities for selective catalytic reduction (SCR) of NO with methane as a reducing agent. With increasing crystallite size of the spinel structure, the catalytic activity increased. The ratio of the amount of methane consumed by combustion to total methane conversion was proportional to the density of acid sites on the surface of the mixed oxides. The mixed oxide catalysts prepared in diethylenetriamine had lower densities of acid sites and showed a higher methane-efficiency for CH₄-SCR than those prepared in other solvents. These catalysts maintained their high activity even when the reaction was carried out under the severe conditions (i.e., high space velocity and low NO concentration).     

Intrinsic Elastic, Dielectric, and Piezoelectric Losses in Lead Zirconate Titanate Ceramics Determined by an Immittance-Fitting Method

The material coefficients of "soft" and "hard" lead zirconate titanate (PZT) ceramics were determined as complex values by the nonlinear least-squares-fitting of immittance data measured for length-extensional bar resonators. The piezoelectric d -constant should be a complex value to obtain a best fitting between observed and calculated results. Because the elastic, dielectric, and piezoelectric losses determined in this process were not "intrinsic" losses, a calculation process to evaluate the "intrinsic" losses was proposed. It was confirmed that the intrinsic losses were smaller than the corresponding extrinsic losses. The intrinsic piezoelectric loss existed in both soft and hard PZTs; ∼50% of the loss of piezoelectric d -constant was derived from the elastic and dielectric losses. The most notable difference between the soft and hard PZTs was observed in their elastic losses.     

Silica-supported cobalt catalysts for the selective reduction of nitrogen monoxide with propene

Catalytic behavior of silica-supported transition metals for NO reduction with propene in the presence of oxygen was investigated. While both silica and cobalt oxides did not show any activity for the selective NO reduction, impregnated CoO/SiO₂ prepared from cobalt acetate showed good activity although the preparation conditions had significant effect on the activity. It was suggested that highly dispersed surface Co²⁺ ions on silica are responsible for the catalytic activity.     

A new concept for determining triglyceride composition of fats and oils by liquid chromatography

The matrix concept was used to characterize the chromatographic rules in the elution of molecular species of triglyceride. To prove the hypothesis experimentally, cacao butter, palm oil, linseed oil, olive oil, rapeseed oil and triglyceride of “Ogonori” (Gracilaria verrucosa) were examined. A matrix model was suggested to help determine the individual molecular species of naturally occurring triglycerides.     

Effect of EFA deficiency on lipid transport from liver

Studies are reported of the effect of an essential fatty acid (EFA) deficiency on synthesis of triglycerides (TG) and phospholipids (PL) and secretion of these compounds by livers of male Sprague-Dawley rats. Animals were fed a semipurified diet containing corn oil or hydrogenated coconut oil (HCO) as the sole source of fat or no fat from weaning to 20 weeks of age. Liver function of the animals in each group was compared by an isolated liver perfusion technique with perfusates containing erythrocytes and linoleate, and in vivo experiments via tail vein injection of palmitate-³H. Perfusion experiments showed that an EFA deficiency reduced the ability of the liver to secrete TG and PL. Accumulation of TG in the liver and its diminished secretion into the blood of EFA deficient animals were demonstrated by in vivo experiments with palmitate-³H. The rate of conversion of linoleate to arachidonate and synthesis of PL was greater in livers of EFA deficient rats than in the control, corn oil fed animals. The results suggest a relationship of EFA metabolism to lipid transport. One of five papers to be published from the Symposium “Lipid Transport” presented at the AOCS Meeting, New Orleans, April 1970.     

Enzymatic modification of canola/palm oil mixtures: Effects on the fluidity of the mixture

The bioreactor system to interesterify edible oils and fats at an ultra-micro aqueous phase of 100 ppm and less was investigated. The adsorption of lecithin, together with lipase onto a carrier, was effective for conducting the interesterifying reaction efficiently for oils and fats in micro aqueous phase. To improve the handling properties of palm oil at rather low temperature, palm oil was blended with canola or soybean oil, and then these blended oils were modified by enzymatic selective interesterification in a solvent-free, ultra-micro aqueous bioreactor system with an immobilized lipase that had 1,3-positional specificity. The effects of enzymatic interesterification were confirmed by triglyceride determination, by solid fat content profiles and by cloud point profiles, which were also compared to products of chemical interesterification. The improvement in the fluidity of blended oils with canola oil by the enzymatic reaction was bigger than with soybean oil, and chemical interesterification had no effects on the fluidity of blended oils.