Control of grain size and -orientation in multi-crystalline silicon ingots

Two different cooling rates have been imposed during the early solidification of two multi-crystalline silicon ingots with 250mm diameter and 100mm height in a pilot scale directional solidification furnace. This has been done by opening a variable heat leak system below the crucible in order to achieve a high initial cooling rate in one of the ingots. The grain-structure and -orientation of these two ingots have been investigated by light microscopy (LM) and electron backscattered diffraction (EBSD), and their electrical properties by quasi-steady state photo-conductance (QSSPC) and surface photovoltage (SPV) method. The ingot with the high initial cooling rate shows predominantly grains which are significantly larger than what is usually found in mc-Si. The minority carrier diffusion lengths measured on the large grains in the ingot with high cooling rate show higher values than those measured on the ingot with smaller grains. These results indicate that principles of grain size and -orientation control in mc-Si ingots can be applied to a pilot scale furnace, and the potential for up-scaling to industrial ingots with improved electrical properties and, thus, higher solar cell conversion efficiency.     

Thermodynamic and Kinetic Behavior of B and Na Through the Contact of B-Doped Silicon with Na2O-SiO2 Slags

Boron (B) is the most problematic impurity to be removed in the processes applied for the production of solar grade silicon. Boron removal from liquid silicon by sodium-silicate slags is experimentally studied and it is indicated that B can be rapidly removed within short reaction times. The B removal rate is higher at higher temperatures and higher Na₂O concentrations in the slag. Based on the experimental results and thermodynamic calculations, it is proposed that B removal from silicon phase takes place through its oxidation at the slag/Si interfacial area by Na₂O and that the oxidized B is further gasified from the slag through the formation of sodium metaborate (Na₂B₂O₄) at the slag/gas interfacial area. The overall rate of B removal is mainly controlled by these two chemical reactions. However, it is further proposed that the B removal rate from silicon depends on the mass transport of Na in the system. Sodium is transferred from slag to the molten silicon through the silicothermic reduction of Na₂O at the slag/Si interface and it simultaneously evaporates at the Si/gas interfacial area. This causes a Na concentration rise in silicon and its further decline after reaching a maximum. A major part of the Na loss from the slag is due to its carbothermic reduction and formation of Na gas.     

Physical workload on neck and upper limb using two CAD applications

The aim was to evaluate (1) the physical workload on neck and upper limb in computer-aided design (CAD) work; (2) the impact of two applications (PROFESSIONAL-CADAM and PRO/Engineering) and (3) two input devices (computer mouse and keyboard), as well as (4) sitting and standing work positions. Fifteen CAD operators were interviewed and examined physically. For nine subjects, the physical workload was measured: electromyography (EMG) of trapezius and forearm extensor muscles, inclinometry of the head, the upper back and upper arms, as well as wrist goniometry. The muscular load was low in CAD work, but the inter-individual variation was considerable. Neither the positions were extreme, nor the movements. The applications, per se, did not have a large impact on the workload, but because of the need for different input devices the effect was strong. Using a keyboard meant higher angular velocities than using a mouse. Hence, when choosing a new software, which requires mainly a mouse as input device, this has to be balanced against the risk of disorders.     

A syntax-preserving error resilience tool for JPEG 2000 based on error correcting arithmetic coding.

JPEG 2000 is the novel ISO standard for image and video coding. Besides its improved coding efficiency, it also provides a few error resilience tools in order to limit the effect of errors in the codestream, which can occur when the compressed image or video data are transmitted over an error-prone channel, as typically occurs in wireless communication scenarios. However, for very harsh channels, these tools often do not provide an adequate degree of error protection. In this paper, we propose a novel error-resilience tool for JPEG 2000, based on the concept of ternary arithmetic coders employing a forbidden symbol. Such coders introduce a controlled degree of redundancy during the encoding process, which can be exploited at the decoder side in order to detect and correct errors. We propose a maximum likelihood and a maximum a posteriori context-based decoder, specifically tailored to the JPEG 2000 arithmetic coder, which are able to carry out both hard and soft decoding of a corrupted code-stream. The proposed decoder extends the JPEG 2000 capabilities in error-prone scenarios, without violating the standard syntax. Extensive simulations on video sequences show that the proposed decoders largely outperform the standard in terms of PSNR and visual quality.     

Orthographic, phonological, and articulatory contributions to masked letter and word priming.

A series of experiments assessed masked priming for letters and words that are visually similar (SIM) and dissimilar (DIS) in upper- and lowercase formats. For letters, robust DIS priming was obtained in a naming task, but this priming did not extend to a variety of non-naming tasks. For words, robust DIS priming was obtained in both naming and non-naming tasks. SIM letter and word priming extended to all tasks, but the effects were generally small for letters. The restricted set of conditions for DIS letter priming suggests that this priming is mediated by phonological-articulatory processes, and the generality of DIS word priming argues that abstract orthographic codes mediate these effects. Consistent with this conclusion, priming between homophones (for both letters and words) was found in a naming task, but little word homophone priming was obtained in a lexical decision task. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Probabilistic methods for eigenvalue estimates

Some probabilistic techniques are discussed regarding their use in estimating the principal eigenvalue of an elliptic operator. Such estimates are useful when studying models for biochemical reactions governed by lateral diffusion.In this paper we summarize recent results on some mathematical techniques that were developed to study certain biological models.     

Influence of probe size on the measurement accuracy of non-uniform ELF magnetic fields

The accuracy of extremely low frequency (ELF) magnetic field measurements can be sensitively varied by the meter probe size when the spatial distribution of the magnetic flux density is highly non-uniform, e.g. if the measurement point is close to the field source. The deviation between measured and actual field varies from point to point depending on the probe dimension and on the source configuration, once the other measurement conditions are fixed. The analysis of this effect is developed through a two-dimensional numerical model that enables the evaluation of the actual field value and of the corresponding probe indication. The error distribution, i.e. the deviation between actual and measured value, is computed for magnetic fields generated by industrial three-phase systems under both balanced and unbalanced supply conditions. The analysis shows how, for a given source, the error depends not simply on the distance from the source in relation to the probe size, but on its spatial distribution, which is complex and cannot be a priori predicted without using a computational tool such as the one proposed.     

Induced maturation of frog mast cells by nerve growth factor during ontogenesis

The effect of nerve growth factor (NGF) on ontogenesis of frog mast cells was investigated in vivo by histochemical, morphometric, and ultrastructural analysis. Three groups of tadpoles at various stages of development were used. In the first group, the larvae received i.p. injections of 1 ng NGF/g; the second group received 10 ng NGF/g, while the control group received only the vehicle. The first recognizable mast cells arose symmetrically in the tongue at stage 26 of Witschi's standard table. At stages 26 and 29, the mast cell number in the NGF-injected tadpoles was significantly higher than the control group. From stage 29 onward, the mast cell number rapidly increased in all groups. No significant differences in mast cell number were observed between the control group and the NGF-injected groups at stages 31 and 33. Electron microscopy revealed that at metamorphic climax (stage 33), the mast cells in the NGF-treated groups were more mature than those in the control group. Therefore, nerve growth factor at early stages of tadpole development is likely to induce differentiation of mast cell precursors, while at later stages it is likely to induce maturation of immature mast cells. The close anatomical association between mast cells and perineurium, observed during nerve development, is intriguing. Already in the early stages of nerve development, the mast cells form a network around Schwann cell-axon complexes, together with the perineurial cells. At climax, the mast cells are located between the perineurial layers, suggesting that they may play a role in the tissue-nerve barrier of the perineurium. Nerve growth factor also seems to induce perineurial cell maturation.