西北低煤阶盆地生物成因煤层气成藏模拟研究

在美国粉河、澳大利亚苏拉特等低煤阶盆地煤层气勘探取得突破以前,一直认为具有商业价值的煤层气资源主要存在于中煤阶的煤层中,煤阶太低,一般含气量不高,不具有勘探价值。但是近几年来的发现证实,低煤阶盆地煤层厚度大,渗透率高,资源丰度大,含气饱和度高,同样可获得商业性气流,而且从其气体的成因来看,其中有很大一部分是生物成因的煤层气。利用煤层气成藏模拟装置对低煤阶含煤盆地的煤岩样品开展成藏模拟,从实验角度证明了中国西北地区虽然煤层煤阶较低,热成因气较少,但是却存在着具有商业价值的二次生物成因的甲烷气,再加上含煤层系众多,煤层厚度大,资源丰度极高,仍具有巨大的勘探潜力。      

Formation of Arrayed Droplets by Soft Lithography and Two-Phase Fluid Flow, and Application in Protein Crystallization

This paper presents an overview of our recent work on the use of soft lithography and two-phase fluid flow to form arrays of droplets. The crucial issues in the formation of stable arrays of droplets and alternating droplets of two sets of aqueous solutions include the geometry of the microchannels, the capillary number, and the water fraction of the system. Glass capillaries could be coupled to the PDMS microchannels and droplets could be transferred into glass capillaries for long-term storage. The arrays of droplets have been applied to screen the conditions for protein crystallization with microbatch and vapor diffusion techniques.     

IP网络信源信道联合编码策略

面向IP网络,讨论了一种信源编码的失真估计模型,并用典型的视频编码器作了验证.提出了一种基于包的信道编码方法,并将该方法引入信道编码的失真估计中,对一种信道编码的失真估计模型作了改进.以前述内容为基础,提出了两种信源信道联合编码策略,实验结果表明,这两种策略得到的最优结果在很大程度上提高了视频重建质量.     

高性能大尺寸永磁体粘合强度的测定

介绍了一种用三点弯曲试验法测定高性能大尺寸粘接永磁体粘合强度的方法，及利用布氏硬度计的加载系统，实现100％检验粘接质量的方法。     

Flash器件中氧化硅/氮化硅/氧化硅的特性

对普遍采用的氧化硅/氮化硅/氧化硅( ONO)三层复合结构介质层的制备工艺及特性进行了研究分析,研究了ONO的漏电特性以及顶氧( top oxide)和底氧( bottom oxide)的厚度对ONO层漏电的影响.结果表明,采用较薄的底氧和较厚的顶氧,既能保证较高的临界电场强度,又能获得较薄的等效氧化层厚度,提高耦合率,降低编程电压.     

柔性联轴节在减小转子系统扭转冲击运动中的作用

通过对大型振动磨机运动特性的研究分析,把其旋转系统简化为由两个柔性联轴节连接的三转子系统。建立了柔性连接的三转子系统在冲击转矩作用下的运动方程,对方程求解得到了柔性连接转子系统的扭转冲击响应。通过对冲击响应随柔性联轴节扭转刚度和阻尼变化规律的讨论分析,发现减小柔性联轴节的扭转刚度和增大柔性联轴节的阻尼,可以减小转子系统的扭转冲击响应。     

混合动力电动汽车用电机及驱动控制器的电磁兼容设计

电机及驱动控制器作为电动汽车的关键部件,其电磁兼容设计对于保证电动汽车的可靠运行非常重要.介绍了国家十五项目中某混合动力轿车用电机及控制器系统的电磁兼容措施,分别从控制电路、信号电缆、功率电路及屏蔽机箱等工程角度进行了分析和设计.该系统的电磁兼容性符合GB/T17619-1998的要求,且已应用于实际混合动力电动汽车,运行情况良好.     

基于FPGA的CAVLC编解码器设计与实现

H．264标准在基本档次和扩展档次中采用CAVLC熵编码，完成对变换系数残差块的编码。提出一种基于FPGA的H．264标准的CAVLC编解码器，程序代码用verilog硬件描述语言编写，并在QuartusⅡ中进行了仿真验证，可以实现对每个残差块数据的编解码并将其按照宏块光栅扫描的顺序输出到存储器，因此适合于嵌入在最终的码流中。仿真结果表明此CAVLC编解码器达到H．264标准中基本档次和扩展档次level3．0的性能要求。     

Determination of molecular weight and molecular sizes of polymers by high temperature gel permeation chromatography with a static and dynamic laser light scattering detector

Flow-mode static and dynamic laser light scattering (SLS/DLS) studies of polymers, including polystyrene, polyethylene, polypropylene and poly(dimethylsiloxane) (PDMS), in 1,2,4-trichlorobenzene (TCB) at 150 °C were performed on a high temperature gel permeation chromatography (GPC) coupled with a SLS/DLS detector. Both absolute molecular weight (M) and molecular sizes (radius of gyration, R_g and hydrodynamic radius, R_h) of polymers eluting from the GPC columns were obtained simultaneously. The conformation of different polymers in TCB at 150 °C were discussed according to the scaling relationships between R_g, R_h and M and the ρ-ratio (ρ=R_g/R_h). Flow-mode DLS results of PDMS were verified by batch-mode DLS study of the same sample. The presented technique was proved to be a convenient and quick method to study the shape and conformation of polymers in solution at high temperature. However, the flow-mode DLS was only applicable for high molecular weight polymers with a higher refractive index increment such as PDMS.