Experimental investigation of solid particles flow in a conical spouted bed using radioactive particle tracking

Solid particles flow in a conical spouted bed is characterized by radioactive particle tracking. The influence of operating conditions on key parameters of this flow is evaluated and discussed: the morphology of the solid bed is not strongly influenced by the forces exerted by the gas on the solid particles, but rather by geometrical considerations; the particles spend approximately 8% of their time in the spout in all experiments; it is the force exerted on the solid particles by the gas that directly controls the volumetric flow rate between adjacent regions, and not the amount of particles in the bed; as U/U_ms increases, the volume of solid particles in the annulus decreases, the volume of solid particles in the fountain increases and the volume of solid particles in the spout remains constant. Correlations to predict key flow parameters as functions of operating conditions are also established and discussed. © 2015 American Institute of Chemical Engineers AIChE J, 62: 26–37, 2016     

“平面的科学性”:住宅建筑及其相关(1860-1930年)

通过研究英国现代住宅在19世纪下半叶以来的平面科学,本文展现出全景式的视角来认知当时的建筑师将住宅科学化的思想是如何成形的,并且认知相关的英国理论是如何与同时代的德国及法国理论发生关联的.从现代住宅的平面科学性出发,19世纪末至20世纪初年建筑理论中关于住宅特征与民族国家性的关系得到了在民族学、人类学、艺术史等学科视角之下的讨论.     

Individual cell lag time distributions of Cronobacter (Enterobacter sakazakii) and impact of pooling samples on its detection in powdered infant formula

Cells of six strains of Cronobacter were subjected to dry stress and stored for 2.5 months at ambient temperature. The individual cell lag time distributions of recovered cells were characterized at 25 °C and 37 °C in non-selective broth. The individual cell lag times were deduced from the times taken by cultures from individual cells to reach an optical density threshold. In parallel, growth curves for each strain at high contamination levels were determined in the same growth conditions. In general, the extreme value type II distribution with a shape parameter fixed to 5 (EVIIb) was the most effective at describing the 12 observed distributions of individual cell lag times. Recently, a model for characterizing individual cell lag time distribution from population growth parameters was developed for other food-borne pathogenic bacteria such as Listeria monocytogenes. We confirmed this model’s applicability to Cronobacter by comparing the mean and the standard deviation of individual cell lag times to populational lag times observed with high initial concentration experiments. We also validated the model in realistic conditions by studying growth in powdered infant formula decimally diluted in Buffered Peptone Water, which represents the first enrichment step of the standard detection method for Cronobacter. Individual lag times and the pooling of samples significantly affect detection performances.     

Sintering and conductivity of BaCe0.9Y0.1O2.95 synthesized by the sol-gel method

Ceramic powders of BaCe_0.9Y_0.1O_2.95 (BCY10) have been prepared by the sol-gel method. Barium and yttrium acetate and cerium nitrate were used as ceramic precursors in a water solution. The reaction process studied by DTA-TG and XRD showed that calcination of the precursor powder at T ≥ 1000 °C produces a single perovskite phase. The densification behaviour of green compacts studied by constant heating rate dilatometry revealed that the shrinkage rate was maximal at 1430 °C. Sintered densities higher than 95% of the theoretical one were thus obtained below 1500 °C. The bulk and additional blocking effects were characterized by impedance spectroscopy in wet atmosphere between 150 and 600 °C. A proton conduction behaviour was clearly identified. The blocking effect can be related to a space-charge depletion layer of protons in the vicinity of grain boundaries.     

Quantification of Se-Methylselenocysteine and Its γ-Glutamyl Derivative from Naturally Se-Enriched Green Bean (Phaseolus vulgaris vulgaris) After HPLC-ESI-TOF-MS and Orbitrap MS n -Based Identification

Orthogonal liquid chromatographic (ion exchange, reversed phase, and ion pairing) and mass spectrometric [electrospray ionization (ESI)-TOF-MS, ESI-Orbitrap MS, and inductively coupled plasma mass spectrometry (ICP-MS)] methods were addressed to identify and quantify selenium species from a naturally Se-enriched green bean (Phaseolus vulgaris vulgaris) sample after proteolytic digestion. While selenomethionine (10.1 mg/kg as Se) and selenate (9.5 mg/kg as Se) could be quantified in a straightforward way by anion exchange LC-ICP-MS technique, a multistep purification protocol was required to identify Se-methylselenocysteine and γ-glutamyl-Se-methylselenocysteine in an unambiguous way prior to quantification by using either in-source fragmentation (LC-ESI-TOF-MS) or collision-induced dissociation (LC-ESI-Orbitrap MS). Finally, Se-methylselenocysteine (2.6 mg/kg as Se) and γ-glutamyl-Se-methylselenocysteine (1.2 mg/kg as Se) could contribute to the overall selenium recovery of 72 %. This sample is the first of the Faboideae subfamily and Phaseolus ssp. to be speciated to such an extent for selenium including γ-glutamyl-Se-methylselenocysteine, a highly potential selenium species, which makes this bean material an ideal candidate for functional food purposes.     

用于加氢反应的催化剂及其制备

正本发明涉及到含有载体的催化剂,载体包括至少一种粘结剂和至少一种沸石以及至少一系列通道,由含12个氧原子限定的通道是开放的,所说催化剂包含磷,至少一种C1~C4二烷基丁二酸酯,醋酸和氢化-脱氢功能团,官能团含有至少一个族ⅥB元素和至少一个族Ⅷ元素。     

Assessment of elastic parameters of human skin using dynamic elastography

Sonoelastography and transient elastography are two ultrasound-based techniques that facilitate noninvasive characterization of the viscoelastic properties of soft tissues by investigating their response to shear mechanical excitation. Young's modulus is the principle assessment parameter. Because it defines local tissue stiffness, it is of major interest for the medical imaging and cosmetic industries as it could replace subjective palpation by yielding local, quantitative information. In this paper, we describe a new high-resolution device capable of measuring local Young's modulus in very thin layers (1-5 mm) and devoted to the in vivo evaluation of the elastic properties of human skin. It uses an ultrasonic probe (50 MHz) for tracking the displacements induced by a 300 Hz shear wave generated by a ring surrounding the transducer. The displacements are measured using a conventional cross-correlation technique between successive ultrasonic back-scattered echoes. First, this noninvasive technique has been experimentally proven to be accurate for investigating elasticity in different skin-mimicking phantoms. Second, data were acquired in vivo on human forearms. As expected, Young's modulus was found to be higher in the dermis than in the hypodermis and other soft tissues.     

Effect of porosity and hydrostatic pressure on water absorption in a semicrystalline fluoropolymer

This paper discusses the effect of porosity and hydrostatic pressure on diffusion kinetics and equilibrium water uptake in a semicrystalline fluoropolymer. Water sorption experiments at atmospheric pressure and under water pressures up to 250 MPa were carried out during 18 months at 40 °C on reference and porous samples. Porosity of samples was induced due to a cavitation process occurring at the highest triaxiality area of waisted and notched specimens during tensile tests. Water uptake was found to be very sensitive to porosity, showing an increase in samples with a high void fraction. On the other hand, water content decreased with increasing pressure suggesting a compaction of the porous space in which water can be stored. Two models describing this water uptake behaviour were considered. The first is a classical model which assumes that sorption occurs only by diffusion following Fick’s law. Fick’s model was found to be in agreement with the experimental results. A “Langmuir-type” sorption model was also proposed to describe water uptake in porous samples, considering a two-phase water transport mechanism: one portion of the absorbed water diffuses through the polymer matrix and the other portion is stored in voids. This model was implemented in a user subroutine using ABAQUS? software and simulations were confronted to experimental sorption curves showing satisfactory agreements. The potential of the Langmuir-type sorption model resides on its availability to be coupled to a poro-mechanical model, in order to improve the understanding of coupling between the mechanical behaviour and water sorption mechanism in a porous polymer.     

Modifications to bicarbonate conductivity: A way to increase phosphate removal during hemodialysis? Proof of concept

Introduction Hyperphosphatemia and cardiovascular mortality are associated particularly with end‐stage renal disease. Available therapeutic strategies (i.e., diet restriction, calcium [or not]‐based phosphate binders, calcimimetics) are associated with extrarenal blood purification. Compartmentalization of phosphate limits its depuration during hemodialysis. Several studies suggest that plasmatic pH is involved in the mobilization of phosphate from intracellular to extracellular compartments. Consequently, the efficiency of modified bicarbonate conductivity to purify blood phosphate was tested. Methods Ten hemodialysis patients with chronic hyperphosphatemia (>2.1 mmol/L) were included in the two three–sessions‐per week periods. Bicarbonate concentration was fixed at 40 mmol/L and 30 mmol/L in the first and second periods, respectively. Phosphate depuration was evaluated by phosphate mobilization clearance (K_M). Findings Although bicarbonatemia was lower during the second period (21.0 ± 2.7 vs. 24.4 ± 3.1 mmol/L, P < 0.01), no difference was observed in phosphatemia (2.4 ± 0.5 vs. 2.3 ± 0.4 mmol/L, P = NS). The in‐session variation of phosphate was lower (?1.45 ± 0.42 vs. ?1.58 ± 0.44 mmol/L, P < 0.05) and K_M was higher during the second period (82.94 ± 38.00 vs. 69.74 ± 24.48 mL/min, P < 0.05). Discussion The decrease of in‐session phosphate and the increase in K_M reflect phosphate refilling during hemodialysis. Thus, modulation of serum bicarbonate may play a role in controlling the phosphate pool. Even though correcting metabolic acidosis during hemodialysis remains important, alkaline excess can impair phosphate mobilization clearance. Clinical trials are needed to test the efficiency and relevance of a strategy where bicarbonatemia is corrected less at the beginning of sessions.     

Development of damage in a 2D woven C/SiC composite under mechanical loading: I. Mechanical characterization

An investigation has been undertaken to determine the damage mechanisms and the associated mechanical response of a 2D reinforced composite of carbon fibers in an SiC CVI-processed matrix subjected to uniaxial tensile and compressive loadings at room temperature. Under tension loading, an extended non-linear stress/strain response was evidenced and related to a multi-stage development of damage involving transverse matrix microcracking, bundle/matrix and inter-bundle debonding as well as thermal residual stress release. This tensile behavior proved to be damageable-elastic with respect to a fictitious thermalstress-free origin of the stress/strain axis lying in the compression domain. In compression, after an initial stage involving closure of the thermal microcracks present from processing, the composite displayed a linear-elastic behavior until failure. The extent of damage over the material was characterized quantitatively at the microscale by the decrease of the average transverse microcrack spacing and at the macroscale by the decrease of both the longitudinal Young's modulus and the in-plane Poisson's ratio.