壳聚糖固定化脲酶生物传感器选择性测定铜离子

基于重金属对脲酶的抑制作用,研制了用于测定铜离子的生物传感器。该生物传感器的制备以壳聚糖为载体,将脲酶固定于pH电极表面。由于壳聚糖对Cu2+的富集,该生物传感器展现出高灵敏度。在样品溶液中加入5 mmol/L NaI,可以消除Hg2+和Ag+的干扰,从而实现Cu2+的选择性检测。在0.005～0.5μg/mL的浓度范围内,脲酶活性的抑制率与Cu2+浓度的对数呈良好的线性响应关系,其检出限为0.002μg/mL。将使用后的生物传感器浸泡于0.5 mmol/L的EDTA溶液再生5 min,被Cu2+抑制的脲酶的活性可以得到恢复。     

无患子表面活性物及其复配体系的性质研究

对天然植物原料无患子提取物中的表面活性物的性质（临界胶束浓度、表面张力和起泡性能）及其影响因素（温度、pH、水硬度和盐度等）进行了系统的研究，结果表明无患子表面活性物具有很低的cmc和γcmc，且在一定范围内受一些因素的影响也不大，是一种理想的香波原料；同时也研究了无患子活性物与其他温和型的阴离子表面活性剂的复配体系，表明具有明显的协同增效效果。     

Photoelectric conversion of photosynthetic reaction center in multilayered films fabricated by layer-by-layer assembly

Multilayered protein films which contained ordered layers of photosynthetic reaction center (RC) from Rhodobacter Sphaeroides (RS601) were assembled by means of alternate electrostatic adsorption with positively charged poly(diallyldimethylammonium chloride) (PDDA). The assembly of RC was monitored by spectrometry and photocurrent measurement. Linear film growth was observed up to about 20 cycles of adsorption. For the monolayer film, the photocurrent was about 8.5 nA cm⁻². For the multilayered film, the total photocurrent was about 77 nA cm⁻² for the 24-layer RC film, while the average photocurrent increment per adsorption cycle was about 3.2 nA cm⁻². The overall light-to-electricity conversion efficiency for a 24-layer film was about eight times higher than that for the monolayer one. The effects of electrode potential and pH on the photocurrent were also measured to illustrate the light-to-electric converting mechanism.     

Coordination between strategic forest management and tactical logistic and production planning in the forestry supply chain

In this paper, we study the coordination mechanism in the forestry supply chain between strategic forest management and tactical production planning. We first formulate an integrated model to establish a theoretical benchmark for performance of the entire supply chain. It is a mixed integer programming model that involves harvesting, bucking, transportation, production, and sales decisions for both tactical and strategic planning levels. We then present two sequential approaches S‐A and S‐B where the coordination is done through internal pricing. S‐A is the approach currently used in practice where harvesting in the forest is the main driver of the supply chain activities and internal pricing is introduced to control bucking decision in a separate stage. In contrast, S‐B takes downstream demand information into consideration and internal pricing directly influences harvesting decision in the first stage. In order to find the appropriate setting of internal pricing that leads to the system optimum, we suggest two heuristics H‐I and H‐II. The internal pricing in H‐I is based on dual values and in H‐II, it is derived from a Lagrangian decomposition. A real‐life case study in the Chilean forestry industry is used to compare the results of different approaches. It is shown that the new sequential approach S‐B generates as good feasible solution as that obtained from the integrated approach but in much less time. Both heuristics H‐I and H‐II bring about near‐optimal feasible solutions. H‐II also provides optimistic bound of the optimal objective function value, which can be used as a measure of the solution quality.     

Modeling of photocatalytic oxidation of VOCs in a packed bed reactor under continuous and discontinuous illuminations

In this paper, a mathematical model is presented to describe the photocatalytic degradation of VOCs in a packed bed reactor. Here, the adsorption of VOCs on the wall of the reactor is taken into account and the diffusion of VOCs in the axial direction is neglected. First-order kinetics is used to describe the photocatalytic oxidation of VOCs. The analytical solution of the present model is obtained by traveling wave method. The solution shows that the reactor performance is totally dependent on the inlet concentration of VOCs when the time is large enough. The present model is validated through the experimental result of the photocatalytic oxidation of trichloroethylene in a packed bed and the predicted results accord well with the experimental data. The influence of flow rate and inlet concentration on the performance of the reactor is discussed in detail. High flow rate offers high reaction rate and low conversion efficiency. The different inlet conditions and different reaction patterns are also investigated. The model would be useful to estimate the rate constant and help to the design of the reactor.     

数据加密技术在计算机安全中的应用

随着计算机网络技术的不断发展,计算机互联网在人们的生活中应用越来越广泛,网络安全问题也随之而来。目前的计算机安全存在着诸多因素的威胁,研究人员也在致力于这方面的研究与发展,应用先进的技术来保证计算机安全,为计算机用户的信息安全提供更高的保障。本文将针对计算机安全问题进行分析,探讨数据加密技术在计算机安全中的应用。     

无线传感器网络的路灯远程控制系统设计

本设计基于TI公司的CC2480/ZigBee开发系统,设计了无线控制平台,论证了网络的组成、软件流程以及节能模式,旨在提供一种基于ZigBee无线技术的城市路灯照明系统解决方案,从而设计出低成本、高效能、全自动化的城市照明系统。     

沥青带水磺化工艺的研究

通过沥青磺化过程的主反应和副反应，进一步讨论了磺化工艺的原理，磺化试剂的选择，溶剂的组成，带水速度，溶剂的回收方式等各种因素对产品质量的影响。     

A novel and versatile method for the synthesis of soluble fullerenated polymers

Summary A new route for the preparation of soluble fullerenated polymer through the reaction of carbanion intermediates of polymers with fullerenes, particularly C₆₀, is demonstrated. Confirmation of the covalent attachment of C₆₀ to the polystyrene backbone is by a variety of techniques such as UV-Vis, FT-IR, TGA, SEM and ¹³C NMR etc. The product, which has a visibly brownish yellow cast when compared with the unreacted polymer, is soluble in some common organic solvents. The thermal stability of pure polystyrene is enhanced by C₆₀-chemical modification, and no bonds within the carbon sphere are broken.     

基于Creator的战场地形仿真研究

如何解决地形模型精细度、逼真度与仿真速度之间的矛盾是军事仿真的难点问题。本文研究了三维地形生成的关键技术,并详细阐述了利用MultiGen Creator建模工具,采用DEM数据和卫星遥感影像数据构建和优化大面积战场地形的原理和方法,最后结合实例生成战场地形。仿真结果表明,该方法生成的模型达到了精细度高、真实感强、实时性好等仿真要求。