火工品压药机装配误差的研究

针对军用雷管生产线中压药机结构,分别用极值法和概率法对压药机冲子和雷管的配合精度,进行了装配尺寸链的描述和计算,并对所得的结果进行了比较。     

NSA-500-1型氩弧焊机VD9不同接法对引弧和稳弧的影响

从一起NSA－500－1型氩弧焊机故障，分析其高压脉冲旁路二极管VD9不同接法对引弧、稳弧及设备安全的影响。     

可编程模拟器件与技术新进展

简述可编程模拟器件的基本原理、典型应用和开发方法,介绍并比较主要的模拟可编程实现技术与主流器件系列,指出现存的主要问题并展望其未来发展方向.     

T8钢－聚有机硅氧烷仿生减粘降阻复合涂层的特性

研究了Ｔ８钢－聚有机硅氧烷仿生减粘降阻复合涂层的表面润湿性、磨料磨损特性及对土壤的减粘降阻性能与金属材料相比，仿生复合涂层的表面憎水性显著提高，水在其表面上的接触角达９２°；与４５钢相比，其磨料磨损的体积相对耐磨系数为６３％，降阻率达１５．２２％～２２．２７％     

邻—(4—乙基苯甲酰基)苯甲酸的研究

本文阐述了通过Friedel-Crafts反应合成邻-(4-乙基苯甲酰基)苯甲酸的方法.研究了影响产物质量的因素,提出了适宜的工艺条件.     

Trends and variations in neonatal length of in-hospital stay in Canada

The objectives of this study were to evaluate the possible mechanisms involved in prolongation of bleeding time in pre-eclamptic patients receiving a magnesium sulfate infusion to prevent convulsions. Eighteen pre-eclamptic patients near term or at term (4 cases 33 to 35 weeks; the remainder > 36 weeks) were studied. Fifteen of them received magnesium sulfate infusion; 3 did not and served as controls. Bleeding time (modified Ivy method with Surgicutt), platelet count, platelet aggregation pattern, as well as serum arachidonic acid metabolites [thromboxane B2 (TxB2) and 6-Keto-prostaglandin F1 alpha (6-Keto-PGF1 alpha)] werde done on admission to the labor floor (before magnesium infusion) and repeated at discontinuation of the infusion, 12-24 hours postpartum; the controls received the second test 24 hours postpartum. Thirteen of 15 patients receiving magnesium sulfate had an increase in bleeding time from an average of 6 minutes 31 seconds to 11 minutes 56 seconds, an 82% rise (p < 0.004). In 2 there was a decrease. Among the 3 controls the averages were 6 minutes 38 seconds and 6 minutes 3 seconds. The total magnesium given ranged from 52.5 to 145 grams. Platelet counts averaged 251,000/mm3 (range 145,000-519,000). Platelet aggregation pattern done in 11 patients and was normal and unchanged after magnesium in 10 of the patients with increased bleeding time and one control. TxB2 and 6-Keto-PGF1 alpha levels did not change significantly either after magnesium administration (688 and 135 pgm/ml, to 654 and 117) or in controls (695 and 230 pgm/ml, to 445 and 225). Likewise, the ratio of these 2 substances did not change in either group (6.3 to 6.6, and 4.2 to 2.2). There was no correlation between duration of infusion or total magnesium given and directions of small changes observed. This study confirms a prior preliminary observation that magnesium sulfate infusion, as currently used to prevent eclamptic convulsions, induces a significant prolongation of bleeding time. This effect is mediated neither by changes in platelets count or aggregation pattern, nor by changing the level or ratios of serum arachidonic acid metabolites (TxB2 and 6-Keto-PGF1 alpha). Further studies are needed to clarify the mechanism of this clinically important observation of increased bleeding following magnesium sulfate infusion.     

A Special Structure in Al-Mg-Li Alloy (01420) Weld Metal

A large quantity of laminated fine grain zones were observed in the Al-Mg-Li alloy weld metal by manual TIG, which was not found in ordinary Al alloy welds. The fine grain zone is formed because of the Al3(Zr,Ti) particles in the filler metal and the manual filling of filler metal in welding process     

屏蔽暂堵技术在青西地区的应用

对玉门油田青西地区裂缝性储层的保护方法 ,最有效的技术手段就是利用屏蔽暂堵技术。根据该地区储层岩性不同 ,分别选用聚磺、金属离子、阳离子钻井液体系 ,在原浆的基础上加入EP - 2、LF - 1和硅油消泡剂 ,配制成屏蔽暂堵钻井液体系。通过室内试验 :屏蔽暂堵钻井液体系API失水小于 5ml,HTHP失水小于 13ml,岩心渗透率恢复值大于 70 % ,起到了良好的屏蔽暂堵效果。经完井试油发现 ,储层污染明显减小 ,产量与邻井相比有大幅度提高     

甲醇氧化羰化制碳酸二甲酯产物气相色谱分析

以Chromosorb 10 1为固定相 ,气相色谱法分析甲醇氧化羰化制碳酸二甲酯产物中水、甲醇、乙酸甲酯和碳酸二甲酯等组份的含量 ,考察了柱温 ,载气流量对分离度的影响 ,确定了适宜的分析条件 ,并用校正面积归一化法定量。该方法操作简便 ,快速 ,精度高 ,重现性好