Interaction of zinc finger ZNF191(243—368) and its I323 W and R327W mutants with oligonucleotides by florescence spectrum

Two mutants of the zinc finger protein, ZNF191 (243–368) I323W and R327W, are successfully obtained by site-directed mutagenesis. The fluorescence spectrum is used to study the interaction between these two mutants and the oligonucleotides. The influence of the mutation on the interaction has been studied using ethidium bromide (EB) as the fluorescence probe. The binding constants of the I323W-DNA and R327W-DNA have been calculated and the possible binding models have been discussed.     

Synthesis and VUV-UV spectroscopic properties of rare earth borosilicate oxyapatite: RE5Si2BO13:Ln (RE=La, Gd, Y; Ln=Eu, Tb)

Three rare earth borosilicate oxyapatites, RE₅Si₂BO₁₃ (RE=La, Gd, Y), were synthesized via wet chemical method, of which RE₅Si₂BO₁₃ (RE=Gd, Y) were first reported in this work. In the three oxyapatites, [BO₄] and [SiO₄] share the [TO₄] tetrahedral oxyanion site, and RE³⁺ ions occupy all metal sites. The differential scanning calorimetry-thermo gravimetry measurements and high temperature powder X-ray diffraction pattern revealed a vitrification process within 300-1200 °C, which was due to the glass-forming nature of borosilicates. From the VUV excitation spectra of Eu³⁺ and Tb³⁺ in RE₅Si₂BO₁₃, the optical band gaps were found to be 6.31, 6.54 and 6.72 eV for RE₅Si₂BO₁₃ (RE=La, Gd, Y), respectively. The emission and excitation bands of Eu³⁺ and Tb³⁺ are discussed relating with their coordination environments. Among the three hosts, Y₅Si₂BO₁₃ would be the best for Eu³⁺ and Tb³⁺-doped phosphors.     

Synthesis of lipid A derivatives and their interactions with polymyxin B and polymyxin B nonapeptide

Lipid A is the causative agent of Gram-negative sepsis, a leading cause of mortality among hospitalized patients. Compounds that bind lipid A can limit its detrimental effects. Polymyxin B, a cationic peptide antibiotic, is one of the simplest molecules capable of selectively binding lipid A and may serve as a model for further development of lipid A binding agents. However, association of polymyxin B with lipid A is not fully understood, primarily due to the low solubility of lipid A in water and inhomogeneity of lipid A preparations. To better understand lipid A-polymyxin B interaction, pure lipid A derivatives were prepared with incrementally varied lipid chain lengths. These compounds proved to be more soluble in water than lipid A, with higher aggregation concentrations. Isothermal titration calorimetric studies of these lipid A derivatives with polymyxin B and polymyxin B nonapeptide indicate that binding stoichiometries (peptide to lipid A derivative) are less than 1 and that affinities of these binding partners correlate with the aggregation states of the lipid A derivatives. These studies also suggest that cooperative ionic interactions dominate association of polymyxin B and polymyxin B nonapeptide with lipid A.     

Fabrication of poly(dimethylsiloxane) microfluidic system based on masters directly printed with an office laser printer

Applications of poly(dimethylsiloxane) (PDMS)-based microfluidic systems are more popular nowadays. Previous fabrication methods of the masters for PDMS microchannels require complicated steps and/or special device. In this paper, we demonstrated that the toner printed on the transparency film with the office laser printer (1200 dpi) can be used as the positive relief of the masters. The transparency film was printed in two steps in order to obtain the same printing quality for the crossed lines. With the laser-printed master, the depth of the fabricated PDMS microchannels was ca. 10 microm and the smallest width was ca. 60 microm. Surface characteristics of the PDMS/PDMS microchannels were performed with SEM. Their electrokinetic properties were investigated by the aids of the measurement of electroosmotic flow (EOF) and the Ohm's curve. Using the PDMS/PDMS microchip CE systems, electroactive biological molecules and non-electroactive inorganic ions were well separated, respectively. This simple approach could make it easy to carry out the studies of PDMS microfluidic systems in more general labs without special devices.     

Racemization of chiral amino alcohols III: Effect of Mg or Ca addition on the activity and stability of the Co/γ-Al2O3 catalyst

The racemization of R-(-)-2-amino-1-butanol in a reaction using Co/γ-Al₂O₃ catalysts and catalysts modified by Mg or Ca was investigated in this paper. Complete racemization was achieved with a yield of over 83% at using the Mg modified Co/γ-Al₂O₃ catalyst under optimized reaction conditions of 170°C and 2.5 MPa of H₂. The catalysts were thoroughly characterized by XRD, XPS, TPR, SEM and TEM. The addition of Mg and Ca may be advantageous for dispersing and stabilizing the active species of the Co/γ-Al₂O₃ catalyst, protecting from sintering, significantly improving its catalytic activity and stability.     

CuAl2O4 powder synthesis by sol-gel method and its photodegradation property under visible light irradiation

Nanocrystalline spinel CuAl₂O₄ powders were prepared by sol-gel method from nitrate Cu(NO₃)₂·3H₂O, Al(NO₃)₃·9H₂O and complex C₆H₈O₇·H₂O. Sintering was carried out at 400, 500, 600, 700, 800°C respectively for 2 h in air. The XRD patterns started to appear CuAl₂O₄ peaks after sintering of 500°C and consist of only CuAl₂O₄ peaks as spinel crystal after sintering of 700°C. The powders were analyzed by TEM and UV-vis diffuse reflectance spectrum to be round, about 10–30 nm in size and Eg=1.77 eV. Photodegradation property of nanocrystalline CuAl₂O₄ powders was investigated by using methyl orange as model pollutant and mercury lamp (λ>400 nm) as energy source. The results indicated that CuAl₂O₄ powders sintered at 700°C had the excellent visible photocatalytic property. Under the irradiation of visible light, methyl orange could be degraded 97% in 120 min.     

DNA电化学生物传感器测定水中痕量铅

采用物理涂附法将单链DNA固定到金表面得到ssDNA/Au修饰电极。研究表明,该电极在pH 5,0.2 mol/L NaAc-HAc缓冲底液中,可用于测定水中痕量Pb2 。Pb2 以Pb-DNA络合物的形式吸附在电极上,以示差脉冲伏安法测定Pb2 ,在0.15 V(vsSCE)处有灵敏的氧化峰,其峰电流与Pb2 浓度在5.0×10-8~1.0×10-6mol/L范围内呈良好的线性关系,此法的检测限为2.0×10-8mol/L,该修饰电极的稳定性和抗干扰性都较好。用该电极对饮用水中的Pb进行检测,得到了满意的结果。     

The outer valance orbital electron densities of cyclopentane by binary (e,2e) spectroscopy

The binding energy spectra and electron distributions in momentum space of the valence orbitals of cyclopentane (C(5)H(10)) are studied by Electron Momentum Spectroscopy (EMS) in a noncoplanar symmetric geometry. The impact energy was 1200 eV plus binding energy and energy resolution of the EMS spectrometer was 1.2 eV. The experimental momentum profiles of the outer valence orbitals are compared with the theoretical momentum distributions calculated using Hartree-Fock and density functional theory (DFT) methods. The shapes of the experimental momentum distributions are generally quite well described by both the Hartree-Fock and DFT calculations when the large and diffuse basis sets are used.     

A New Activation Method for Electroless Metal Plating：Palladium Laden via Bonding with Self—Assembly Monolayers

A new activation method has been developed for electroless copper plating on silicon wafer based on palladium chemisorption on SAMs of APTS without SnCl2 sensitization and roughening condition.A closely packed electroless copper film with strong adhesion is successfully formed by AFM observation.XPS study indicates that palladium chemisorption occurred via palladium chloride bonding to the pendant amino group of the SAMs.     

Colloidal adhesion of phospholipid vesicles: high-resolution reflection interference contrast microscopy and theory

High-resolution reflection interference contrast microscopy (HR-RICM) was developed for probing the deformation and adhesion of phospholipid vesicles induced by colloidal forces on solid surfaces. The new technique raised the upper limit of the measured membrane–substrate separation from 1 to 4.5 μm and improved the spatial resolution of the heterogeneous contact zones. It was applied to elucidate the effects of wall thickness, pH and osmotic stress on the non-specific adhesion of giant unilamellar vesicles (ULV) and multilamellar vesicles (MLV) on fused silica substrates. By simultaneous cross-polarization light microscopy and HR-RICM measurements, it was observed that ULV with the wall thickness of a single bilayer would be significantly deformed in its equilibrium state on the substrate as the dimension of its adhesive–cohesive zone was 29% higher than the theoretical value of a rigid sphere with the same diameter. Besides, electrostatic interaction was shown as a significant driving force for vesicle adhesions since the reduction in pH significantly increased the degree of deformation of adhering ULV and heterogeneity of the adhesion discs. The degree of MLV deformation on the solid surfaces was significantly less than that of ULV. When the wall thickness of vesicle increased, the dimension of contact zone was reduced dramatically due to the increase of membrane bending modulus. Most important, the adhesion strength of colloidal adhesion approached that of specific adhesion. Finally, the increase of osmotic stress led to the collapse of adhering vesicles on the non-deformable substrate and raised the area of adhesive contact zone. To interpret these results better, the equilibrium deformation of adhering vesicle was modeled as a truncated sphere and the adhesion energy was calculated with a new theory.