首页 | 官方网站   微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   120篇
  免费   40篇
  国内免费   32篇
数理化   192篇
  2024年   2篇
  2023年   5篇
  2022年   11篇
  2021年   8篇
  2020年   1篇
  2019年   6篇
  2018年   8篇
  2017年   5篇
  2016年   5篇
  2015年   5篇
  2014年   3篇
  2013年   3篇
  2012年   8篇
  2011年   11篇
  2010年   6篇
  2009年   5篇
  2008年   8篇
  2007年   11篇
  2006年   3篇
  2005年   5篇
  2004年   10篇
  2003年   6篇
  2002年   2篇
  2001年   2篇
  2000年   1篇
  1999年   3篇
  1998年   3篇
  1997年   4篇
  1996年   3篇
  1995年   10篇
  1994年   4篇
  1993年   3篇
  1991年   4篇
  1990年   1篇
  1989年   2篇
  1987年   1篇
  1986年   3篇
  1985年   2篇
  1984年   1篇
  1982年   1篇
  1980年   1篇
  1978年   1篇
  1966年   1篇
  1965年   1篇
  1962年   1篇
  1955年   1篇
  1954年   1篇
排序方式: 共有192条查询结果,搜索用时 15 毫秒
31.
The performance of optical interconnection has improved dramatically in recent years. Silicon-based optoelectronic heterogeneous integration is the key enabler to achieve high performance optical interconnection, which not only provides the optical gain which is absent from native Si substrates and enables complete photonic functionalities on chip, but also improves the system performance through advanced heterogeneous integrated packaging. This paper reviews recent progress of silicon-based opt...  相似文献   
32.
根据真空室冷屏所处位置和设计条件要求,选择304LN不锈钢作为冷屏的制作材料,在环向上把真空室冷屏分为16个扇区,每个扇区由12个子部分组成,在冷屏面板扇区的子部分上合理布置相应的冷却管回路,并选择高压液氦作为冷却剂。为减少热流密度、降低冷屏辐射发射率,在冷屏表面涂有5μm厚的银层。根据辐射热原理,利用CFX软件对真空室冷屏结构进行热分析,得到其面板的温度分布及冷却管道回路的进出口压力差,分析表明,在允许范围内验证了该冷却管道布局的合理性。  相似文献   
33.
选择304LN 不锈钢作为冷屏的制作材料,将杜瓦冷屏分为16 个扇区,每个扇区由20 个子部分组成,在每一个子部分上布置相应的冷却管。选择液氦作为冷却剂。为检验杜瓦冷屏结构是否符合设计要求,分析了杜瓦冷屏的传热方式以及冷却原理,利用FLUENT 软件对设计的冷屏结构进行了热分析,得到了杜瓦冷屏面板的温度分布情况以及冷却管道进出口压力差。结果表明,杜瓦冷屏面板温度和冷却管道进出口压力差在合理范围内,验证了冷却管道布局的合理性,为后续杜瓦冷屏的设计提供了重要参考。  相似文献   
34.
用简单方法求出了在均匀磁场中旋转的导体厚球壳上电荷的分布,证明了在磁场中转动的导体表面电荷分布无普遍公式。  相似文献   
35.
构造辅助函数计算行列式   总被引:1,自引:0,他引:1  
对于某类特殊行列式,根据其自身特点,构造相应辅助函数,借以计算其结果。  相似文献   
36.
对食品中铝含量国标测定方法的改进   总被引:2,自引:0,他引:2  
对国标GB/T 5009.182-2003中样品处理方法做了改进,用干法灰化代替湿法消解,解决了国标方法中由于pH值和高氯酸对显色反应的影响造成检测结果不准确的问题.采用干法灰化-分光光度法测定了食品中的铝含量,测定结果的相对标准偏差为1.6%(n=6),回收率为94.3%~100.7%.该方法适用于大批量食品中铝的快速检测.  相似文献   
37.
李炎勇  汪华锋  曹玉飞  王开友 《中国物理 B》2013,22(2):27504-027504
We investigated the effect of low temperature annealing on magnetic anisotropy in 7-nm ultrathin Ga0.94Mn0.06As devices by measuring the angle-dependent planar Hall resistance(PHR).Obvious hysteresis loops were observed during the magnetization reversal through the clockwise and counterclockwise rotations under low magnetic fields(below 1000 Gs,1 Gs = 10-4 T),which can be explained by competition between Zeeman energy and magnetic anisotropic energy.It is found that the uniaxial anisotropy is dominant in the whole measured ferromagnetic range for both the as-grown ultrathin Ga0.94Mn0.06As and the annealed one.The cubic anisotropy changes more than the uniaxial anisotropy in the measured temperature ranges after annealing.This gives a useful way to tune the magnetic anisotropy of ultrathin(Ga,Mn)As devices.  相似文献   
38.
In this Letter, we demonstrate a linear polarization conversion of transmitted terahertz wave with double-layer meta-grating surfaces, which integrated the frequency selectivity of a split ring resonator metasurface and the polarization selectivity of a metallic grating surface. Since the double-layer can reduce the loss, and the Fabry–Perot like resonant effect between the two layers can improve the conversion efficiency, this converter can rotate the incident y-polarized terahertz wave into an x-polarized transmitted wave with relatively low loss and high efficiency. Experimental results show that an average conversion efficiency exceeding 75% from 0.25 to 0.65 THz with the highest efficiency of 90% at 0.43 THz with only-2 dB loss has been achieved.  相似文献   
39.
利用Ansys/Ls-dyna有限元软件模拟打击气压为0.6、0.8、1.2MPa下大尺寸混凝土的SHPB束杆试验. 试验结果表明, 模拟得到的冲击试验过程中束杆传播的入射、反射及透射应力波信号与实测结果比较, 波形总体吻合较好, 入射波偏差很小, 反射波和透射波差异略大; 打击气压越大, 试样破损速度越快. 数值模拟给出了不同打击气压下大尺寸混凝土破坏形貌变化的规律.  相似文献   
40.
基于Euler-Bernoulli梁理论的经典纤维模型忽略了剪切变形给截面带来的影响,为了得到更加精确的梁单元模型,该文基于考虑剪切效应的纤维梁单元,根据Timoshenko梁理论,推导了该纤维梁单元的刚度矩阵,并结合弹塑性增量理论,同时考虑了几何非线性和材料非线性的双重影响,建立了压弯剪复杂应力状态下结构非线性有限元...  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号