Improvement of emission efficiency in polymer light-emitting devices based on phosphorescent polymers

We report improvement of emission efficiency in polymer light-emitting devices (PLEDs) employing phosphorescent polymers. A hole-blocking layer was inserted between the emissive layer and the cathode to enhance recombination efficiency for the injected holes and electrons. Aluminum(III)bis(2-methyl-8-quinolinato)4-phenylphenolato (BAlq) was used for the hole-blocking layer. The resultant PLEDs exhibited significant improvement of emission efficiency. The respective external quantum efficiencies for red, green and blue PLEDs were 6.6, 11 and 6.9%. These values are very high compared with those based on conventional fluorescent polymers.     

A new bubble-point-pressure correlation for the binary LiBr/H2O solution

In accord with the increasing concern about the global environmental issues, the absorption refrigeration heat-pump systems are currently being considered very promising and attractive. For the purpose of supporting the advanced R&D technology in this area, we have developed a novel correlation to represent the bubble-point pressures of LiBr H₂O solutions. The developed correlation covers the most extensive range of validity ever proposed: 273–483 K for temperatures, 0.05 kPa to 1.0 MPa for pressures. and 29 76 wt% LiBr for concentrations.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994. Boulder, Colorado, U.S.A.     

Reinjection experiment at the matsukawa vapor-dominated geothermal field: Increase in steam production and secondary heat recovery from the reservoir

A reinjection experiment has been conducted in an attempt to sustain reservoir pressure and steam production and to extract remaining heat energy in the superheated reservoir in the Matsukawa vapor-dominated geothermal field. This experiment was undertaken because the increase in superheat of produced steam and the decline of steam production are the current major issues for stable operation of the power plant. Almost all the reinjected fluid into well MR 1 was recovered from well M5, and the steam production of well M5 has increased by approximately 67%.     

Dynamic bandwidth control of the virtual path in an asynchronoustransfer mode network

The virtual path concept has several valuable features to construct an economical and efficient asynchronous transfer mode (ATM) network. One of them is bandwidth control which affords transmission efficiency improvement through statistical sharing of capacity. An effective bandwidth control algorithm and its calculated performance are described. Network performance with the algorithm is evaluated, and the bandwidth control is shown to successfully improve network transmission efficiency with only a slight increase in processing load compared to the fixed bandwidth scheme. A method is also proposed to equalize call loss probability for each virtual path. The effectiveness of the method is demonstrated by analysis     

Bubble-point pressures and liquid densities of binary R-125 + R-143a System

Bubble-point pressures and saturated-liquid densities of the binary R-135 (pentafuoroethane) + R- 143a ( 1, 1, 1-trifluoroethane) system have been measured for several compositions at temperatures from 280 to 330 K by means of a magnetic densimeter coupled with a variable-volume cell mounted with a metallic bellows. The experimental uncertainties of the temperature, pressure. and density measurements and the composition determination were estimated to be within ±15 mK, ±13 k Pa, ±0.2%, and ±0.1 wt%, respectively. The purities of the samples used throughout the measurements are 99.98 wt% for R-125 and 99.0 mol % for R- 143a. Based on the present data, the thermodynamic behavior of the vapor-liquid equilibria of this binary refrigerant mixture has been evaluated by using the Peng-Robinson equation for the bubble-point pressures, and the modified Hankinson-Brobst-Thomson equation for the saturated-liquid densities. This was done to identify the optimized binary interaction parameters.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

Coating of hydroxyapatite on metal plates using thermal dissociation of calcium-EDTA chelate in phosphate solutions under hydrothermal conditions

Coating of hydroxyapatite on various metal plates was carried out by a homogeneous precipitation technique using hydrothermal reactions in Ca(edta)^2-–NaH₂PO₄ at 140–200°C and pH 3.4–10.0. Hydroxyapatite films were formed on the surface of the iron plates in solutions at an initial pH above 4.7, whereas aggregates consisting of needle-like hydroxyapatite crystal radiating from a point in the form of flower deposited as islands on the surface of aluminum, copper and titanium plates. The upper part of the film formed on the surface of the iron plates consisted of needle-like hydroxyapatite particles whereas the bottom of the film consisted of spherical hydroxyapatite particles. The length of the needle-like hydroxyapatite particles increased with decreasing concentration of Ca(edta)^2-.     

Pressureless sintering and characterization of cordierite/ZrO2 composites

Cordierite/ZrO₂ composites with 5 to 25 wt% ZrO₂ were fabricated by conventional powder mixing and pressureless sintering method. Their densification behavior, microstructure, mechanical and thermal properties were studied. By dispersing 25 wt% (9.57 vol%) ZrO₂, densified cordierite/ZrO₂ composite with a relative density of 98.5% was obtained at an optimum sintering condition of 1440 °C and 2 h. ZrO₂ particles were homogenously dispersed within matrix grains and at the grain boundaries. The intragranular particles were finer than 100 nm and the intergranular particles were coarser. Both fracture strength and toughness could be enhanced more than two times higher, compare to those of monolithic cordierite, by dispersing 25 wt% ZrO₂ into the cordierite matrix. The toughening mechanism in the present composites was mainly attributed to martensitic transformation due to ZrO₂ dispersion. Electronic Publication     

A 1.5-V full-swing BiCMOS logic circuit

A BiCMOS logic circuit applicable to sub-2-V digital circuits has been developed. A transiently saturated full-swing BiCMOS (TS-FS-BiCMOS) logic circuit operates twice as fast as CMOS at 1.5-V supply. A newly developed transient-saturation technique, with which bipolar transistors saturate only during switching periods, is the key to sub-2-V operation because a high-speed full-swing operation is achieved to remove the voltage loss due to the base-emitter turn-on voltage. Both small load dependence and small fan-in dependence of gate delay time are attained with this technique. A two-input gate fabricated with 0.3-μm BiCMOS technology verifies the performance advantage of TS-FS-BiCMOS over other BiCMOS circuits and CMOS at sub 2-V supply     

Silica removal from Mokai, New Zealand, geothermal brine by treatment with lime and a cationic precipitant

Preliminary experiments using two chemicals (CaO, a quicklime, and a cationic nitrogen-bearing precipitant, EC-004) to remove silica from geothermal brine were undertaken at the Mokai geothermal plant, New Zealand. The brine was mixed with the reagent (CaO or EC-004). The reaction was studied from the start of the experiment (NRT, 0 min, no retaining time) and after 15 min (15RT) at 90 °C. The concentration of silica in the brine was initially 954 mg/l, and decreased linearly with increasing reagent concentration. When CaO is added, the silica concentration at 15RT was 200 mg/l lower than at NRT and became almost zero on addition of 1.5 g/l. In contrast, when EC-004 is added, the total silica concentration nearly reaches the solubility of amorphous silica at 90 °C. In order to prevent silica scaling in Mokai brines cooled to 90 °C, the CaO and EC-004 added should be individually adjusted to 0.5 g/l and 80 mg/l, respectively.     

Epstein-Barr virus-positive multiple early gastric cancers and dysplastic lesions: a case report

Epstein-Barr virus (EBV) has been implicated as a causal virus of gastric cancer with episomal monoclonality, elevated antibodies and a unique morphologic expression in the early intramucosal stage, but the infection mechanisms have not been demonstrated. EBV has been shown only in the cancerous lesions by the highly sensitive EBV-encoded small RNA in situ hybridization (EBER-ISH) method, not in the dysplastic mucosa adjacent to the cancer. A case is presented of multiple EBV-positive gastric cancer and dysplastic epithelium observed in a 52-year-old man. Serial cut sections of the gastrectomy specimen showed four small cancerous lesions, three of which were EBER-positive, and three EBER-positive, minute, non-cancerous dysplastic lesions. The three cancerous lesions were intramucosal cancer, with one having minimal submucosal invasion forming a lymphoepithelioma-like histology. All of these EBER-positive cancerous and dysplastic lesions showed intense CD8 T-lymphocytic infiltration. There was no such findings in the EBV-negative cancerous lesion. It was concluded that EBV infection may occur in the epithelial cells of atrophic gastric mucosa, and progress to cancer with monoclonal expansion through the EBV-positive dysplastic change. Cytotoxic T-lymphocytic reactions can occur even in the dysplastic lesions. Multifocal EBV infection in the gastric mucosa may occur and, if necessary, total gastrectomy is recommended in such a case.