Flash器件中氧化硅/氮化硅/氧化硅的特性

对普遍采用的氧化硅/氮化硅/氧化硅( ONO)三层复合结构介质层的制备工艺及特性进行了研究分析,研究了ONO的漏电特性以及顶氧( top oxide)和底氧( bottom oxide)的厚度对ONO层漏电的影响.结果表明,采用较薄的底氧和较厚的顶氧,既能保证较高的临界电场强度,又能获得较薄的等效氧化层厚度,提高耦合率,降低编程电压.     

Thermomechanical finite-element model of shell behavior in continuous casting of steel

A coupled finite-element model, CON2D, has been developed to simulate temperature, stress, and shape development during the continuous casting of steel, both in and below the mold. The model simulates a transverse section of the strand in generalized plane strain as it moves down at the casting speed. It includes the effects of heat conduction, solidification, nonuniform superheat dissipation due to turbulent fluid flow, mutual dependence of the heat transfer and shrinkage on the size of the interfacial gap, the taper of the mold wall, and the thermal distortion of the mold. The stress model features an elastic-viscoplastic creep constitutive equation that accounts for the different responses of the liquid, semisolid, delta-ferrite, and austenite phases. Functions depending on temperature and composition are employed for properties such as thermal linear expansion. A contact algorithm is used to prevent penetration of the shell into the mold wall due to the internal liquid pressure. An efficient two-step algorithm is used to integrate these highly nonlinear equations. The model is validated with an analytical solution for both temperature and stress in a solidifying slab. It is applied to simulate continuous casting of a 120 mm billet and compares favorably with plant measurements of mold wall temperature, total heat removal, and shell thickness, including thinning of the corner. The model is ready to investigate issues in continuous casting such as mold taper optimization, minimum shell thickness to avoid breakouts, and maximum casting speed to avoid hot-tear crack formation due to submold bulging.     

Glycoconjugated polymer 6. Synthesis of poly[styrene-<Emphasis Type="Italic">block</Emphasis>-(styrene-<Emphasis Type="Italic">graft</Emphasis>-amylose)] via potato phosphorylase-catalyzed polymerization

Summary The potato phosphorylase-catalyzed polymerization of α-D-glucose-1-phosphate (G-1-P) onto poly[styrene-block-(4-vinylbenzyl maltohexaoside)] (1) was performed at the molar ratios of [G-l-P]₀ and [maltohexaose]₀ of 35, 80, and 250. The product was found to be soluble in dimethyl sulfoxide, which was a good solvent for amylose, and showed the complex-formation with iodine, indicating that the product was assignable to poly[styrene-block-(styrene-graft-amylose)] (2). The quantitative analysis of the liberated phosphoric acid gave the average degree of polymerization o f the glucose unit (n) as 27, 5 1, and 180 for 2-I, 2-II, and 2-III, respectively. Received: 29 November 2002/Accepted: 22 December 2002 Correspondence to Toyoji Kakuchi     

多服务组的流媒体安全通信机制

提出了一种基于多服务组的流媒体安全通信机制.现有的方案一般是针对用户只参加一个多播组的通信,很少涉及到一个用户同时参加多个多播组的通信,而且没有提供有效的发送方身份验证机制.本文提出了一种具有发送方身份验证功能的一个用户同时可以参加多个组通信的方案,大大地降低了用户和服务器的存储开销,与传统的密钥树方案相比,用户的存储开销降低为原来的l/lgn(n为组中的用户数目),有良好的可扩展性.另外,本机制实现了可靠的发送方身份验证功能.     

MULTICARRIER DS—CDMA WITH ADAPTIVE MODULATION AND POWER ALLOCATION

Adaptive modulation and power allocation is introduced into the multicarrier DSCDMA system to improve the system performance and bandwidth efficiency.First,the system design appropriate for adaptive modulation and power allocation is given,then the algorithm of adaptive modulation and power allocation is applied.Simulation results demonstrate great performance improvement compared with the fixed modulated one.     

爆破震动作用下新浇基础混凝土的安全震动速度研究

针对新浇筑混凝土的爆破震动控制,设法利用爆破地震波(Rayleigh波)作用下的新浇筑基础混凝土受力状态的理论分析和动力有限元计算,确定的新浇筑混凝土中的震动速度及动拉应变分布,并结合不同龄期下新浇筑混凝土的允许极限拉应变,从理论上确定新浇筑基础混凝土的安全震动速度及主要影响因素.理论分析结果和计算实例表明,新浇筑基础混凝土的允许震动速度值随基岩对新浇筑混凝土的基础约束程度的提高和随混凝土强度的降低而降低,我国现行采用的新浇筑大体积混凝土基础面上的质点安全震动速度值具有较大的安全储备.     

Exchange-correlation errors at harmonic and anharmonic orders: the case of bulk Cu

As an aid towards improving the treatment of exchange and correlation effects in electronic structure calculations, it is desirable to have a clear picture of the errors introduced by currently popular approximate exchange-correlation functionals. We have performed ab initio density functional theory and density functional perturbation theory calculations to investigate the thermal properties of bulk Cu, using both the local density approximation (LDA) and the generalized gradient approximation (GGA). Thermal effects are treated within the quasiharmonic approximation. We find that the LDA and GGA errors for anharmonic quantities are an order of magnitude smaller than for harmonic quantities; we argue that this might be a general feature. We also obtain much closer agreement with experiment than earlier, more approximate calculations.     

Electronic properties of magnetically doped nanotubes

Effect of doping of carbon nanotubes by magnetic transition metal atoms has been considered in this paper. In the case of semiconducting tubes, it was found that the system has zero magnetization, whereas in metallic tubes the valence electrons of the tube screen the magnetization of the dopants: the coupling to the tube is usually antiferromagnetic (except for Cr).     

基于TMS320VC5410的最小系统设计

TMS320VC5410是TI公司生产的一款定点数字信号处理(DSP)芯片。基于DSP的最小系统是以其简洁的硬件结构来实现DSP的一般功能,广泛应用于工业生产、教学、科研、电子设计等领域。主要介绍了基于TMS320VC5410的最小系统硬件电路设计方案,阐述了重要电路部分的抗干扰设计和软件调试过程中应注意的若干问题。最后提出了简单易行的软件调试方法以及部分程序代码。     

Cable Modem的原理与反向噪声的控制

介绍Cable Modem的基本概念、传输方式、标准规范，并对影响Cable Modem工作稳定性的反向噪声问题进行技术分析，并提出预防控制措施。