WC对Cu/WC_P复合材料性能及组织的影响

通过ＷＣ含量对ＷＣ／Ｃｕ复合材料性能的影响，确定了冷压－烧结法制备Ｃｕ／ＷＣ材料的适宜ＷＣ含量为１０ｖｏｌ％左右。并就ＷＣ对该材料组织和再结晶行为的影响进行了有益的探讨。     

氧化铝/锌合金复合材料界面的SEM观察

利用挤压铸造制备氧化铝／锌合金复合材料，在扫描电镜（ＳＥＭ）上观察复合材料的界面。结果表明，在复合材料中纤维与基体间存在致密界面层，合金元素通过适当的化学反应可改善纤维与基体间的结合；在凝固过程中，纤维／基体界面上的硅在共晶体的共生生长过程中起了领先相作用，导致复合材料的共晶转变是由铝硅共晶转变和锌铝共晶转变两者组成。     

Neural network congestion controller in prioritised ATM switch

A neural network (NN) scheme is proposed for congestion control in an ATM switch with time priorities. It is shown that in a prioritised switch it is necessary to monitor the buffer to be controlled as well as buffers with higher priorities. Furthermore, it is shown that the NN scheme in a time prioritised switch gives lower cell loss and delay when compared to the conventional binary scheme     

Design of finite-length metal-clad optical waveguide polarizer

The performance of optical metal-clad waveguide polarizers is analyzed in this paper with a view to optimizing the extinction ratio, a condition for which power of the TM mode is completely attenuated is identified here. In general, such a condition corresponding to an infinitely high extinction ratio can be met for a wide range of buffer layer thicknesses by selection of metal film thickness and polarizer length. When a very thick (e.g., semi-infinitely thick) metal film is used, the aforementioned condition can be met with a properly chosen buffer layer thickness and polarizer length. The numerical results show that all the polarizers designed here for realization of infinitely high extinction ratios have either quite low or reasonably acceptable attenuations for the TE mode     

Nonoperative management of esophageal perforations. Is it justified?

OBJECTIVE: Experiences obtained with nonoperative treatment (NOT), i.e. total prohibition of per oral food intake for a minimum of 7 days, administration of combinations of broad-spectrum antibiotics, and parenteral hyperalimentation, are described in the management of esophageal perforations. SUMMARY BACKGROUND DATA: The place, value, and indication of NOT in the management of esophageal perforation has not yet been unequivocally defined. As a result, contradictory data have been published regarding the outcome of NOT. METHODS: During the past 15 years (1979 to 1994), 20 of 86 patients (23.3%) with esophageal perforation have been treated nonoperatively from the outset. In this group, perforations were located to the upper, middle, and lower third of the esophagus in 50%, 30%, and 20%, respectively. In the operative management group (OT)--in which conservative (drainage, endeprothesis), reconstructive (suture, reinforced suture), and radical (resection) surgical methods were applied--lesions were preponderantly located in the lower one third of the esophagus (56.1%--37/66). As to the interval between the perforation and the onset of treatment, 14 patients had been diagnosed within 24 hours, whereas in 6 cases treatment had been begun beyond 24 hours. RESULTS: NOT could be successfully carried out in 16 patients; the decision to use NOT had to be revised in 4 other cases (Table 1). Two patients were lost; the mortality rate was 10% (2 of 20). The rate of complications was lower in the NOT group (20%, or 4 of 20) than in the OT group (50%, or 33 of 66). CONCLUSIONS: NOT can be suggested for the treatment of intramural perforations. In the case of transmural perforation, this approach should be taken into consideration if the esophageal lesion is circumscribed, is not in neoplastic tissue, is not in the abdominal cavity, and is not accompanied by simultaneous obstructive esophageal disease; in addition, symptoms and signs of septicemia should be absent.     

Analysis of Combined Systems of Two Endoreversible Engines

A single endoreversible engine can operate as a cooler, a true heat engine, a heat pump, or a refrigerator. We investigate how many different modes of operation a combined system of two endoreversible engines may display. Special attention is paid to the independent combined system which neither consumes nor supplies power.     

Superconducting control for surge currents

Systems designed to use superconductors to limit fault currents in power grids are undergoing testing. The authors describe superconducting fault current limiters (SCFCL) which may be categorised into resistive or shielded core types. The features and operation of each type of device are outlined. Both the shielded-core and resistive types of SCFCL use the same amount of superconductor material to achieve a given limitation behavior. This is because the rated power per volume of conductor is determined by the product of fault-induced field and critical current, which is the same for both devices, assuming the same type of superconducting material is employed. The shielded-core limiter works only with AC currents and is much larger and heavier than the resistive SCFCL. While there is only one large program left in the low-temperature type of SCFCL, more than 10 major projects are under way worldwide on the high-temperature type of device. The main reason is the lower HTS cooling cost     

Estimating the cost of an interview survey using geographic information system software

Estimating the cost of interview surveys is difficult but important. A geographic information system (GIS) was used to determine the shortest time route to survey 533 medical facility locations in Perth. The results provided time and cost estimates for undertaking the survey and the interviewer agreed to a contract for the job on the basis of these estimates.