Improvement of damage detection methods based on experimental modal parameters

The objective of this paper is to introduce a new method for structural damage detection based on experimentally obtained modal parameters. The new method is suitable for detection of fatigue damage occurring in an aluminium cantilever beam. The damage has been practically realised as saw cuts of different sizes and at different locations. The first step of analysis included an attempt of damage identification with the most often used damage indicators based on measured modal parameters. For that purpose special signal processing technique has been proposed improving the effectiveness of indicators tested. However the results obtained have not been satisfactory. That was the motivation for defining new damage indicators (frequency change based damage indicator, Hybrid Damage Detection method), utilising the change of natural frequencies and any mode shape (measured or modelled) as the measurement of frequencies is much less time consuming in comparison to total mode shape measurement. It has been shown that the proposed technique is suitable for damage localisation in beam-like structures.     

Electrolytic deposition and corrosion resistance of Zn-Ni coatings obtained from sulphate-chloride bath

Zn-Ni coatings were deposited under galvanostatic conditions on steel substrate (OH18N9). The influence of current density of deposition on the surface morphology, chemical and phase composition was investigated. The corrosion resistance of Zn-Ni coatings obtained at current density 10–25 mA cm⁻² are measured, and are compared with that of metallic cadmium coating. Structural investigations were performed by the X-ray diffraction (XRD) method. The surface morphology and chemical composition of deposited coatings were studied using a scanning electron microscope (JEOL JSM-6480) with EDS attachment. Studies of electrochemical corrosion resistance were carried out in the 5% NaCl, using potentiodynamic and electrochemical impedance spectroscopy (EIS) methods. On the ground of these research, the possibility of deposition of Zn-Ni coatings contained 24–26% at. Ni was exhibited. It was stated, that surface morphology, chemical and phase composition of these coatings are practically independent on current density of deposition. On the basis of electrochemical investigations it was found that corrosion resistance of these Zn-Ni coatings is also independent of current density. These coatings are more corrosion resistant in 5% NaCl solution than metallic cadmium. It was suggested that the Zn-Ni coating may be used as a substitute for toxic cadmium.     

Determination of mass density, dielectric, elastic, and piezoelectric constants of bulk GaN crystal

Mass density, dielectric, elastic, and piezoelectric constants of bulk GaN crystal were determined. Mass density was obtained from the measured ratio of mass to volume of a cuboid. The dielectric constants were determined from the measured capacitances of an interdigital transducer (IDT) deposited on a Z-cut plate and from a parallel plate capacitor fabricated from this plate. The elastic and piezoelectric constants were determined by comparing the measured and calculated SAW velocities and electromechanical coupling coefficients on the Z- and X-cut plates. The following new constants were obtained: mass density p = 5986 kg/m(3); relative dielectric constants (at constant strain S) ε(S)(11)/ε(0) = 8.6 and ε(S)(11)/ε(0) = 10.5, where ε(0) is a dielectric constant of free space; elastic constants (at constant electric field E) C(E)(11) = 349.7, C(E)(12) = 128.1, C(E)(13) = 129.4, C(E)(33) = 430.3, and C(E)(44) = 96.5 GPa; and piezoelectric constants e(33) = 0.84, e(31) = -0.47, and e(15) = -0.41 C/m(2).     

Differences in two-dimensional gel electrophoresis patterns of skeletal muscle myosin light chain isoforms between Bos taurus, Sus scrofa and selected poultry species

BACKGROUND: In this study the interspecies differences in two‐dimensional electrophoresis patterns of skeletal muscle myosin light chain (MLC) isoforms between Bos taurus (cattle), Sus scrofa (pig), Gallus gallus (chicken), Meleagris gallopavo (turkey), Anas platyrhynchos (duck) and Anser anser (goose) were characterised on the basis of specific properties of MLCs associated with their structure and mobility in gel. RESULTS: Two‐dimensional electrophoresis separations revealed species‐specific differences in the molecular weight and pI of individual MLC isoforms (MLC1f, MLC2f and MLC3f). In the case of closely related animal species such as goose and duck or turkey and chicken, significant differences occurred in MLC1f. For MLC2f, differences between cattle and turkey and between pig and chicken were around 1 and 0.3 kDa respectively. It appeared from the comparison of amino acid sequences that even MLCs with only 2% difference in sequences have different electrophoretic mobilities. CONCLUSION: Interspecies differences in skeletal MLC isoforms appeared between cattle, pig, chicken, turkey, duck and goose. The slight changes observed in the course of the aging process confirmed that these proteins are relatively little susceptible to proteolytic enzymes during meat aging. Copyright © 2011 Society of Chemical Industry     

The preparation of TiO2–nitrogen doped by calcination of TiO2·xH2O under ammonia atmosphere for visible light photocatalysis

The investigation on incorporating nitrogen group into titanium dioxide in order to obtain powdered visible light-active photocatalysts is presented. The industrial hydrated amorphous titanium dioxide (TiO₂·xH₂O) obtained directly from sulphate technology installation was modified by heat treatment at temperatures of 100–800 °C for 4 h in an ammonia atmosphere. The photocatalysts were characterized by UV–VIS–DR and XRD techniques. The UV–VIS–DR spectra of the modified catalysts exhibited an additional maximum in the VIS region (, ) which may be due to the presence of nitrogen in TiO₂ structure. On the basis of XRD analysis it can be supposed that the presence of nitrogen does not have any influence on the transformation temperature of anatase to rutile. The photocatalytic activity of the modified photocatalysts was determined on the basis of decomposition rate of phenol and azo-dye (Reactive Red 198) under visible light irradiation. The highest rate of phenol degradation was obtained for catalysts calcinated at 700 °C (6.55%), and the highest rate of dye decomposition was found for catalysts calcinated at 500 and 600 °C (ca. 40–45%). The nitrogen doping during calcination under ammonia atmosphere is a very promising way of preparation of photocatalysts which could have a practical application in water treatment system under broader solar light spectrum.     

In-vessel composting for utilizing of municipal sewage-sludge

The amount of sludge generated from wastewater treatment plants has been increasing year-by-year as the sewerage service area expanded. The composting process is considered to be one of the best management methods to stabilize different organic wastes. The main goal of this investigation was to find the optimal ratio of the quantity of the organic waste to the quantity of the sewage sludge. The process of composting was carried out in the Horstmann bioreactor (pilot scale) for 2–3 weeks and then in a compost pile for 6–12 weeks. Seven experiments were performed, with different ratios of the quantity of organic wastes to the quantity of sewage sludge. The results enabled an estimation of the quality of compost and its usefulness and also the usefulness of the bioreactor to be deduced.     

Molecular recognition of the Lewis Y antigen by monoclonal antibodies

The murine monoclonal antibody BR55-2 is directed against thetumor-associated antigen Lewis Y oligosaccharide. The LewisY core antigen is a difucosylated structure consisting of fourhexose units. Analysis of binding profiles of lactoseries isomericstructures by BR55–2 suggest that the binding epitopeincludes the OH-4 and OH-3 groups of the ß-D-galactoseunit, the 6-CH₃ groups of the two fucose units and the N-acetylgroup of the subterminal ß-D-N-acetylglucosamine (ßDGlcNAc).To elucidate the molecular recognition properties of BR55–2for the Y antigen, BR55–2 was cloned, sequenced and itsthree-dimensional structure was examined by molecular modeling.The crystal structure of BR96, another anti-Lewis Y antibody,solved in complex with a nonoate methyl ester Lewis Y tetrasaccharide,and the lectin IV protein in complex with a Lewis b tetrasaccharidecore were used as a guide to probe the molecular basis for BR55–2antigen recognition and specificity. Our modeling study showsthat BR55–2 shares similar recognition features for thedifucosylated type 2 lactoseries Lewis Y structure observedin the BR96-sugar complex. We observe that a major source ofspecificity for the Lewis Y structure by anti-Y antibodies emanatesfrom interaction with the ß-D-N-acetylglucosamineresidue and the nature of the structures extended at the reducingsite of the fucosylated lactosoamine.     

Isobaric vapour-liquid equilibrium for the binary mixtures of 1-bromobutane with isomeric butanols at 40.0 and 101.3 kpa

A dynamic recirculating still was employed to measure isobaric vapour-liquid equilibrium at 40.0 and 101.3 kPa for the binary systems 1-bromobutane and each of the isomers of butanol. All mixtures show azeotropes at both pressures. The experimental VLE data are thermodynamically consistent and were correlated using Margules, Van Laar, Wilson, NRTL and UNIQUAC equations.