Compression of Na0.4Mg0.6Al1.6Si0.4O4 NAL and Ca-ferrite-type phases

Compression behaviors of two Al-rich phases in the lower mantle, hexagonal new aluminum-rich (NAL) phase and its high-pressure polymorph Ca-ferrite-type (CF) phase, were examined for identical Na_0.4Mg_0.6Al_1.6Si_0.4O₄ (40?% NaAlSiO₄–60?% MgAl₂O₄) composition. The volumes of the NAL and CF phases were obtained at room temperature up to 31 and 134?GPa, respectively, by a combination of laser-annealed diamond-anvil cell techniques and synchrotron X-ray diffraction measurements. Fitting of the third-order Birch–Murnaghan equation of state to such pressure–volume data yields bulk modulus K ₀?=?199(6) GPa at 1?bar and its pressure derivative K ₀′?=?5.0(6) for the NAL phase and K ₀?=?169(5) GPa and K ₀′?=?6.3(3) for the CF phase. These results indicate that the bulk modulus increases from 397 to 407 GPa across the phase transition from the NAL to CF phase at 43 GPa, where the NAL phase completely transforms into the CF phase on Na_0.4Mg_0.6Al_1.6Si_0.4O₄. Density also increases by 2.1?% across the phase transition.     

Groundwater recharge and discharge processes in the Jakarta groundwater basin, Indonesia

Proper management of groundwater resources requires knowledge of the processes of recharge and discharge associated with a groundwater basin. Such processes have been identified in the Jakarta groundwater basin, Indonesia using a theory that describes the simultaneous transfer of heat and fluid in a porous medium. Temperature-depth profiles in monitoring wells are used to determine the geothermal gradient. To examine the rules of groundwater flow in the distortion of the isotherms in this area, several methods are compared. Subsurface temperature distribution is strongly affected by heat advection due to groundwater flow. Under natural flow conditions, the recharge area is assumed to occur in the hills and uplands, which are located on the periphery of the Jakarta basin, and the discharge area is located in the central and northern part of the Jakarta groundwater basin. A transition area, which could act as local recharge and discharge areas, occupies the middle of the lowland. Subsurface temperatures show good correlation with the groundwater flow conditions, and the data yield important information on the location of recharge and discharge areas.     

Structural controls on the 1998 volcanic unrest at Iwate volcano: Relationship between a shallow, electrically resistive body and the possible ascent route of magmatic fluid

Magnetotelluric (MT) measurements were conducted at Iwate volcano, across the entirety of the mountain, in 1997, 1999, 2003, 2006, and 2007. The survey line was 18 km in length and oriented E–W, comprising 38 measurements sites. Following 2D inversion, we obtained the resistivity structure to a depth of 4 km. The surface resistive layer (~ several hundreds of meters thick) is underlain by extensive highly conductive zones. Based on drilling data, the bottom of the highly conductive zone is interpreted to represent the 200 °C isotherm, below which (i.e., at higher temperatures) conductive clay minerals (smectite) are rare. The high conductivity is therefore mainly attributed to the presence of hydrothermally altered clay. The focus of this study is a resistive body beneath the Onigajo (West-Iwate) caldera at depths of 0.5–3 km. This body appears to have impeded magmatic fluid ascent during the 1998 volcanic unrest, as inferred from geodetic data. Both tectonic and low-frequency earthquakes are sparsely distributed throughout this resistive body. We interpret this resistive body as a zone of old, solidified intrusive magma with temperatures in excess of 200 °C. Given that a similar relationship between a resistive body and subsurface volcanic activity has been suggested for Asama volcano, structural controls on subsurface magmatic fluid movement may be a common phenomenon at shallow levels beneath volcanoes.