硫含量对钴钼型耐硫脱氧剂的脱氧活性影响

研究了工艺气中硫含量对钴钼型耐硫脱氧剂脱氧活性的影响。通过常压微反 -色谱装置测定脱氧剂的本征脱氧活性 ,加压原粒度反应器测定脱氧剂的表观脱氧活性 ,结合实际经验确定了耐硫脱氧剂所需的最低硫含量。还讨论了温度、压力、空速对耐硫脱氧剂脱氧活性的影响。结果表明 ,耐硫脱氧剂完全能满足耐硫变换工艺的要求 ,而且有耐硫变换的作用 ,并对耐硫变换催化剂起到保护作用     

Modelling asymmetry in the peripheral auditory system of the lizard

The ears of lizards are highly directional. The directionality is generated by strong acoustical coupling of the eardrums. A simple lumped-parameter model of the ear followed by binaural comparisons has been shown to perform successful phonotaxis in robot implementations. However, such a model will produce localization errors in the form of response bias if the ears are asymmetrical. We have evaluated how large errors are generated by asymmetry using simulations of the ear model in Mathematica 5.2. The study shows that the effect of asymmetry is minimal around the most directional frequency of the ear, but that biases reduce the useful bandwidth of localization. This work was presented in part at the First European Workshop on Artificial Life and Robotics, Vienna, Austria, July 12–13, 2007     

Piezoelectric Nanogenerators for Self-Powered Nanodevices

A novel approach converts nanoscale mechanical energy into electric energy for self-powering nanodevices.In our own work, we've used piezoelectric zinc-oxide nanowire (ZnO NW) arrays to demonstrate a novel approach for converting nanoscale mechanical energy into electric energy. Here, we review the fundamental principle behind the nanogenerator, present an approach for improving its performance, and discuss some of the challenges we face in pushing this technology to reach its potential.     

CMTS＋CM技术实现有线电视网络双向传输原理

用CMTS＋CM技术实现宽带接入是有线电视的主流方向。本文对其传输的原理、技术指标、改造注意事项及综合性能进行了分析。     

A polynomial dynamic system approach to software design for attractivity requirement

Because of the widespread increasing application of Web services and autonomic computing, self-adaptive software is an area gaining increasing importance. Control theory provides a theoretical foundation for self-adaptive software. In this paper, we propose the use of the supervisory control theory of discrete event dynamic systems (DEDS) to provide a rigorous foundation for designing software for reactive systems. This paper focuses in particular on design of software with an attractivity requirement. It studies this problem using the polynomial dynamic system (PDS) model of DEDS. A necessary and sufficient condition for software existence and two algorithms for such software design are presented.     

非标压力机箱形主梁全约束优化设计

根据非标设备结构优化问题的特点,给出满足《钢结构设计规范》(GBJ17 88)规定的箱形主梁全约束优化设计方 法。将编制的内罚函数法优化程序应用于主梁的设计,计算结果表明,该优化方法可应用于实际设计。     

剖析全板电镀镍金发白现象

简要介绍了全板电镀镍金加工过程中镀金面发白现象及改善措施。特别是针对高位发白(或粗糙)的产生原因和处理过程进行较为详细的描述,并对工艺在此处理过程中存在问题进行了简要剖析。     

小生境遗传算法AVOA反演

采用具有水平对称轴的横向各向同性(HTI)模型研究裂缝性油气藏,P波振幅随炮检距和方位角变化(AVOA),表现出较强的方位各向异性特征。本文基于Ruger提出的HTI介质模型的P波反射系数公式,利用由基准测线和另外两条与之呈45°、90°测线的P波反射系数的相对差异估算裂缝方位;同时引入小生境遗传算法,对基准测线和与之呈90°测线的P波反射系数差进行反演,得到了较高精度的纵、横波波速比和Thomsen各向异性参数。     

Studies of substrate specificities of lipases from different sources

Although lipases are widely applied in a wide variety of reactions, available information on the factors that are responsible for the substrate specificities of lipases from different sources is scarce. In this paper, nine lipase‐producing microorganism strains were isolated from oil‐containing samples. The properties of these enzymes, including pH optima, temperature optima, thermal stability, and pH stability, vary significantly with the different sources from which these lipases were isolated. The substrate specificities of the nine lipases, including fatty acid and positional specificities, were also studied. The fatty acid specificities of the nine lipases were observably different toward 15 substrates with different carbon chain lengths, different saturation degrees and different side chains. The lipases from S₃ Penicillium citrinum (PCL), MJ₁ Aspergillus niger (ANL), MJ₂ Aspergillus oryzae (AOL), YM Bacillus coughing (BCL), S₉ Geotrichum candidum (GCL), and S₁₁ Candida lypolytica (CLL) showed the strongest specificities to short‐chain esters, and the other lipases showed strong selectivity for medium‐ or long‐chain and branched esters. The positional specificities were examined by analyzing the hydrolytic products of triolein catalyzed by the nine lipases, using TLC. The lipases can be mainly classified into two groups by their specificities for the ester bond at position 2 of triglycerides; one group can selectively hydrolyze the ester bond at position 2 of the triglycerides, the other group cannot. All these nine lipases were divided into four groups by hierarchical clustering analysis on the basis of the results of fatty acid and positional specificities.     

Preparation and Characterization of Carboxymethyl Chitosan and β-Cyclodextrin Microspheres by Spray Drying

Three kinds of carboxymethyl chitosan/β-cyclodextrin microspheres loaded with theophylline were prepared by spray drying intended for pulmonary delivery. Mucociliotoxicity, permeation rate, and drug release characteristics of the product were investigated. The microspheres obtained by spray drying were found to be spherical with smooth or wrinkled surfaces. The mean particle size was between 3.39 and 6.06 µm. The microspheres demonstrated high product yield (43.7-50.2%), high drug loading (13.7-38.1%), and high encapsulation efficiency (86.9-92.8%). FT-IR indicated that there were interactions of theophylline with carboxymethyl chitosan matrix. Further studies on mucociliotoxicity and permeation confirmed that microspheres had better adaptability and high permeation rate. In vitro drug release from the microspheres was not related to the drug/polymer ratios.