Reverse osmosis performance of organosilica membranes and comparison with the pervaporation and gas permeation properties

Hybrid organosilica membranes were successfully prepared using bis(triethoxysilyl)ethane (BTESE) and applied to reverse osmosis (RO) desalination. The organosilica membrane calcined at 300^°C almost completely rejected salts and neutral solutes with low‐molecular‐weight. Increasing the operating pressure led to an increase in water flux and salt rejection, while the flux and rejection decreased as salt concentration increased. The water permeation mechanism differed from the viscous flow mechanism. Observed activation energies for permeation were larger for membranes with a smaller pore size, and were considerably larger than the activation energy for water viscosity. The organosilica membranes exhibited exceptional hydrothermal stability in temperature cycles up to 90^°C. The applicability of the generalized solution‐diffusion (SD) model to RO and pervaporation (PV) desalination processes were examined, and the quantitative differences in water permeance were accurately predicted by the application of generalized transport equations. © 2012 American Institute of Chemical Engineers AIChE J, 59: 1298–1307, 2013     

Determination of the Temperature Coefficient Distribution of Dielectric Ceramics Using Scanning Photothermal Dielectric Microscopy

Two-dimensional images of the distribution showing the temperature coefficient of the dielectric constant for two types of two-phase composite ceramics composed of TiO₂-Bi₂Ti₄O₁₁ and BaTi₄O₉-BaPr₂Ti₄O₁₂ were obtained using scanning photothermal dielectric microscopy. The images of the TiO₂-Bi₂Ti₄O₁₁ ceramic showed that the TiO₂ and Bi₂Ti₄O₁₁ grains had negative and positive temperature coefficients, respectively, and that the macroscopic averaged temperature coefficient of the ceramic was relatively low because of the cancellation of the opposite signs of the coefficients. On the other hand, the images of the BaTi₄O₉-BaPr₂Ti₄O₁₂ ceramic showed that the temperature coefficient of both grains had the same sign (negative), although their absolute values were quite different.     

Hydrocracking of diphenylmethane and tetralin over bifunctional NiW sulfide catalysts supported on three kinds of zeolites

Hydrocracking reactions of diphenylmethane and tetralin were carried out over three kinds of zeolites with or without NiW sulfide to discuss the roles of catalytic bifunctionality in two types of hydrocracking reactions. It was found that strong acid sites were not needed for the hydrocracking of diphenylmethane, while the conversion of tetralin required relatively strong acid sites. Ultra-stable Y zeolite with strong acidity exhibited high hydrocracking activity for both reactions. In contrast, mordenite catalysts did not show high activity for either hydrocracking, though isomerization of tetralin and excess hydrocracking to gaseous products proceeded. The superior performances of ultra-stable Y zeolite in the tetralin hydrocracking were suggested to be related to the hydrogen transfer ability. In most cases, the loading of NiW sulfide enhanced catalytic activity. In the diphenylmethane hydrocracking, the role of NiW sulfide was found to supply active hydrogen to the hydrocracking active sites on zeolite and to prevent polymerization of benzyl cations. In the tetralin hydrocracking, the dehydrogenated products from tetralin were re-hydrogenated over NiW sulfide.     

Mechanism of photoconductivity gain and persistent photoconductivity for diamond photodetector

Photoconductivity gain (PG) and persistent photoconductivity (PPC) properties observed in diamond photodetector are theoretically explained by solving rate equations which describe capture and emission processes of photo-generated hole and electron through a boron acceptor and a hole trap in a diamond epilayer and a nitrogen donor in a diamond substrate. Formation of one-sided pn-junction between the epilayer and substrate and slow hole capture rate of acceptor and hole trap levels provide accumulation of photo-generated hole in the epilayer, which produces the PG larger than the ideal responsivity. The PPC current after turning off the deep ultraviolet light is interpreted as due to the slow hole capture rate of the acceptor and trap levels.     

Fabrication and electrical properties of SrTiO3/diamond junctions

Strontium titanate (STO) films were directly deposited on Ib (100) single crystal diamond by r.f. magnetron sputtering. The as-deposited STO film was in amorphous state. On the other hand, the crystalline STO film was obtained under the optimized condition of a deposition temperature of 250 °C and a post-annealing temperature of 650 °C. STO/diamond junctions were fabricated on boron-doped homoepitaxial layers grown on p⁺-type single crystal diamond substrates. Electrical properties of the STO/diamond junction were investigated by changing the surface terminations of diamond with hydrogen or oxygen and the crystallinity of the STO film. It was found that the amorphous STO acted like a semi-insulator on H-diamond surface and that the amorphous STO/O-diamond junction behaved like a Schottky diode. The crystalline STO/O-diamond showed a complex rectifying behavior. The crystalline STO film possessed a higher dielectric constant as compared to that of the amorphous one.     

Decay of material properties of degraded MEA caused by repeated cold starts under subzero conditions in polymer electrolyte fuel cells

This study investigated the characteristics of cell performance degradation, decline of component performance, and changes in the properties of membrane electrode assembly materials caused by repeated cold starts under a subzero condition of ?30 °C. It was made clear that functional decay appeared mainly at the cathode due to increased proton conductive impedance and reduction of reactivity of the electrode catalyst. Among the cathode components, an increase in proton conductive impedance in the cathode electrolyte was dominant. Furthermore, the application of ion chromatography and a newly developed proton‐induced gamma‐ray emission method to measure fluorine in the off‐gas drain revealed that decomposition of the electrolyte was dominant in the cathode catalyst layer. A decrease in fluorine in the cathode electrolyte measured by fluorine‐19 nuclear magnetic resonance confirmed this decomposition. A hypothesis is also presented concerning the cause of the performance degradation. © 2012 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley Online Library ( wileyonlinelibrary.com/journal/htj ). DOI 10.1002/htj.20394     

Dependence of ion selectivity on ordered orientation of neutral carriers in ion-sensing membranes based on thermotropic liquid crystals

Thermotropic liquid-crystalline compounds were applied as membrane materials (membrane solvent and neutral carrier) for neutral carrier-type ion sensors to investigate how the ordered arrangement of neutral carriers affects the property of the resulting ion sensors. Nematic, smectic, and cholesteric liquid-crystalline compounds were used as the membrane solvents and crown ether derivatives with a molecular structure similar to the liquid-crystalline solvent as the K+ neutral carriers. Polarized IR spectroscopy and X-ray diffraction experiments confirmed that the highly ordered arrangement of membrane components was retained in the liquid-crystal-based ion-sensing membranes containing a neutral carrier and a lipophilic salt. The ordered arrangement of neutral carriers in the liquid-crystalline membranes enhanced the ion selectivity significantly, probably due to the efficient cooperation of two adjacent crown ether moieties in the highly ordered and aggregated state.     

Risk assessment of airborne fine particles and nanoparticles

Pulmonary health effects of fine particles and nanoparticles are overviewed in this paper, mainly based on the researches conducting in our laboratory. For the hazard assessment, we exposed rats to aerosolized asbestos-substitutes or nanoparticles aerosols (nickel oxide and titanium dioxide), and examined the biological and pathological effects of the particle on lung, a major target organ for the particles, and cytokines which are related to inflammation, fibrosis and carcinogenesis in the lung. It is essential to perform comprehensive evaluation of the toxicity of poorly soluble powder samples using the precise characterization data and exposure methods, such as single instillation or aerosol inhalation.     

Fluctuations in Tracer Amounts in a Compartmental System with a Markovian Transition Process

This communication considers a method for evaluating fluctuations in the integral type output of a linear time-invariant compartmental system with a Markovian transition process. First, we derived a mathematical formula to calculate variances and covariances of integral type. outputs, as with radioisotope data, when transition rates are known. Then, an estimate for the upper limits of variances and covariances, i.e., 1/2?initial dose, when the transition rates are not given beforehand, was introduced.     

Detection of back-side pit on a ferrous plate by magnetic flux leakage method with analyzing magnetic field vector

We have developed a magnetic flux leakage (MFL) system using magnetic resistive (MR) sensors for detecting two dimensional magnetic field components, and an induction coil that generates low magnetic field strengths and extremely low frequencies. The signal at each scanned measurement point (i) was divided by the signal strength M_mes,i and phase α_i by a lock-in amplifier. Using the strength M_mes,i and phase α_i, we calculated the imaginary part of the signal using the common phase β. By optimization of the common phase β to the imaginary part, the analyzed scanning data curve was shown to be effective in estimating the size (depth and diameter) of back-side pits on a ferrous plate. Comparing the two dimensional magnetic field components of leakage, the imaginary part of the y-component parallel to the induced magnetic field was found to be suitable for detecting the back-side pits.