Performance of solvothermally prepared Ga2O3-Al2O3 catalysts for SCR of NO with methane

The solvothermal reaction of mixtures of aluminum isopropoxide (AIP) and gallium acetylacetonate (Ga(acac)₃) directly yielded the mixed oxides of γ-Ga₂O₃-Al₂O₃. In the solvothermal synthesis, the crystal structure of mixed oxides was controlled by the initial formation of γ-Ga₂O₃ nuclei. The mixed oxides prepared in diethylenetriamine have extremely high activities for selective catalytic reduction (SCR) of NO with methane as a reducing agent. With increasing crystallite size of the spinel structure, the catalytic activity increased. The ratio of the amount of methane consumed by combustion to total methane conversion was proportional to the density of acid sites on the surface of the mixed oxides. The mixed oxide catalysts prepared in diethylenetriamine had lower densities of acid sites and showed a higher methane-efficiency for CH₄-SCR than those prepared in other solvents. These catalysts maintained their high activity even when the reaction was carried out under the severe conditions (i.e., high space velocity and low NO concentration).     

Observation of single-walled carbon nanotubes by photoemission microscopy

Single-walled carbon nanotube networks grown on SiO₂ pillars were studied by means of scanning photoemission microscopy. The individual nanotubes or nanotube bundles growing from the pillar tops were observed in C 1s images. Band bending near catalytic Fe/nanotube contacts in an end-bonded configuration was studied by measuring C 1s spectra along the tube axes. Within our experimental resolution, no band bending was observed. This implies that the depletion width is less than the spatial resolution of the scanning photoemission microscope (90 nm) or that the amount of the band bending is less than 0.1 eV.     

Crystalline complex between poly(γ-methyl l-glutamate) and dimethyl phthalate

The crystalline complex between poly(γ-methyl l-glutamate) (PMLG) and dimethyl phthalate (DMP) has been formed in films cast from a solution in dichloroethane. It has the stoichiometry of 1 mol of DMP to three or four residues of PMLG and shows two definite characteristics in X-ray diffraction patterns; one is the large hexagonal unit cell with the edge of around 28 Å and another the ‘extra’ 5.07 Å meridional reflection which can not be interpreted by a PMLG α-helical conformation. The structural examination for the films with various DMP contents is carried out by X-ray, viscoelastic, and d.s.c. measurements and the following structure is proposed for the crystalline complex. Four PMLG are associated to form a group which is hexagonally packed and DMP molecules, located in the gaps between groups, form a specific favourable helical structure along PMLG chains in which the van der Waals stacking of benzene rings of DMP is significant.     

Design of new catalysts for ecological high-quality transportation fuels by combinatorial computational chemistry and tight-binding quantum chemical molecular dynamics approaches

Recently, we introduced a concept of combinatorial chemistry to computational chemistry and proposed a new method called “combinatorial computational chemistry”, which enables us to perform a theoretical high-throughput screening of catalysts. In the present paper, we reviewed our recent application of our combinatorial computational chemistry approach to the design of new catalysts for high-quality transportation fuels. By using our combinatorial computational chemistry techniques, we succeeded to predict new catalysts for methanol synthesis and Fischer–Tropsch synthesis. Moreover, we have succeeded in the development of chemical reaction dynamics simulator based on our original tight-binding quantum chemical molecular dynamics method. This program realizes more than 5000 times acceleration compared to the regular first-principles molecular dynamics method. Electronic- and atomic-level information on the catalytic reaction dynamics at reaction temperatures significantly contributes the catalyst design and development. Hence, we also summarized our recent applications of the above quantum chemical molecular dynamics method to the clarification of the methanol synthesis dynamics in this review.     

Allelopathic Effects of Volatile Monoterpenoids Produced by <Emphasis Type="Italic">Salvia leucophylla</Emphasis>: Inhibition of Cell Proliferation and DNA Synthesis in the Root Apical Meristem of <Emphasis Type="Italic">Brassica campestris</Emphasis> Seedlings

Salvia leucophylla, a shrub observed in coastal south California, produces several volatile monoterpenoids (camphor, 1,8-cineole, -pinene, -pinene, and camphene) that potentially act as allelochemicals. The effects of these were examined using Brassica campestris as the test plant. Camphor, 1,8-cineole, and -pinene inhibited germination of B. campestris seeds at high concentrations, whereas -pinene and camphene did not. Root growth was inhibited by all five monoterpenoids in a dose-dependent manner, but hypocotyl growth was largely unaffected. The monoterpenoids did not alter the sizes of matured cells in either hypocotyls or roots, indicating that cell expansion is relatively insensitive to these compounds. They did not decrease the mitotic index in the shoot apical region, but specifically lowered mitotic index in the root apical meristem. Moreover, morphological and biochemical analyses on the incorporation of 5-bromo-2-deoxyuridine into DNA demonstrated that the monoterpenoids inhibit both cell-nuclear and organelle DNA synthesis in the root apical meristem. These results suggest that the monoterpenoids produced by S. leucophylla could interfere with the growth of other plants in its vicinity through inhibition of cell proliferation in the root apical meristem.     

Intrinsic Elastic, Dielectric, and Piezoelectric Losses in Lead Zirconate Titanate Ceramics Determined by an Immittance-Fitting Method

The material coefficients of "soft" and "hard" lead zirconate titanate (PZT) ceramics were determined as complex values by the nonlinear least-squares-fitting of immittance data measured for length-extensional bar resonators. The piezoelectric d -constant should be a complex value to obtain a best fitting between observed and calculated results. Because the elastic, dielectric, and piezoelectric losses determined in this process were not "intrinsic" losses, a calculation process to evaluate the "intrinsic" losses was proposed. It was confirmed that the intrinsic losses were smaller than the corresponding extrinsic losses. The intrinsic piezoelectric loss existed in both soft and hard PZTs; ∼50% of the loss of piezoelectric d -constant was derived from the elastic and dielectric losses. The most notable difference between the soft and hard PZTs was observed in their elastic losses.     

New multicolor and rewritable holographic polymer film for three‐dimensional holographic display

We have developed a new multicolor holographic polymer film. Our holographic polymer film contains 3‐[(2,4,6‐trichloro)azo]‐9H‐carbazole‐9‐ethanol (A‐1) and poly(methyl methacrylate). The holographic polymer film can be recorded with a holographic image without applying an external electric field. The diffraction efficiency was 57% at A‐1 with a 20 wt% of dope ratio. The writable holographic image writing for the holographic polymer film step used the silver halide photographic emulsion master plate 532‐nm laser beam under the nonelectric field. After the copy hologram is formed, our holographic polymer film can be displayed in red and green holographic images. Even though our holographic polymer film is rewritten over 200 times, the diffraction efficiency does not fall. As the holographic polymer film is manufactured using roll‐to‐roll techniques, although still in a laboratory scale in this study, it has a strong possibility of being manufactured in larger sizes with lower cost.     

Critical temperature for production of MAG by esterification of different FA with glycerol using <Emphasis Type="Italic">Penicillium camembertii</Emphasis> lipase

Production of MAG by a lipase-catalyzed reaction is known to be effective at low temperature. This phenomenon can be explained by assuming that synthesized MAG are excluded from the reaction system because MAG, which have low m.p., are solidified at low temperatures. Consequently, MAG are efficiently accumulated and do not serve as the precursor of DAG. If this hypothesis is correct, the critical temperature for MAG production, defined as the highest temperature at which DAG synthesis is repressed, should depend on the m.p. of the MAG. Esterification of FFA with glycerol using Candida rugosa, Rhizopus oryzae, and Penicillium camembertii lipases produced MAG efficiently at low temperatures. However, Candida lipase showed very low esterification activity at high temperatures (>20°C), and Rhizopus lipase produced not only MAG but also DAG even at low temperatures. Meanwhile, P. camembertii lipase catalyzed synthesis of MAG only from FFA and glycerol at low temperatures, although the enzyme catalyzed synthesis of DAG from MAG in addition to synthesis of MAG at high temperatures. We thus studied the effect of temperature on esterification of C₁₀−C₁₈ FFA with glycerol using Penicillium lipase as a catalyst and determined the critical temperatures for production of MAG. The critical temperature for production of each MAG showed a linear correlation with m.p. of the MAG, which supported the hypothesis. In addition, because the m.p. of MAG are estimated from that of the constituent FA, the optimal temperature for production of MAG can be predicted from the m.p. of the FFA used as a substrate.     

The effect of sputter etching on the surface characteristics of dyed aramid fabrics

Three kinds of aramid fabrics, Technora (modified p-aramid), Conex (m-aramid) and Kevlar (p-aramid), were subjected to sputter etching and argon low-temperature plasma treatments after dyeing in black with disperse dyes. The depth of shade increased considerably on Technora and Kevlar with the sputter etching treatment, but not on Conex fabrics. Argon low-temperature plasma treatment had virtually no effect on the depth of shade on the aramid fabrics.     

Stereochemistry and mechanism of the hydrogenation of dialkyl cyclohexenes

In order to investigate the steric effect of the substituents to determine the product distribution, disubstituted cyclohexenes were hydrogenated over several transition metal catalysts. Some cyclohexenes which have two large substituents at the vicinal carbon atoms, at least one of which is trigonal, were not hydrogenated over Raney Ni at all but were hydrogenated over Pt catalyst under our experimental conditions. Presumably, the stereoselectivity depends on the competitive operation of the torsional angle strain and the catalyst hindrance with substituents. In the hydrogenation over Pd catalyst, thermodynamically more stable products were dominant at the standard condition but at high substrate to catalyst ratio the less stable products were slightly preferred. No appreciable stereoselectivity was observed in the hydrogenation of 1,4-disubstituted cyclohexenes.