Thermal performance of a packed bed reactor for a high‐temperature chemical heat pump

The thermal performance of a chemical heat pump that uses the reaction system of calcium oxide/lead oxide/carbon dioxide, which is developed for utilization of high‐temperature heat above 800°C, is studied experimentally. The thermal performance of a packed‐bed reactor of a calcium oxide/carbon dioxide reaction system, which stores and transforms a high‐temperature heat source in the heat pump operation, is examined under various heat pump operation conditions. The energy analysis based on the experiment shows that it is possible to utilize high‐temperature heat with this heat pump. This heat pump can store heat above 850°C and then transform it into a heat above 900°C under an approximate atmospheric pressure. An applied system that combines the heat pump and a high‐temperature process is proposed for high‐efficiency heat utilization. The scale of the heat pump in the combined system is estimated from the experimental results. Copyright © 2001 John Wiley & Sons, Ltd.     

A fast method for the determination of the efficiency coefficient of bare CR-39 detector

A fast and simple method for the determination of the efficiency coefficient (η) of bare CR-39 detector is presented and discussed. The efficiency coefficient of bare CR-39 detector is then calculated by different ways and the obtained values are found to be comparable to each other. The average value of η of bare CR-39 is found to be 0.20 ± 0.01 tracks cm⁻² day⁻¹ per Bq m⁻³.     

Electron-impact excitation and ionization cross sections for ground state and excited helium atoms

Comprehensive and critically assessed cross sections for the electron-impact excitation and ionization of ground state and excited helium atoms are presented. All states (atomic terms) with n4 are treated individually, while the states with n5 are considered degenerate. For the processes involving transitions to and from n5 levels, suitable cross section scaling relations are presented. For a large number of transitions, from both ground and excited states, convergent close coupling calculations were performed to achieve a high accuracy of the data. The evaluated/recommended cross section data are presented by analytic fit functions, which preserve the correct asymptotic behavior of the cross sections. The cross sections are also displayed in graphical form.     

Mutants of the nematode Caenorhabditis elegans that are defective specifically in their attraction to cycloheximide

The nematode Caenorhabditis elegans exhibits chemotaxis toward a wide variety of chemicals including water-soluble molecules and volatile organic compounds. We have previously discovered that C. elegans wild-type strain N2 is strongly attracted by cycloheximide which has long been known as a bitter tastant for humans and other mammals. We describe here the isolation and initial characterization of the first mutants which were defective specifically in their attraction to cycloheximide. In our screenings, we selected two mutants that were defective in chemotaxis to cycloheximide but normal in their attraction to NH4Cl and histidine. These mutants also avoided quinine hydrochloride, CuSO4 and high concentrations of NaCl similar to the wild-type strain N2. Furthermore, no observable defect was detected in their attraction to volatile odorants such as isoamyl alcohol and diacetyl. Dye-filling experiments suggested that they have no morphological defect in the sensory endings of the amphid neurons.     

Biosynthesis of PP-V, a monascorubramine homologue, by Penicillium sp. AZ

The biosynthetic pathway of PP-V, a new monascorubramine homologue, was elucidated by 13C-labeling studies. The [1-13C] of acetate was incorporated into 2-, 3a-, 4a-, 6-, 8-, 9-, 11-, 13-, 15-, 17-, and 19-Cs of PP-V, and the [2-13C], into 3-, 4-, 5-, 8a-, 9a-, 10-, 12-, 14-, 16-, 18-, and 20-Cs. These incorporation patterns coincide with those reported in the biosynthesis of a Monascus azaphilone pigment, monascorubrin.     

High-throughput immunophenotyping by surface plasmon resonance imaging

Cell binding assays on antibody arrays permit the rapid immunophenotyping of living cells. The throughput of the analysis, however, is still limited due to our inability to perform parallel and quantitative detection of cells captured on the array. To address this limitation, we employed here an imaging technique based on surface plasmon resonance (SPR). SPR has been frequently used to monitor capture of proteins on antibody microarrays, while few cases were reported for capture of cells. Antibody arrays were prepared through the photopatterning of an alkanethiol monolayer on a gold-evaporated glass plate and the subsequent immobilization of various antibodies onto 4-9 separate spots created by photopatterning. A glass slip was mounted onto the array with a thin spacer to construct a parallel-plate chamber. Leukemia cells were injected into the chamber to conduct a binding assay, while refractive index changes at the vicinity of the array surface were monitored by SPR imaging. We observed that SPR signals were intensified on specific antibody spots but not on nonspecific spots. Confocal laser scanning microscopy revealed that the observed SPR signals were attributed to cell deformations caused by multivalent interactions with immobilized antibody, which effectively elevated the refractive index of a medium phase within an evanescent field. This effect could be suitably utilized to monitor quantitatively cell binding to multiple spots from a heterogeneous cell population.     

Carbon Nitride Loaded with an Ultrafine,Monodisperse, Metallic Platinum-Cluster Cocatalyst for the Photocatalytic Hydrogen-Evolution Reaction

For the realization of a next-generation energy society, further improvement in the activity of water-splitting photocatalysts is essential. Platinum (Pt) is predicted to be the most effective cocatalyst for hydrogen evolution from water. However, when the number of active sites is increased by decreasing the particle size, the Pt cocatalyst is easily oxidized and thereby loses its activity. In this study, a method to load ultrafine, monodisperse, metallic Pt nanoclusters (NCs) on graphitic carbon nitride is developed, which is a promising visible-light-driven photocatalyst. In this photocatalyst, a part of the surface of the Pt NCs is protected by sulfur atoms, preventing oxidation. Consequently, the hydrogen-evolution activity per loading weight of Pt cocatalyst is significantly improved, 53 times, compared with that of a Pt-cocatalyst loaded photocatalyst by the conventional method. The developed method is also effective to enhance the overall water-splitting activity of other advanced photocatalysts such as SrTiO₃ and BaLa₄Ti₄O₁₅.     

Design and control of a microrobotic system using magneticlevitation

Presents a prototype microrobot based on magnetic principles. Miniature items are to be transported and assembled in hazardous environments. A microrobot can be remotely operated with 3 DOF in an enclosed environment by transferring magnetic energy and optical signals from outside. The magnetic drive unit consists of 8 electromagnets (4 pairs), 2 permanent magnets, a return yoke and a pole piece. The microrobot is manipulated under the pole piece by regulating magnetic field. It consists of a magnetic head, a body (electronic circuit and batteries), and copper alloy ribbon ringers. A shape memory alloy actuator activates the fingers by illuminating/extinguishing several LED. PID controls were applied. To cope with uncertainties and variations in payload masses, an adaptive control law was also employed for positioning along the z axis to enable the controller parameters to be adjusted in real-time. Effectiveness of the control was verified by the results of several experiments. The microrobot has a net mass of 8.1 g and it can elevate and manipulate objects with masses up to 1.5 g within a volume of 29×29×26 mm³ with a precision of 0.05 mm