10 Gbit/s optical soliton transmission over 7200 km by using amonolithically integrated MQW-DFB-LD/MQW-EA modulator light source

The authors demonstrate 10 Gbit/s optical soliton transmission in a recirculating loop through the use of a monolithically integrated MQW-DFB-LD/MQW-EA modulator light source. The timing jitter due to the Gordon-Haus effect is successfully reduced by the optical bandpass filters conventionally used in the cascaded EDFAs to avoid the accumulation of amplified spontaneous emission. The transmission distance of 7200 km is achieved at a bit error rate of 10^-9     

a-Si alloy three-stacked solar cells with high stabilized-efficiency

a-Si alloy three-stacked solar cells have been studied to improve the stabilized efficiency of a-Si: H based solar cells. Based on the analysis by the individual characterization method of the component cells in stacked type cells, the a-Si :H middle cell was replaced with an a-SiGe :H cell. Furthermore, the optical confinement technology was improved to obtain a high-output current with thin i-layer thickness in the a-SiGe :H bottom cell. By this device design, the initial conversion efficiency was improved up to 12.4% and more than a 10% stabilized efficiency was obtained in a-SiC :H/a-SiGe :H/a-SiGe :H three-stacked cells. These cell characteristics were confirmed by measurements at the JQA Organization (the former JMI Institute).     

Area- and time-specific marginal capacity costs of electricity distribution

Marginal costs of electricity vary by time and location. In the past, researchers attributed the variations to factors related to electricity generation and transmission. These authors, however, have not analyzed possible variations in marginal distribution capacity costs (MDCC). The objectives of this paper are:

1. (i) to show that large MDCC variations are due to the dispersion in distribution capital expenditures by time and space,

2. (ii) to propose a method for quantifying the area- and time-specific MDCC in the presence of lumpy investments, and

3. (iii) to compare our MDCC estimates to those commonly used in the electric utility industry.

Our proposed method and its results were adopted by the California Public Utilities Commission (CPUC) in 1992 for Pacific Gas and Electric Company (PG&E), the largest privately owned electric utility in the U.S.     

Biochemical identification of transmembrane segments of the Ca(2+)-ATPase of sarcoplasmic reticulum

The transmembrane segments of sarcoplasmic reticulum Ca(2+)-ATPase were determined by trypsinization of cytoplasmic side-out intact sarcoplasmic reticulum vesicles. The membrane portion of tryptic digest comprising the transmembrane fragments, joined by the intravesicular segments, was separated by sodium dodecyl sulfate-polyacrylamide gel electrophoresis after labeling with fluorescein 5-maleimide in the presence of sodium dodecyl sulfate. In this way, seven fluorescent bands of tryptic fragments below 11 kDa were observed which were derived from 4 pairs of membrane spanning segments and one hydrophobic sequence at the C-terminal end. Two peptides of 10.8 and 10.6 kDa had the identical N-terminal sequence beginning at Glu826, representing the transmembrane segments M7 and M8 and their connecting loop. A band at 8.1 kDa contained one peptide beginning at Tyr36 (M1/loop/M2). A 7.7-kDa peptide starting at Leu253 (M3/loop/M4) and a 7.3-kDa peptide beginning at Ala752 (M5/loop/M6) were also observed. A band at 6.7 kDa contained two peptides, one beginning at Ser48 (M1/loop/M2) and another beginning at Tyr763 (M5/loop/M6). In addition, a 4-kDa peptide beginning at Met925 was observed. The size of this peptide did not allow for a complete pair of transmembrane segments, but this peptide could have been derived from trypsinolysis between the last pair of membrane spanning segments. These data therefore provide biochemical evidence for at least 8 transmembrane segments and perhaps two more at the C-terminal end of the enzyme.     

Aortic valve papillary fibroelastoma. A diagnosis by transthoracic echocardiography

Cardiac papillary fibroelastomas are unusual, frond-like growths typically found on cardiac valves, diagnosed incidentally on autopsy or cardiac surgery, but rarely during life. We report a rare case of an aortic valve papillary fibroelastoma detected by transthoracic echocardiography and confirmed by histologic study.     

Predictive equation for acquisition of hepatitis B in hospital workers in a general hospital

A cross-sectional study was performed to obtain risk factors for hepatitis B disease, HBsAg carriers and immunised personnel, among 2470 workers in a general hospital in Madrid, Spain. The data obtained were analyzed with multiple logistic regression to obtain beta coefficients for variables. The results of the analysis show that being a nurse or being regularly exposed to blood are the most important risk factors for hepatitis B acquisition. The length of time working at the same job activity was also a risk factor. The resulting beta coefficients allow the construction for a hepatitis non-immunised, HBsAg carrier and immunised HBV status, which can select subjects for a hepatitis B vaccination program.     

Methodological issues in outcome studies of school-based interventions for the prevention of adolescent depression.

Several methodological and ethical issues are addressed in the context of 3 related school-based studies of the primary and targeted prevention of depressive symptoms and disorder in high school adolescents. These issues include obtaining S consent and the protection of confidentiality, minimizing attrition over long-term follow-up periods, the "unit of assignment" issue common to most school-based research, and ensuring therapist fidelity to the intervention protocol. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

The evolution of custom microarray manufacture

Given the enormous size of the genome and that there are potentially many other types of measurements we need to do to understand it, it has become necessary to pick and choose one's targets to measure because it is still impossible to evaluate the entire genome all at once. What has emerged is a need to have rapidly customizable microarrays. There are two dominant methods to accomplish custom microarray synthesis, Affymetrix-like microarrays manufactured using light projection rather than semiconductor-like masks used by Affymetrix to mass manufacture their GeneChip/sup TM/ arrays now, or the ink-jet printing method employed by Agilent. The manufacture of these custom Affymetrix-like microarrays can now be done on a digital optical chemistry (DOC) machine developed at the University of Texas Southwestern Medical Center, and this method offers much higher feature numbers and feature density than is possible with ink-jet printed arrays. On a microarray, each feature contains a single genetic measurement. The initial DOC prototype has been described in several publications, but that has now led to a second-generation machine. This machine reliably produces a number of arrays daily, has been deployed against a number of biomedical questions, is being used in new ways and has also led to a number of spin-off technologies.