Morphological and crystallographic features of γ-γ′ Ni-Al and Ni-Al-Ti two-phase bicrystals

Several- Ni-Al and Ni-Al-Ti two-phase bicrystals were made by the solid-state diffusion couple method. Each couple consisted of a-phase single crystal and a pure-Ni polycrystal, and was annealed at 1473 K in an Ar gas atmosphere. Single crystal layers of-phase with uniform thickness always grow into the parent-phase single crystals. The resultant/ interface has no voids or facets regardless of the orientation of interface and the chemical composition of the-phase. Porosity formation due to the Kirkendall effect is observed in the diffused region. Concentration profiles exhibit nearly constant gradients in-phase. The orientation relationship between both phases is found to be 001//001, that is, the-phase grows epitaxially along the crystal orientation of-phase.     

Size of plastic region owing to blunting of the precrack tip andJ lc value in several types of structural steels

In this study, a three-point bendJ _lc fracture-toughness test was carried out using four types of structural steels at room temperature. The values of (γ _p)V, which represent the width of the region where the voids are located just ahead of the crack tip, were measured by Beacham's method [9] with the help of a scanning electron microscope (SEM). The experimental (γ _p) values and the theoretical values obtained using the finite element method (FEM) or calculated fromK at initiation are in good agreement. It was found that there is a certain linear relationship between (γ _p)Vand the stretched zone width (SZW), and an experimental relationship betweenJ _lc andσ _flow·(γ _p)V which may be expressed by the following equation: $$J_{lc} = 44.1 + 0.35\sigma _{{\text{flow}}} \cdot (\gamma _{\text{p}} )V_c KJ$$ whereσ _flow is the average value of the yield stress and the ultimate tensile strength. (γ _p)V _c represents the critical value of (γ _p)V. The numerical constant 44.1 kJ m^?2 is considered to be aJ _lc value for brittle fracture of the material tested, according to the authors' previous results. It is possible to calculateJ _lc if (γ _p)V _c can be measured.     

Crystallite size distribution and the lattice distortions in highly γ-irradiated linear polyethylene

Crystallite size distributions and lattice distortions have been analysed for highly-irradiated linear polyethylene in the direction normal to 1 1 0 and 0 0 1 lattice planes through X-ray line profile analysis. It has been found that the lateral crystallite size is little affected irradiation greater than 1000 Mrad, whereas that in the chain direction decreases almost linearly with the dose of irradiation. A minor difference in the crystallite size between irradiation atmospheres, i.e. irradiation in air or in vacuum, has been disclosed at a very high dose of irradiation. The above degradation behaviour of crystallites and the change in lattice distortions have proved that radiation cross-links are mainly formed in the amorphous region near the lamellar surface of polyethylene.     

A facile synthesis of hydro- and vinyl-functionalized di- and tetrasiloxanes and polyaddition via hydrosilylation

Summary Hydro- and vinyl-bifunctionalized di- or tetrasiloxane were synthesized by degradative cleavage of functional cyclic siloxanes with methyllithium followed by quenching with a functional chlorosilane, or by ring-opening of hexamethylcyclotrisiloxane (D₃) by functional alkyllithium followed by quenching with a functional chlorosilane. These bifunctionalized siloxanes were used as monomers in polyaddition with transition metal catalysts.     

Formation of Zirconia Solid Solutions Containing Alumina Prepared by New Preparation Method

In the system ZrO₂–Al₂O₃, a new method for preparing ZrO₂ solid solutions from ZrCl₄ and AlCl₃ using hydrazine monohydrate is investigated. c -ZrO₂ solid solutions containing up to ∼40 mol% Al₂O₃ crystallize at low temperatures from amorphous materials. The formation mechanism is discussed from IR spectral data. The values of the lattice parameter α increase linearly from 0.5072 to 0.5105 nm with increasing Al₂O₃ content. At higher temperatures, transformation of the solid solutions proceeds as follows: c ( SS ) → t ( ss ) → t ( ss ) +α-Al₂O₃→ m +α-Al₂O₃. m -ZrO₂–α-Al₂O₃ composite ceramics are fabricated by hot isostatic pressing for 2 h at 1250°C and 196 MPa. Microstructures and mechanical properties are examined, in connection with increasing Al₂O₃ content.     

Measurements of gamma-ray emission probabilities of 241, 243Am and 239Np

Gamma-ray emission probabilities of ^{241, 243}Am and ²³⁹Np have been precisely measured with gamma- and alpha-ray spectroscopic methods. The activities of the samples were determined by measuring alpha particles using a Si semiconductor detector. Gamma rays emitted from the samples were measured with a planar type High-Purity Germanium (HPGe) detector. An efficiency curve of the HPGe detector was derived with uncertainties from 0.7% to 2.5% by combining measured efficiencies and Monte Carlo simulation. The gamma-ray emission probabilities for the major gamma rays of these nuclides were determined with uncertainties less than 1.2%.     

Experimental Evaluation of Characteristics of SR Motor Made of Permendur

A switched reluctance (SR) motor has a doubly salient pole structure. The performance of the SR motor strongly depends on the magnetic properties of the core material, since it consists only of an iron core and copper windings. This study experimentally evaluates the performance of an SR motor made of permendur (Fe–49% Co alloy), which has very high saturation flux density and low core loss. Two types of SR motors that have the same dimensions but different core materials are used: one motor is made of the conventional nonoriented Si steel, and the other is made of permendur. Comparison of the characteristics of the two motors shows that the performance of the permendur SR motor surpasses that of the conventional one in terms of output power and efficiency. © 2014 Wiley Periodicals, Inc. Electr Eng Jpn, 187(1): 51–57, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22431     

Laser Photolysis Study on Mechanism and Efficiency of Electron Transfer Between Fullerenes (C60 and C70) and Tetraselenafulvalenes

Abstract

Efficient electron-transfer reactions from three kind of tetraselenafulvalenes (TSeF's) to photoexcited triplet state of C₆₀ or C₇₀ in polar solvents have been confirmed by transient absorption spectroscopy observing the decay of ³C₆₀*/³C₇₀* and rise of C₆₀ ^??/C₇₀ ^??. Growth of single crystal seems to be stimulated by laser irradiation of the solution containing C₆₀ and bis(ethylenedithio)tetraselena-fulvalene (BEDT-TSeF), in which C₆₀ ^?? was effectively formed.