用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

1.48μm掺饵光纤放大器泵源

采用Ｐ型ＩｎＰ衬底新月型结构制备了１．４８μｍ大功率激光器，该激光器与单模光纤耦合输出功率大于４０ｍＷ。     

流动微量量热法研究阴离子表面活性剂在油砂表面的吸附

用流动微量量热法研究了十二烷基硫酸钠(SDDS)和十二碳羧酸钠(SL)在克拉玛依油田九区和乌尔禾区油砂上的吸附,简要地计论了吸附机理。所得实验结果表明,SL 在油砂上的吸附强度比 SDDS 的要大,在相当低的浓度下即可迟到饱和吸附。     

糖化酶制剂辐照性能研究

研究了工业糖化酶制剂经辐照处理后各项性能的变化。结果表明,经2kGy以下剂量的γ射线处理后,可提高其贮存稳定性,改善卫生品质,不影响其正常使用。     

Non-steady-state model for kinetics of free radical polymerization, 4. Direct thermal initiation

This paper deals with the non-steady-state kinetics of direct thermal initiated polymerization. The initiation is assumed to be a bimolecular reaction of the monomer. The relationship between the radical concentration and the monomer conversion is rigorously derived. In further treatment a few very close approximations are introduced based on the fact that the number of monomer molecules reacting in the initiation step is much less than that consumed in the propagation step for a process producing high polymer, and the value of the rate constant for propagation or chain transfer is much lower than that for chain termination. Expressions for various molecular parameters, such as molecular weight distribution, number-average and weight-average degrees of polymerization, and dispersity, are given. Several numerical examples are provided.     

稀土混合物水溶液中囊泡的形成

依据柠檬酸的螯合作用和乙二醇的空间位阻效应，获得了稀土混合物囊泡。并利用ＩＣＰ、ＴＥＭ、ＦＳ等仪器对囊泡的性能进行了研究，最后对囊泡的形成机理进行了讨论。     

1，2─双（二乙基膦基）乙烷的合成

以二乙基氯化膦为原料，经乙炔化及加氢两步合成了１，２－双（二乙基膦基）乙烷，产率超过文献值。用红外光谱和核磁共振波谱分别测定了结构。     

Preparation of nanosized titania powder via the controlled hydrolysis of titanium alkoxide

By controlling the hydrolysis of titanium butoxide, followed with or without an ethanol washing process, the preparation of nanoscale titania powder was studied in detail. The characteristics of different powders produced by the direct precipitation (without an ethanol wash) and ethanol wash processes were studied by X-ray diffraction, transmission electron microscopy, BET, thermogravimetry and differential thermal analysis techniques. By comparison, it was found that both the direct precipitation and ethanol wash methods can obtain slightly agglomerated nanoscale titania powders of less than 15 nm, but the ethanol wash can further reduce the agglomeration. The particle sizes of titania powders can be modified while still retaining the anatase structure.