Comparisons Between the p--q and p--q--r Theories in Three-Phase Four-Wire Systems

This paper presents a comparative analysis between results from applications of the p-q and the p-q-r theories in shunt active power filters for three-phase four-wire systems, discussing aspects related to the influence of the system voltage in the control methods that calculate the compensating currents. It is shown that in some cases, a preprocessing of the system voltage is required if the goal is to achieve sinusoidal compensated currents. On the other hand, when the goal is to compensate zero-sequence current, the need of energy storage elements in the active filter is discussed. In this case, if zero-sequence components are present simultaneously in the system voltage and load current, they produce zero-sequence power flow, and the control methods based on both theories must contain additional calculations to allow the elimination of energy storage elements in the active filter. A control strategy based on the p-q theory is proposed to eliminate the neutral current without the need of energy storage elements, with the advantage of avoiding the extra transformation from alphabeta0 to pqr coordinates that is needed in the p-q-r theory. Simulation results are presented for the purpose of comparing the performance of both control methods.     

Probiotics: An alternative strategy for combating salmonellosis: Immune mechanisms involved

Salmonella produces infections of different nature and severity depending of many factors including the Salmonella serovar involved, strain virulence, infective dose, host animal species, age and immune status of the host. The treatments against Salmonella infections rely on supportive and antibiotic therapy to eliminate the pathogen, but the development of resistance by Salmonella to the antimicrobials most commonly used limits its efficacy. Other disadvantages of antibiotic treatments are that they can lead to acute diarrhea (antimicrobials normally induce an imbalance of intestinal bacterial flora) and may produce chronic toxicity. Considering this undesired consequences of antibiotics and because at the present there are no effective oral vaccines which protect against salmonellosis, scientists have been searching for alternative methods to control enteric infections. In the present review, probiotics are proposed as an attractive possibility to attend this concern. Probiotic are live microorganisms, which when administered in adequate amounts confer a health benefit on the host. In vitro and in vivo studies showed the effectiveness of probiotic administration in the prevention or in the treatment against Salmonella infection. There are several mechanisms by which probiotic strains might exert their effects. They include non immune mechanisms (stabilization of the gut mucosal barrier, competition for adhesion, secretion of antimicrobial substances, etc.) and the modulation of the mucosal and systemic immune responses. These mechanisms are species and/or strain specific. There are also evidences that in some cases, a mix of probiotic strains can be more useful than each strain alone against this infection. In addition, the presence of one or more probiotic strains in a fermented product can improve the beneficial properties of the probiotic strains involved. It was also reviewed the security of probiotics administration after Salmonella infection in healthy host and in immunosuppressed or babies hosts. Although, the major part of the researches were performed in animal models through in vivo assays or by in vitro studies using human cell lines, some studies carried out in humans to verify the probiotic effects were also addressed in the present review. Nevertheless, is of critical importance to perform more clinical trials in humans to validate the results obtained with each specific probiotic strain or probiotic product.     

Learning material defect patterns by separating mixtures of independent component analyzers from NDT sonic signals

This paper introduces the application of independent component analysis mixture modelling (ICAMM) in non-destructive testing (NDT). The application consists of discriminating patterns for material quality control from homogeneous and defective materials inspected by impact-echo testing. This problem is modelled as a mixture of independent component analysis (ICA) models, representing a class of defective or homogeneous material by an ICA model whose parameters are learned from the impact-echo signal spectrum. These parameters define a kind of particular signature for the different defects. The proposed procedure is intended to exploit to the maximum the information obtained with the cost efficiency of only a single impact. To illustrate this capability, four levels of classification detail (material condition, kind of defect, defect orientation, and defect dimension) are defined, with the lowest level of detail having up to 12 classes. The results from several 3D finite element models and lab specimens of an aluminium alloy that contain defects of different shapes and sizes in different locations are included. The performance of the classification by ICA mixtures is compared with linear discriminant analysis (LDA) and with multi-layer perceptron (MLP) classification. We demonstrate that the mass spectra from impact-echo testing fit ICAMM, and we also show the feasibility of ICAMM to contribute in NDT applications.     

Impurity effects in neutron-irradiated simple oxides: Implications for fusion devices

Radiation damage induced by neutron irradiation was studied in undoped MgO crystals and in MgO doped with either iron, hydrogen or lithium impurities. The oxygen-vacancy concentration produced by irradiation increases with neutron fluence. The net production rates resulting from irradiations with 14.8 MeV neutrons are about twice those produced by fission neutrons.

In nominally pure crystals, the oxygen-vacancy concentration incurred by the fission-neutron irradiation is higher in crystals with a larger number of inherent impurities (such as iron) due to trapping of interstitials by impurities. Suppression of these defects is observed in MgO:H crystals and attributed to migration of oxygen vacancies to microcavities filled with H₂ gas. In MgO:Li crystals irradiated with neutron fluences below 10¹⁸ n/cm², most of the oxygen vacancies are camouflaged as hydride ions. Nanoindentation experiments show that hardness increases with neutron fluence and is independent of the presence of lithium in the crystal. Comparison between a neutron-irradiated and a thermochemically reduced crystal containing similar concentrations of oxygen vacancies shows that 70% of the neutron-irradiation hardening is produced by interstitials, 30% by oxygen vacancies and a negligible amount by higher-order point defects.     

System to measure the use of the backrest in sitting-posture office tasks

This paper presents an inexpensive and simple system to measure the way of use of the backrest. The system can be also used in field studies. It is based on a set of electrodes which, attached to the subject's back and the backrest, allows the contact area to be measured. A laboratory test was performed to validate the system. In the test the spontaneous use of the backrest in standard office chairs and tasks was studied. Four different types of backrest use have been detected, and it has been shown that they determine the lumbar curvature and pelvic inclination angles, as well as postural mobility. The comfort levels observed in the four types of backrest use were also different. Consequently, the system can be used as an indicator of back posture and comfort.     

Anatomic basis of continuous axillary block of the brachial plexus with thoracic reservoir

Although continuous axillary block is effective for periods of up to four to six weeks, pain clinic patients with severe chronic pain in the upper extremities, mainly resulting from neuropathic disease, can require continuous drug delivery by catheter-reservoir for up to three months or longer. We studied possible locations for implanting reservoirs or catheters from the perivascular axillary space in fresh cadavers, checking for possible vascular or nerve damage after applying the usual technique for reservoir implantation. The ideal location for the reservoir is the subcutaneous tissue of the homolateral infraclavicular space of the anterior side of the thorax. The customary procedures for inserting the catheter along the subcutaneous route that extends from the perivascular axillary space to the reservoir carry no risk of damaging vascular or nerve structures.     

Adaptability of sweet corn ears to a frozen process

The effects of frozen condition on the quality of three sweet corn ears (2038, 2010, 2004) and the pattern (Bonanza), were evaluated. Biometrics characteristics like ear size, ear diameter, row and kernel deep were measured as well as chemical and physical measurement in fresh and frozen states. The corn ears were frozen at -95 degrees C by 7 minutes. The yield and stability of the frozen ears were evaluated at 45 and 90 days of frozen storage (-18 degrees C). The average commercial yield as frozen corn ear for all the hybrids was 54.2%. The industry has a similar value range of 48% to 54%. The ear size average was 21.57 cm, row number was 15, ear diameter 45.54 mm and the kernel corn deep was 8.57 mm. All these measurements were found not different from commercial values found for the industry. All corn samples evaluated showed good stability despites the frozen processing and storage. Hybrid 2038 ranked higher in quality.     

Chemical changes induced on a TiO2 surface by electron bombardment

We study the TiO₂ (Ti⁴⁺) chemical reduction induced by electron bombardment using Auger electron spectroscopy and factor analysis. We show that the electron irradiation of a TiO₂ sample is characterized by the appearance of a lower Ti oxidation state, Ti₂O₃ (Ti³⁺), followed by a further deposition of carbon, which is present inevitably in the environment even under ultra-high vacuum conditions. The appearance of C over the surface is found to be a complex mechanism which affects the reduction process through passivation of the electron-induced oxygen desorption and formation of titanium carbide. For very high irradiation doses, we also found that the chemical changes on the surface are stopped due to the deposition of carbon in a graphitic form.     

Microbial and enzymatic stability of fruit juice-milk beverages treated by high intensity pulsed electric fields or heat during refrigerated storage

The influence of high intensity pulsed electric fields (HIPEF) treatment (35 kV/cm, bipolar 4 μs square wave pulses at 200 Hz) on the inactivation of Listeria innocua in fruit juice–whole (FJ–WM) or skim milk (FJ–SM) beverages was assessed. As well, the effects of HIPEF or conventional thermal (90 °C 60 s) processing in terms of microbial and enzymatic stability and changes on physicochemical parameters of the beverages during refrigerated storage were also studied. HIPEF and thermal processing ensured the microbial stability of the beverages during 56 days at 4 °C without significant changes on pH, acidity and soluble solid content values. Thermal processing was more effective than HIPEF in reducing Pectin Methyl Esterase (PME) activity in FJ–SM and FJ–WM beverages since its activity was reduced by 70.66% and 87.33%, respectively. With regards to Polygalacturonase (PG), HIPEF treatment reduced by 26.92% and 20.93% the enzyme activity in the FJ–WM and FJ–SM beverages, respectively, whereas thermal treatment did not inactivate PG in both beverages. HIPEF or thermally-treated samples showed higher viscosity than the untreated ones, being this increment more pronounced in the beverages with whole milk. Therefore, HIPEF processing may be a feasible technology in order to obtain shelf stable and fresh-like fruit juice-milk beverages.