Interactions between soil texture and placement of dairy slurry application: II. Leaching of phosphorus forms

Managing phosphorus (P) losses in soil leachate folllowing land application of manure is key to curbing eutrophication in many regions. We compared P leaching from columns of variably textured, intact soils (20 cm diam., 20 cm high) subjected to surface application or injection of dairy cattle (Bos taurus L.) manure slurry. Surface application of slurry increased P leaching losses relative to baseline losses, but losses declined with increasing active flow volume. After elution of one pore volume, leaching averaged 0.54 kg P ha(-1) from the loam, 0.38 kg P ha(-1) from the sandy loam, and 0.22 kg P ha(-1) from the loamy sand following surface application. Injection decreased leaching of all P forms compared with surface application by an average of 0.26 kg P ha(-1) in loam and 0.23 kg P ha(-1) in sandy loam, but only by 0.03 kg P ha(-1) in loamy sand. Lower leaching losses were attributed to physical retention of particulate P and dissolved organic P, caused by placing slurry away from active flow paths in the fine-textured soil columns, as well as to chemical retention of dissolved inorganic P, caused by better contact between slurry P and soil adsorption sites. Dissolved organic P was less retained in soil after slurry application than other P forms. On these soils with low to intermediate P status, slurry injection lowered P leaching losses from clay-rich soil, but not from the sandy soils, highlighting the importance of soil texture in manageing P losses following slurry application.     

Interactions between soil texture and placement of dairy slurry application: I. Flow characteristics and leaching of nonreactive components

Land application of manure can exacerbate nutrient and contaminant transfers to the aquatic environment. This study examined the effect of injecting a dairy cattle (Bostaurus L.) manure slurry on mobilization and leaching of dissolved, nonreactive slurry components across a range of agricultural soils. We compared leaching of slurry-applied bromide through intact soil columns (20 cm diam., 20 cm high) of differing textures following surface application or injection of slurry. The volumetric fraction of soil pores >30 microm ranged from 43% in a loamy sand to 28% in a sandy loam and 15% in a loam-textured soil. Smaller active flow volumes and higher proportions of preferential flow were observed with increasing soil clay content. Injection of slurry in the loam soil significantly enhanced diffusion of applied bromide into the large fraction of small pores compared with surface application. The resulting physical protection against leaching of bromide was reflected by 60.2% of the bromide tracer was recovered in the effluent after injection, compared with 80.6% recovery after surface application. No effect of slurry injection was observed in the loamy sand and sandy loam soils. Our findings point to soil texture as an important factor influencing leaching of dissolved, nonreactive slurry components in soils amended with manure slurry.     

Predicting phosphorus losses with the PLEASE model on a local scale in Denmark and the Netherlands

To reduce losses from agricultural soils to surface water, mitigation options have to be implemented as a local scale. For a cost-effective implementation of these measures, an instrument to identify critical areas for P leaching is indispensable. In many countries, P-index methods are used to identify areas as risk for P losses to surface water. In flat areas, where losses by leaching are dominant, these methods have their limitations because leaching is often not described in detail, PLEASE, is a simple mechanistic model designed to stimulate P Losses by leaching at the field scale using a limited amount of local field data. In this study, PLEASE, was applied to 17 lowland sites in Denmark and 14 lowland sites in the Netherlands. Results show that the simple model simulated measured fluxes and concentrations in water from pipe drains, suction cups, and groundwater quite well. The modeling efficiency ranged from 0.92 for modeling total-P fluxes to 0.36 fr modeling concentrations in groundwater. Poor results were obtained for heavy clay soils and eutrophic peat soils, where fluxes and concentration were strongly underestimated by the model. The poot performance for the heavy clay soil can be explained by the transport of P through macropores to the drain pipes and the underestimation of overland flow on this heavy-textured soil. In the eutrophic peat soils, fluxes were underestimated due to the release of P from deep soil layers.     

Mitigation of methane emission from Fakse landfill using a biowindow system

Landfills are significant sources of atmospheric methane (CH₄) that contributes to climate change, and therefore there is a need to reduce CH₄ emissions from landfills. A promising cost efficient technology is to integrate compost into landfill covers (so-called “biocovers”) to enhance biological oxidation of CH₄. A full scale biocover system to reduce CH₄ emissions was installed at Fakse landfill, Denmark using composted yard waste as active material supporting CH₄ oxidation. Ten biowindows with a total area of 5000 m² were integrated into the existing cover at the 12 ha site. To increase CH₄ load to the biowindows, leachate wells were capped, and clay was added to slopes at the site. Point measurements using flux chambers suggested in most cases that almost all CH₄ was oxidized, but more detailed studies on emissions from the site after installation of the biocover as well as measurements of total CH₄ emissions showed that a significant portion of the emission quantified in the baseline study continued unabated from the site. Total emission measurements suggested a reduction in CH₄ emission of approximately 28% at the end of the one year monitoring period. This was supported by analysis of stable carbon isotopes which showed an increase in oxidation efficiency from 16% to 41%. The project documented that integrating approaches such a whole landfill emission measurements using tracer techniques or stable carbon isotope measurements of ambient air samples are needed to document CH₄ mitigation efficiencies of biocover systems. The study also revealed that there still exist several challenges to better optimize the functionality. The most important challenges are to control gas flow and evenly distribute the gas into the biocovers.     

Stewardship to tackle global phosphorus inefficiency: The case of Europe

The inefficient use of phosphorus (P) in the food chain is a threat to the global aquatic environment and the health and well-being of citizens, and it is depleting an essential finite natural resource critical for future food security and ecosystem function. We outline a strategic framework of 5R stewardship (Re-align P inputs, Reduce P losses, Recycle P in bioresources, Recover P in wastes, and Redefine P in food systems) to help identify and deliver a range of integrated, cost-effective, and feasible technological innovations to improve P use efficiency in society and reduce Europe’s dependence on P imports. Their combined adoption facilitated by interactive policies, co-operation between upstream and downstream stakeholders (researchers, investors, producers, distributors, and consumers), and more harmonized approaches to P accounting would maximize the resource and environmental benefits and help deliver a more competitive, circular, and sustainable European economy. The case of Europe provides a blueprint for global P stewardship.     

Leaching of pesticides through normal-tillage and low-tillage soil--a lysimeter study. II. Glyphosate

Glyphosate is a widely used non-selective herbicide. Leaching of glyphosate (N-(phosphonomethyl)glycine) and/or its metabolite AMPA (aminomethylphosphonic acid) was studied in four lysimeters, two of them being replicates from a low-tillage field (lysimeter 3 and 4), the other two being replicates from a normal tillage field (lysimeter 5 and 6). In both cases the soil was a sandy loam soil with 13-14% clay. The lysimeters had a surface area of 0.5 m2 and a depth of 110 cm. Lysimeter 3 and 4 were sprayed with a mixture of 14C-labelled glyphosate and unlabelled glyphosate, while lysimeter 5 and 6 were sprayed with unlabelled glyphosate. The spraying took place September 18, 1997. The total amount of glyphosate sprayed onto each lysimeter was 40 mg, corresponding to 0.8 kg active ingredient per ha. The lysimeters were installed in an outdoor system in Research Centre Flakkebjerg and were thus exposed to normal climatic conditions of the area. A mean of 260 l drainage water were collected from lysimeter 3 and 4 and a mean of 375 litres from lysimeter 5 and 6. The mean yearly concentration of leached glyphosate and/or AMPA was significantly below 0.1 microg/l from both sets of lysimeters, and thus no significant difference between the two lysimeter sets was shown. However, in both sets of lysimeters several single findings at concentrations above 0.1 microg/l was seen, which might be due to the leaching of particle-bound compounds. A significant difference between the soil residual concencentrations of AMPA was seen, the higher concentration was found in the set of lysimeter where low-tillage had been practiced and where Round Up had been used several times in the years before sampling of the lysimeter soil.     

Bacterial antibiotic resistance levels in Danish farmland as a result of treatment with pig manure slurry

Resistance to tetracycline, macrolides and streptomycin was measured for a period of 8 months in soil bacteria obtained from farmland treated with pig manure slurry. This was done by spread plating bacteria on selective media (Luria Bertani (LB) medium supplemented with antibiotics). To account for seasonal variations in numbers of soil bacteria, ratios of resistant bacteria divided by total count on nonselective plates were calculated. Soil samples were collected from four different farms and from a control soil on a fifth farm. The control soil was not amended with animal manure. The occurrence of tetracycline-resistant bacteria was elevated after spread of pig manure slurry but declined throughout the sampling period to a level corresponding to the control soil. Higher load of pig manure slurry yielded higher occurrence of tetracycline resistance after spreading; however, the tetracycline resistance declined to normal occurrence defined by the tetracycline resistance occurrence in the control soil. Concentrations of tetracycline in soil and in pig manure slurry were measured using HPLC. No tetracycline exceeding the detection limit was found in soil samples. Manure slurry concentrations of tetracycline for three of the farms were 42, 81 and 698 microg/l, respectively. For streptomycin and macrolides, only minor variations in resistance levels were detected. Results obtained in this study thus indicate that tetracycline resistance levels in soil are temporarily influenced by the addition of pig manure slurry. The results indicate also that increased amount of pig manure slurry amendment may result in increased levels of tetracycline resistance in the soil.     

Availability and properties of materials for the Fakse Landfill biocover

Methane produced in landfills can be oxidized in landfill covers made of compost; often called biocovers. Compost materials originating from seven different sources were characterized to determine their methane-oxidizing capacity and suitability for use in a full-scale biocover at Fakse Landfill in Denmark. Methane oxidation rates were determined in batch incubations. Based on material availability, characteristics, and the results of batch incubations, five of the seven materials were selected for further testing in column incubations. Three of the best performing materials showed comparable average methane oxidation rates: screened garden waste compost, sewage sludge compost, and an unscreened 4-year old garden waste compost (120, 112, and 108 g m⁻² d⁻¹, respectively). On the basis of these results, material availability and cost, the unscreened garden waste compost was determined to be the optimal material for the biocover. Comparing the results to criteria given in the literature it was found that the C/N ratio was the best indicator of the methane oxidation capacity of compost materials. The results of this work indicate that batch incubations measuring methane oxidation rates offer a low-cost and effective method for comparing compost sources for suitability of use in landfill biocovers.     

Alpha-fetoprotein and acetylcholinesterase activity in first-and early second-trimester amniotic fluid

Normal ranges of amniotic fluid alpha-fetoprotein (AFP) and acetylcholinesterase activity (AChE) are described for gestational weeks 11–14 using rocket gel immunoelectrophoresis for AFP quantitation and a monoclonal antibody (4F19) enzyme antigen immunoassay for AChE activity measurement. The normal ranges were established by the examination of 281 amniotic fluid samples from 281 normal pregnancies. AFP was found to increase from a median level of 14.0 MIU/1 at 11 weeks to a maximum at 13 weeks (median=18.0 MIU/l) (P<0.05), thereafter falling (not significant). No AChE test result exceeded 4.8 nkat/l. In addition, AFP and AChE values for three cases of fetal malformation, identified by the biochemical analyses of amniotic fluid, are given. These cases included two fetuses with a neural tube defect and one fetus with an abdominal wall defect. Amniocentesis was performed at 10, 11, and 14 weeks, respectively. The AFP and AChE values were all high.     

An inventory of tree species in Europe—An essential data input for air pollution modelling

We present a detailed tree species inventory covering Europe, parts of Africa and parts of Asia. The inventory contains 39 groups of species that are important for biogenic VOCs or pollen emission calculations. For example: oak (Quercus), poplar (Populus), pines (Pinus), spruce (Picea), birch (Betula) and alder (Alnus). The inventory is based on national forest inventories and national statistics and gives tree species distribution in percentage within broadleaved as well as conifer forests. The inventory includes data from 799 regions and is redistributed into the 50 km × 50 km EMEP grid. The inventory is therefore prepared for easy implementation into atmospheric transport models by providing an extension to already applied land use data such as the Corine Land Cover (CLC2000) or Global Land Cover (GLC2000). The gridded version of the data set will be available on the webpage http://www.dmu.dk/International/Air/Models/Background/Trees/.