Photodegradation of tetraphenyltin contained in polychlorinated biphenyl-based transformer oil simulants in alkaline 2-propanol solution

The photodegradation of tetraphenyltin (TePT) contained in polychlorinated biphenyl (PCB)-based transformer oil simulants by ultraviolet (UV) irradiation in alkaline 2-propanol solutions was examined. In the absence of PCBs, the TePT level fell to below 1% of the initial concentration within 30 min. In the absence of both PCBs and an alkali, the concentrations of tri-, di-, and monophenyltins initially increased to a few milligrams per liter, and then reduced to below the detection limits within 90 min. The addition of an alkali to the reaction solution slightly accelerated the photodecomposition of TePT. The decomposition of other phenyltins (PTs) was also accelerated. When PCBs with concentrations of approximately 80 times the initial TePT concentration were added, only a small fraction of the TePT decomposed within 100 min. Moreover, the levels of PTs did not change during irradiation. TePT and other PTs did decompose when the level of PCBs was reduced to the same concentration as that of TePT; however, the decomposition rates were slower than those in the absence of PCBs. In the actual treatment process, TePT and other PTs in PCB-based transformer oil are decomposed by catalytic reduction, which is used after UV irradiation. Therefore, in the actual treatment of PCB-based transformer oil wastes, pollution due to PTs can be prevented.     

Supercritical water gasification of sewage sludge using bench-scale batch reactor: advantages and drawbacks

Sewage sludge, a byproduct of municipal wastewater treatment, was gasified by supercritical water using a bench-scale batch reactor. Configuration of bench-scale batch reactor and operation procedures are discussed in detail. Experience and challenges that arose during the experiment are also shared. Using the bench-scale reactor under the condition of 600 °C, 23 MPa, and a reaction time of 60 min without catalyst presence, a total gas yield of 9.8 mol/(kg-sewage sludge) was obtained. Furthermore, investigations on operational parameters were conducted. Extension of reaction time up to 60 min increased the gasification, reaching a plateau thereafter. Investigation on pressure indicated the superiority of supercritical pressure. The addition of Ni as a catalyst also promoted gasification, although inorganic salts and char seemed to cover the catalyst surface. With regard to the prospect of future operation at a municipal waste water treatment plant, the effect of operational parameters on heavy metal concentration in the liquid phase is also discussed.     

Seasonal variations in 228Ra/226Ra ratio within coastal waters of the Sea of Japan: implications for water circulation patterns in coastal areas

In this study, low-background gamma-spectrometry was used to determine the (228)Ra/(226)Ra ratio of 131 coastal water samples from various environments around Honshu Island, Japan (mainly around Noto Peninsula) at 1-3 month intervals from April 2003 until September 2005. Spatial variation in (228)Ra/(226)Ra ratios was also assessed by analyzing 34 coastal water samples from five areas within the Sea of Japan during May and June 2004. The (228)Ra/(226)Ra ratio of coastal water from all sites around Noto Peninsula shows seasonal variation, with minimum values during summer ((228)Ra/(226)Ra=0.7) and maximum values during autumn-winter ((228)Ra/(226)Ra=1.7-2). This seasonal variation is similar to that recorded for coastal water between Tsushima Strait and Noto Peninsula. The measured lateral variation in (228)Ra/(226)Ra ratios within coastal water between Tsushima Strait and Noto Peninsula is only minor (0.5-0.7; May-June 2004). Coastal waters from two other sites (Pacific shore and Tsugaru Strait, north Honshu) show no clear seasonal variation in (228)Ra/(226)Ra ratio. These measured variations in (228)Ra/(226)Ra ratio, especially the temporal variations, have important implications for seasonal changes in patterns of coastal water circulation within the Sea of Japan.     

PCDD/PCDF formation in the chlor-alkali process—laboratory study and comparison with patterns from contaminated sites

Studies on the formation of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) during the electrolysis of sodium chloride solution (brine) using graphite or titanium electrodes were carried out at a laboratory scale. High concentrations of PCDFs but no PCDDs were formed in tests using graphite electrodes. With titanium electrodes, PCDFs were only formed when tar pitch was added and mainly originated from the dibenzofuran present in the tar. For the first time, a detailed assessment of the formation of mono- to octachlorinated PCDD/PCDF from tar pitch was investigated. The assessment included of the chlorination steps proved that PCDFs were formed by successive lateral chlorinated from dibenzofuran to MonoCDFs, DiCDFs, and TriCDFs to form the typical known “chlorine pattern” of TetraCDF to OctaCDF with a dominance of 1,2,7,8- and 2,3,7,8-TetraCDFs, 1,2,3,7,8-PentaCDF, and 1,2,3,4,7,8-HexaCDF as marker congeners. The final homologue distributions depended on reaction time and reaction temperature. In addition, electrolysis with non-chlorinated dibenzo-p-dioxins, dibenzofuran, and biphenyl was carried out. As a result, PCDDs, PCDFs, and PCB were formed at comparable yields. Congener patterns in soil samples from a PCDD/F-contaminated site where chlor-alkali electrolysis had been operated for decades in Japan had identical isomer distribution demonstrating the source and contamination potential and risk of these processes. Therefore, sites where in the past 120 years chlor-alkali electrolysis has been operated or where residues from chlor-alkali production or other chlorine using industries have been disposed should be assessed for their pollution level and exposure relevance. The assessment of total organohalogen content revealed that PCDF is only a small fraction of organohalogens in the contaminated soils. For an appropriate risk assessment, also other chlorinated aromatic compounds such as PCBs or PCNs need to be considered.     

Seasonal effect on N2O formation in nitrification in constructed wetlands

Constructed wetlands are considered to be important sources of nitrous oxide (N(2)O). In order to investigate the contribution of nitrification in N(2)O formation, some environmental factors, plant species and ammonia-oxidizing bacteria (AOB) in active layers have been compared. Vegetation cells indicated remarkable effect of seasons and different plant species on N(2)O emission and AOB amount. Nitrous oxide data showed large temporal and spatial fluctuations ranging 0-52.8 mg N(2)O m(-2)d(-1). Higher AOB amount and N(2)O flux rate were observed in the Zizania latifolia cell, reflecting high potential of global warming. Roles of plants as ecosystem engineers are summarized with rhizosphere oxygen release and organic matter transportation to affect nitrogen transformation. The Phragmites australis cell contributed to keeping high T-N removal performance and lower N(2)O emission. The distribution of AOB also supported this result. Statistical analysis showed several environmental parameters affecting the strength of observed greenhouse gases emission, such as water temperature, water level, TOC, plant species and plant cover.     

Assessing the probability of land submergence for lowland rice cultivation in Africa using satellite imagery and geospatial data

Sub-Saharan African countries are being strongly urged to enhance their rice production, because their rice consumption and importation rates have been rapidly increasing in recent years. Areas planted to rice in Africa are classified agro-ecologically into rainfed upland, rainfed lowland, and irrigated. Rainfed lowland includes extensive areas of unexploited land that has great potential for the promotion of rice growing. For the unexploited rainfed lowlands of Ghana, we have been studying the development of low-cost rice-farming systems that require no large-scale irrigation or land reclamation. For such systems, it is important to select suitable areas where water for rice farming can be obtained naturally; floodwaters offer promise for this purpose. Delineation and mapping of floodwater prone areas suitable for rice production is important for successful utilization of this land resource. Here, we propose a method of assessing flood probability from submergence frequency, as estimated from satellite imagery and geospatial data. ALOS/PALSAR images acquired in May, June, August, and September 2010 were used to classify land and water, and then a submerged-area map was produced. From the results, we were able to accurately detect non-submerged areas and submerged areas with water depths of at least 3?cm. The number of times classified into submerged area was defined as submergence frequency, and it was approximated by distance from reservoirs representing White Volta River, ponds, and swamps. In addition, flood extent derived from reservoirs was simulated using digital elevation model (DEM). Finally, a flood probability assessment map was produced by integration of the estimated submergence frequency and flood extent simulation. The results of a comparison of soil moisture data measured at 69 points in the field and the NDVIs computed by ALOS/AVNIR showed that areas with high potential for flooding retained high levels of soil moisture and were more likely to show less deterioration of vegetation in the dry season. The validation of these results confirmed the adequacy of the flood probability assessment method.     

Microwave-assisted synthesis of biodegradable and antibacterial thiophene,furan and thiazole derivatives

Environmental Chemistry Letters - The rise of bacterial resistance to common clinical antibiotics is calling for alternative techniques to synthesize antibacterial drugs with high biodegradability....     

Liquefaction process for a hydrothermally treated waste mixture containing plastics

Most landfilled plastic waste is a mixture or is in the form of composites with incombustible wastes such as glass, metals, and ceramics. After hydrothermal treatment, including a steam-explosion process, the separation of mixed waste (MW) into organic and inorganic substances becomes easy. However, the effect of hydrothermal pretreatment on the subsequent liquefaction of organic substances from MW is not obvious. In this study, the effects on the liquefaction of polystyrene and high-density polyethylene are discussed. Moreover, optimum conditions for the liquefaction of organic substances from hydrothermally treated MW are identified. By means of this hydrothermal pretreatment, including the steam-explosion process, polystyrene and high-density polyethylene can be significantly converted to oil by liquefaction at 300°–400°C. In comparison with liquefaction of hydrothermally pretreated mixed waste (HMW) at 300°–400°C with a batch type reactor, the yield of oil increases significantly on liquefaction using a semi-batch type reactor. It is considered that the radical chain and termination reactions among the radicals from HMW were inhibited in the semi-batch type reactor. On liquefaction of HMW in a semi-batch reactor, the conversion of HMW to oil was enhanced on increasing the liquefaction temperature to 350°C and the holding time to 60 min. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

Classification of the sugarcane residues and their characteristics—an environmental assessment of mortar with addition of sugarcane residues

Journal of Material Cycles and Waste Management - The use of agro-residue in resource-limited regions can be a smart way for civil construction to reduce costs, reduce emissions of pollutant gases...