论伪距测量的多普勒效应

论述了多普勒效应对 GPS伪距测量的影响 ,建立了 GPS伪距测量多普勒改正的模型。研究表明 ,多普勒效应对伪距观测值的影响与伪距和伪距变化率的积成正比。伪距观测值的多普勒改正的符号与伪距变化率的符号相同。多普勒改正值在卫星升起和降落时最大 ,其最大值可达到 60 m左右 ;在卫星最高位置时最小 ,其值接近于 0。多普勒效应对伪距观测值的影响相对于卫星最高位呈负对称     

南海季风型海-气耦合模态的时空特征及其与中国夏季降水的关系

使用NCEP/NCAR的海表温度(SST)、海面10 m风场的月平均再分析资料,用联合SVD(CSVD)的方法研究了不同季节南海的海气耦合模的时空分布特征及其与中国夏季降水的关系。通过对不同季节的海-气耦合模的年际变化特征的分析。结果发现:第一模态为最显著模态,模态协方差贡献比在四季均超过80%,空间上SST表现为与南海等深线相一致的海盆模态,风场上主要表现为弱的冬季风或弱的夏季风,各个季节的海-气耦合模态都主要反映了SST-蒸发-风反馈这样1种正反馈的海-气相互作用过程,而且冬季风期间这种相互作用要更强烈些。时间系数均主要表现为一致的上升趋势和1976年前后的年代际突变,以及与ENSO相关的年际变化特征。冬、夏季弱的季风对应暖SST的特征体现了这种耦合模态隔季相关的特征,都对应夏季华南旱(涝)、江南涝(旱),华北、山东半岛旱(涝),东北涝(旱)这样1种波列状的旱涝相间分布。     

基于USB的远程控制系统实现地震灾害救助

基于USB的远程控制系统初步研究设计建立了一种救助模型。与传统生命探测仪的救助系统不同,USB的远程控制系统具有远程实时监控功能。系统的硬件主要由单片机控制电路、USB接口电路、无线收发模块构成。系统利用Internet与计算机互联,通过USB接口电路与单片机的连接,对多个目标检测和控制,实现在地震灾害中的呼叫救助。     

Selection of hazardous waste dumpsites based on parameters effecting soil adsorption capacity – a case study

A careful selection of waste dumpsites, particularly hazardous ones, is very important for sustainable water resources management. Several laboratory experiments were carried out on the field samples to study adsorption capacity using p-dichlorobenzene (a solvent used in various industrial processes) as the test contaminant. The effect of parameters such as organic matter, clay, and iron and aluminium oxides, which are known to influence the soil adsorption capacity, are studied in the present work. Several soil samples from the Patancheru Industrial Area (Hyderabad, India) were collected and characterized. Only three soils, which had a comparatively high percentage of organic matter, clay, iron and aluminium oxide contents were used for the adsorption studies. The results clearly indicated a decrease in the adsorption capacity of the soils by as much as 75% when organic matter was removed. The other parameters such as clay and iron and aluminium oxides also play an important role in adsorption (57 and 39.8% reduction respectively). It was observed that out of the selected factors organic matter in the soils has the maximum effect regarding the adsorption of p-dichlorobenzene. Since the selected soils contain comparatively more organic matter, clay and iron and aluminium oxides in the selected industrial area, these can be used as sites for dumping hazardous waste, which can be further treated by methods like bioremediation.     

Enhanced bioremoval of refractory compounds from dyeing wastewater using optimized sequential anaerobic/aerobic process

The upflow anaerobic sludge blanket process followed by the biological aerated filter process was employed to improve the removal of color and recalcitrant compounds from real dyeing wastewater. The highest removal efficiency for color was observed in the anaerobic process, at 8-h hydraulic retention time, seeded with the sludge granule. In the subsequent aerobic process packed with the microbe-immobilized polyethylene glycol media, the removal efficiency for chemical oxygen demand increased significantly to 75 %, regardless of the empty bed contact time. The average influent non-biodegradable soluble chemical oxygen demand was 517 mg/L, and the average concentration in effluent from the anaerobic reactor was 363 mg/L, suggesting the removal of some recalcitrant matters together with the degradable ones. The average non-biodegradable soluble chemical oxygen demand in effluent from the aerobic reactor was 87, 93, and 118 mg/L, with the removal efficiency of 76, 74, and 67 %, at 24-, 12-, and 8-h empty bed contact time, respectively. The combined anaerobic sludge blanket and aerobic cell-entrapped process was effective to remove the refractory compounds from real dyeing wastewater as well as in reducing organic loading to meet the effluent discharge limits. This integrated process is considered an effective and economical treatment technology for dyeing wastewater.     

Effects of natural attenuation processes on groundwater contamination caused by abandoned waste sites in Berlin

The aim of this research project is to identify, characterize and quantify natural attenuation (NA) processes in groundwater affected by emissions of abandoned waste disposal sites in Berlin-Kladow/Gatow, Germany. It is part of the funding priority called KORA established by the Federal Ministry for Education and Research (BMBF) to explore the extent to which NA can be used for remedial purposes for varied forms of soil and groundwater contamination. Information on the emission behaviour of individual parameters is generated on the basis of hydrogeochemical comparison of 20 years old and new data. Using groundwater-modelling and CFC-analysis, information on the transport and retention of pollutants in groundwater is compiled. The microbial colonization of contaminated aquifers is characterized by molecular biological methods [polymerase chain reaction (PCR) and denaturing gradient gel electrophoresis (DGGE)] to differentiate between contaminated and not contaminated zones.     

利用催化动力学原理测定化探样中微量碘的含量

在HAc-NaAc形成的中性缓冲溶液体系中,利用碘的催化动力学原理,使N-N-四甲基-4-4-二氨基二苯甲烷与氯胺T的氧化反应,生成蓝色络合物来测定地探样中微量碘的含量。通过实验,最佳试剂加入量为8%的HAc溶液5mL,8%的Na2CO3溶液3mL,0.1%的N-N-四甲基-4-4-二氨基二苯甲烷溶液5mL所组成的溶液体系中,在加入0.1%的氯胺T1mL显色后,其测定结果准确度、精密度高,检出限低,测定化探样中微量碘时该方法可以推广应用。     

Iron isotopic analyses of geological reference materials on MC-ICP-MS with instrumental mass bias corrected by three independent methods

Here we report iron (Fe) isotopic data of three pure Fe solution standards (IRMM-014, GSB Fe, and NIST 3126a) and five widely used geological reference materials (RMs) from the United States Geological Survey and Geological Survey of Japan obtained on a Neptune Plus multi-collector–inductively coupled plasma–mass spectrometer (MC-ICP-MS) in our laboratory over the past 3 years. The instrumental mass bias was corrected by three independent methods: sample-standard bracketing (SSB), Ni doping?+?SSB, and ⁵⁷Fe–⁵⁸Fe double spike?+?SSB. Measurements reveal that both the Ni doping and double spike methods helped calibrate short-term fluctuations in mass bias. Collectively, almost all measurements of RMs yielded δ⁵⁶Fe within?±?0.05 of recommended values, provided that each sample was measured four times on MC-ICP-MS. For the first time, new recommended values for NIST SRM3126a are reported (δ⁵⁶Fe?=?0.363?±?0.006, 2SE, 95% CI; and δ⁵⁷Fe?=?0.534?±?0.010, 2SE).     

The effect of annealing on the luminescence decay-time of synthetic calcite:Mn

Calcite was synthesized by four methods, and the luminescence decay-time was measured for nine samples before and after heating hydrothermally in the temperature range 200–400°C. Decay-time data were collected between room temperature and approximately 15 K. The decay time at room temperature is approximately 50 ms, with little difference between a given calcite before and after hydrothermal treatment. The decay time at 15 K is always greater than at room temperature as the effect of thermal quenching diminishes. Differences in decay time before and after heating are more apparent at low temperature owing to this reduction in thermal quenching. The decay time decreased significantly in two samples, and an increase in decay time was observed in the remaining seven samples following heating. Among the latter group, the change in decay time was insignificant in three samples. The results are compared with previous data in which it was shown that the effect of heating is to increase the intensity of luminescence.     

The early Miocene (~25 Ma) volcanism in the northern Kyushu-Palau Ridge,enriched mantle source injection during rifting prior to the Shikoku backarc basin opening

The northern Kyushu-Palau Ridge (KPR), remnant conjugate arc of the Izu-Ogasawara (Bonin)-Mariana (IBM) active arc, is dominated by basalt-andesite except for the Komahashi-Daini Seamount where acidic plutonic rocks of 38 Ma were recovered. These mafic to intermediate volcanics are produced by the rifting volcanism in the proto-IBM arc associated with spreading of the Shikoku Basin. The HFSE and HREE contents and ratios of these volcanics indicate enriched source mantle composition compared to recent volcanic front. The LILE ratios exhibit similar characteristics to reararc volcanism of the recent Izu arc, and some enriched volcanics exhibit high abundance of sediment melt inputs. Based on these observations and compilations of the published data set, the replacement event of the wedge mantle under the IBM arc occurred two times. The first event occurred between 45 and 38 Ma, with Pacific type mantle being replaced by depleted Indian type mantle. The second event occurred between 36 and 25 Ma, enriched mantle flowed from reararc side. The slab component during the proto-IBM arc rifting was a similar characteristic to recent reararc volcanism of the Izu arc, and sediment melt added in a local area.