天然茶皂素的提取及泡沫性能

茶皂素是一种天然的表面活性剂 ,通过几种浸取剂的研究 ,表明 60 %甲醇溶液为最好浸取剂。浸取温度 40℃～ 50℃ ,浸取时间 4 5h左右。浸取的茶皂素与多种表面活性剂比较 ,说明它是一种发泡性好、泡沫稳定性优良的发泡剂     

S＆W超选择性裂解炉分区裂解探讨

介绍了S＆W超选择性裂解炉分区裂解改造的情况，包括分区裂解炉的运行情况、对后系统的影响、对产品收率的影响、投用过程存在的问题及处理。指出分区裂解能提高装置的生产能力，而产品的收率基本不变。     

十六烷基三甲基溴化铵活化催化合成香豆素

以无水碳酸钾为催化剂、十六烷基三甲基溴化铵(HTMAB)为活化剂，用水杨醛和醋酸酐为原料通过Perkin反应合成香豆素，研究了物料比、催化剂用量和HTMAB用量和反应近结束时保温时间对产率的影响。结果表明：用HTMAB为活化剂，可有效活化碱催化剂无水碳酸钾，提高了其碱性，与无HTMAB时相比，香豆素产率有较大提高，其最佳反应条件是n(水杨醛)：n(乙酸酐)：n(碳酸钾)：n（HTMAB)为1．00：3．00：0．25：0．03，反应温度185℃，反应近结束时保温3h，香豆素产率可达85．3％。     

悬浮污泥过滤工艺在油田污水深度处理中的应用

对大庆油田石英砂过滤器结构进行改造,并应用悬浮污泥过滤技术对油田污水进行了深度处理,试验取得了良好的处理效果.改造后的石英砂过滤器在进水悬浮物质量浓度为40～63 mg/L时,出水悬浮物质量浓度小于10 mg/L,平均去除率为81.8%,比改造前提高了33.3%;在进水油质量浓度为79～119 mg/L时,出水油质量浓度小于10 mg/L,平均去除率为92.9%,比改造前提高了21.2%.通过悬浮污泥过滤工艺处理后,出水悬浮物质量浓度小于2 mg/L,出水油质量浓度小于3 mg/L,滤出水悬浮物去除率达到96.4%,油去除率达到97.0%,水质均达到油田回注水标准.     

CaSO_4晶须对聚氨酯胶粘剂性能影响的研究

用实验室自制的相对分子质量为2500的聚己二酸-1,4-丁二醇酯二醇和甲苯二异氰酸酯、混合扩链剂配制聚氨酯胶粘剂,并使用实验室自制的改性和未改性200nm硫酸钙晶须对聚氨酯胶粘剂进行改性,考察不同硫酸钙晶须及其加入量、加入方式对聚氨酯胶粘剂综合力学性能的影响。根据实验结果,200nm改性硫酸钙晶须当加入量为3％时,聚氨酯胶粘剂的拉伸强度、初粘性和最终剥离强度均有明显提高。     

1-(2-氯苯基)-5(4H)-四唑啉酮的合成研究

1 (2 氯苯基 ) 5 (4H) 四唑啉酮 (Ⅰ)可由 2 氯硝基苯经三步合成反应制得。首先 ,2 氯硝基苯经铁粉还原得 2 氯苯胺 (Ⅱ) ,Ⅱ与碳酸二 (三氯甲基 )酯反应得 2 氯苯基异氰酸酯 (Ⅲ ) ,Ⅲ在DMF溶剂中 ,无水三氯化铝催化下与叠氮钠缩合得Ⅰ。三步收率分别为 90 %、80 %、90 % ,总收率为 6 5 %(以邻氯硝基苯计 ) ,产品质量分数达 95 %。     

Self-assembly and crystallization behavior of a double-crystalline polyethylene-block-poly(ethylene oxide) diblock copolymer

The self-assembly and crystallization behavior of a well-defined low molecular weight polyethylene-block-poly(ethylene oxide) (PE-b-PEO) diblock copolymer was studied. The number-average degrees of polymerization for the PE and PEO blocks were 29 and 20, respectively. The molecular weight distribution was 1.04 as determined by size-exclusion chromatography. The PE-b-PEO sample exhibited two melting points at 28.7 and 97.4 °C for the PEO and the PE crystals, respectively. The crystallization of the PE blocks was unconfined, while the crystallization of the PEO blocks was confined between pre-existing PE crystalline lamellae, as demonstrated by simultaneous small-angle X-ray scattering (SAXS) and wide-angle X-ray diffraction (WAXD) studies. In the fully crystalline state, both PE and PEO blocks formed extended-chain crystals with PE chains tilted ∼22° from the lamellar normal and PEO chains parallel to the lamellar normal, as evidenced by two-dimensional WAXD study of shear-oriented samples. Regardless of hydrogen bonding among hydroxyl chain ends in the PEO blocks, interdigitated, single-crystalline layer morphology was observed for both PE and PEO crystals. The partial crystalline morphology, where the PE crystallizes and the PEO is amorphous, had the same overall d-spacing as the fully crystalline morphology. A double-amorphous PEO layer sandwiched between neighboring PE crystalline layers was deduced based on a chain conformation study using Fourier transform infrared. The confined crystallization kinetics for PEO blocks was investigated by differential scanning calorimetry, which could be explained by a heterogeneous nucleation mechanism. The slower crystallization rate in the PEO-block than the same molecular weight homopolymer was attributed to the effects of nanoconfinement and PEO chains tethered to the PE crystals.     

二种双邻位甲基取代的聚芳醚酮类树脂的合成与性能

合成二种双邻位甲基取代的聚芳醚酮类聚合物,聚芳醚酮醚酮酮(DM-PEKEKK)和聚芳醚酮酮醚酮酮(DM-PEKKEKK),用FT-IR、1H NMR、DSC、WAXD、TG等技术对其进行表征,研究表明:较之于未取代的PEKEKK和PEKKEKK玻璃化转变温度和溶解性能大幅度提高,热分解温度有所下降,但均在450℃以上.     

回转窑托轮安装方案调整实践

山东东华水泥有限公司5000t/d熟料生产线三档支承回转窑为φ4.8m×74m,在其托轮安装到位并进行二次灌浆后,进行窑筒体吊装对接前检查发现,托轮与轮带的制造尺寸与设计图纸不符。对此,经过分析研究确定,采用适当调整回转窑的中心线高度(将回转窑中心线高度下降5mm)和托轮中心距的方法,来实现回转窑三档处中心点在一条直线上。生产实践表明,回转窑在此方案安装投产以来,没有出现掉砖和托轮轴承发热现象,回转窑运转良好,达到了使用要求。     

烟气轮机运行中动平衡破坏的原因分析及维护措施

对引发烟气轮机动平衡破坏的原因进行分析 ,并举例加以说明 ,进而提出了烟气轮机平稳运行的维护措施