Control of carbon incorporation in AlAs grown by atomic layer epitaxy using variously orientated substrates

We demonstrate a method for successfully controlling carbon incorporation in AlAs layers grown by atomic layer epitaxy (ALE) using various GaAs substrates with different orientations. The number of alkyl radicals attached to an Al atom at the surface, which is a main factor in carbon incorporation, can be intentionally controlled by changing substrate orientation. We found that the carbon incorporation in ALE-AlAs using the (3 1 1)B surface is 2 x 10¹⁷,cm^-3, which is the lowest value ever reported for ALE-AlAs that satisfies one-monolayer self-limiting growth conditions.     

Digital fault location for high resistance grounded transmissionlines

This paper demonstrates that the presence of multiple load taps cannot be neglected for single-phase-to-ground fault location. A new method has been developed taking this into consideration, that can be applied to correct the location error due to intermediate power sources. Then fault location methods for parallel double-circuit two-terminal transmission lines are discussed. Finally, a new fault location method is proposed for high-resistance grounded double-circuit transmission lines with three terminals     

Correction and evaluation of the effect due to parasitic motion on primary accelerometer calibration

Primary accelerometer calibration is carried out under the assumption that a vibration exciter gives a rectilinear motion to an accelerometer to be calibrated. However practical vibration given by the vibration exciter includes parasitic motion such as transverse, rocking, and bending motion. Such parasitic motion would give two serious effects on primary calibration results, transverse motion effect and vibration distribution effect. Transverse motion effect is caused by an inner product of the vectors of both transverse motion and transverse sensitivity. On the other hand, the vibration distribution effect is caused by relative motion between a sensing point of accelerometer and a spot sensed by the interferometer. As these effects have close interaction between parasitic motion and measuring instruments, it would be very difficult to evaluate them by measuring independently each component.     

Identification of characterization factor for power system oscillation based on multiple synchronized phasor measurements

Electric power systems in Japan are composed of remote and distributed location of generators and loads mainly concentrated in large‐demand areas. The structures having long‐distance transmission tend to produce heavy power flow with increasing electric power demand. In addition, some independent power producers (IPP) and power producer and suppliers (PPS) are participating in the power generation business, which makes power system dynamics more complex. However, there was little observation as a whole power system. In this paper the authors present a global monitoring system of power system dynamics by using the synchronized phasor measurement of demand‐side outlets. Phasor Measurement Units (PMU) are synchronized based on the global positioning system (GPS). The purpose of this paper is to show oscillation characteristics and methods for processing original data obtained from PMU after certain power system disturbances triggered by accidents. This analysis resulted in the observation of the lowest and the second lowest frequency mode. The derivation of eigenvalue with the two‐degree‐of‐freedom model brings a monitoring of two oscillation modes. Signal processing based on wavelet analysis and simulation studies to illustrate the obtained phenomena are presented in detail. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 163(3): 10– 18, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20316     

Relative pitch perception in Japanese monkeys (Macaca fuscata).

To investigate whether monkeys perceive relative pitch, the author trained 3 Japanese monkeys (Macaca fuscata) to detect changes from rising to falling contours of 3-tone sequences. Tone sequences were presented serially with transposition, so monkeys were urged to attend to cues other than the absolute frequency of a component tone. Results from probe tests with novel sequences showed that monkeys discriminated by the relative pitch when the frequency ranges of sequences were within the training range, showing a similar tendency as birds in previous studies (e.g., S. H. Hulse, J. Cynx, & J. Humpal, 1984). (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Design methodology for a braided cylinder

In this study, the design methodology for a braided cylinder was presented. The concept of an analytical model which involved both micro model and macro model was proposed. The analytical method was applied to estimate the rigidity and elastic limit of a braided cylinder subjected to bending and torsional load independently and as combined load. Using the analysis method, the design of a braided cylinder would be carried out in consideration of the factors that decide the mechanical properties of braided cylinder. This method has the possibility to be useful for structural design of braided composites and can be included as a unit in CAE systems for braided composites.     

Signal Detection Performance of Overlapped FFT Scheme with Additional Frames Consisting of Non-continuous Samples in Indoor Environment

Overlapped FFT has been proposed as a signal detection scheme in dynamic spectrum access to reduce the variance of the noise and improve the detection probability. However, the improvement of the detection probability in the conventional overlapped FFT is bounded with the upper limit of the overlap ratio. This paper proposes a new overlapped FFT scheme using additional frames. In the proposed scheme, in addition to the original FFT frames, new frames that consist of multiple subframes with non-continuous samples are constructed and included. It can realize the increase of the number of the FFT frames and the improvement of the detection probability compared with the conventional scheme. Numerical results through computer simulation show that the proposed scheme improves the detection probability by up to 0.07. On indoor channel models the proposed scheme also improves the detection probability. In addition, it is clarified that as the delay spread increases the detection probability reduces due to the correlation between the frames.     

Performance of the first Japanese large-scale facility for radon inhalation experiments with small animals

A radon test facility for small animals was developed in order to increase the statistical validity of differences of the biological response in various radon environments. This paper illustrates the performances of that facility, the first large-scale facility of its kind in Japan. The facility has a capability to conduct approximately 150 mouse-scale tests at the same time. The apparatus for exposing small animals to radon has six animal chamber groups with five independent cages each. Different radon concentrations in each animal chamber group are available. Because the first target of this study is to examine the in vivo behaviour of radon and its effects, the major functions to control radon and to eliminate thoron were examined experimentally. Additionally, radon progeny concentrations and their particle size distributions in the cages were also examined experimentally to be considered in future projects.     

Liquefaction and dechlorination of hydrothermally treated waste mixture containing plastics with glass powder

Additive effects of glass powder upon the product yields and chlorine distribution after liquefaction of hydrothermally pretreated mixed waste (HMW) are compared with liquefaction of HMW with any one of water, quartz sand, or glass powder plus water. As a result, addition of either water or quartz sand did not affect liquefaction and dechlorination of HMW. Further, water (5 g) addition did not enhance liquefaction and dechlorination of HMW with glass powder. On the other hand, after liquefaction of HMW with glass powder, the yields of chlorine in the gas and water insoluble constituents decreased and the chlorine yield in the water-soluble constituent increased significantly. Because sodium in glass powder dissolved in a small amount (0.5 g) of water resulted from dehydration of HMW during liquefaction. Further, hydrogen chloride derived from polyvinylchloride in HMW was neutralized by ion exchange between H(+) and Na(+) dissolved in a small amount of water forming NaCl in the Residue (water-soluble) constituent. Therefore, most of chlorine in HMW was removed easily by water extraction of the Residue constituent after liquefaction of HMW with glass powder. Further, upgrading of HMW into the oil constituent was enhanced due to inhibition of production of chlorine containing organic compounds. Accordingly, it was clarified that glass powder was the most effective additive for liquefaction and dechlorination of HMW.