The charge and discharge of lithium ion batteries are often accompanied by electrochemically driven phase‐transformation processes. In this work, two in situ and operando methods, that is, micro‐Raman spectroscopy and X‐ray diffraction (XRD), have been combined to study the phase‐transformation process in LiFePO4 at two distinct length scales, namely, particle‐level scale (～1 μm) and macroscopic scale (～several cm). In situ Raman studies revealed a discrete mode of phase transformation at the particle level. Besides, the preferred electrochemical transport network, particularly the carbon content, was found to govern the sequence of phase transformation among particles. In contrast, at the macroscopic level, studies conducted at four different discharge rates showed a continuous but delayed phase transformation. These findings uncovered the intricate phase transformation in LiFePO4 and potentially offer valuable insights into optimizing the length‐scale‐dependent properties of battery materials. 相似文献
The thermal decomposition of Mg-Al hydrotalcite and the subsequent reconstruction of the decomposed products in the presence of water vapor (2 vol. % H(2)O in N(2)) have been investigated by in situ XRD. Thermographic analysis and temperature-programmed desorption MS results complemented the diffraction data. Valuable mechanistic and kinetic insights into these processes, which are of prime importance for optimal activation of this type of material for catalytic applications, were obtained. Hydrotalcite decomposition to the mixed oxide proceeds via formation at 423-473 K of an intermediate phase, consisting of a highly disordered, dehydrated, layered structure. The latter evolves by removal of interlayer water on heating, causing a shrinking of the interlayer space (it is up to 45 % smaller than in the as-synthesized hydrotalcite). Above 623 K, Mg(Al)O(x) oxide with the periclase structure is formed. Reversion of the intermediate dehydrated structure to hydrotalcite upon contact with water vapor is complete and very fast at room temperature. Recovery of hydrotalcite from the oxide calcined at 723 K is two orders of magnitude slower than rehydration of the intermediate layered structure and one order of magnitude slower than the typically practiced liquid-phase reconstruction. In contrast to the decomposition, the reconstruction mechanism does not involve an intermediate phase. The gas-phase rehydration and reconstruction was interrupted above 303 K. This is attributed to the poor wetting of the surface of the decomposed materials induced by hampered H(2)O adsorption above room temperature at the water vapor pressure applied. The Avrami-Erofe'ev model describes the reconstruction kinetics well. 相似文献
Extremely small PtRu/C nanocatalysts were prepared via a carbonyl route. A thorough in situ reduction X-ray structural characterization of these catalysts was performed. After synthesis and storage under ambient conditions, the diffraction patterns of PtRu/C catalysts were seriously modified, indicating the surface oxide formation. In the reduced state, the particle size is around 2 nm. The observed relative fluctuations of lattice constants are 3%, which is far too large to be explained by a compositional fluctuation. Their origin is attributed to strong but isotropic strains and is related to the alloy formation. The annealing experiments show all the catalysts present an exceptional thermal stability when annealed in inert ambient, especially that of the Pt1Ru1/C catalyst. Besides, it is interesting to note that there is no thermal expansion evidence from the patterns. 相似文献
1 INTRODUCTION Without introduction of any stabilizing reagent, mesoporous zirconia was prepared via solid state re- action-structure directed method, which broke through the traditional preparation route (liquid reaction)[1]. Using this novel method, the samples possess not only mesoporous structure, but also nano-size. Normal size zirconia has three kinds of crys- talline phases: monoclinic phase existing at room tem- perature, tetragonal phase stabilizing between 1170～2370 ℃ and cubi… 相似文献
Block copolymer nanopaticles were prepared from the mixture solutions containing good/poor solvents by a simple evaporation process. The block copolymers formed disorder, unidirectionally stacked lamellar, and onion‐like structures in nanoparticles depending on preparation temperatures. Thermal annealing induced the disorder‐order phase transition and order‐order phase transformation in the block copolymer nanoparticles, even though the annealing temperature is lower than the of one polymer segment. The unusual thermal behaviors suggest that the glass transition temperature of the block copolymer is decreased by the effect of nanoparticle, whose surface areas are larger than their volumes.
下载免费PDF全文 