共查询到18条相似文献,搜索用时 437 毫秒
1.
2.
3.
4.
能量与能质寓于同一的客观属体--能,又分别表征能的不同的客观属性.热力学可划分为基础热力学和应用热力学两大类,相应地形成了分别以熵和(火用)为核心的两个热力学参数框架体系.(火用)理论的直接应用是(火用)分析法;其扩展应用是与经济学结合产生的热经济学,与传输学结合产生(火用)传递理论. 相似文献
5.
6.
7.
针对工质选择对热力循环系统效率有着重要影响等卡诺定理不能做出合理解释的问题,将工质吸热后的热力学能火用进一步划分为等熵膨胀火用与等压换热火用,指出可被动力设备直接利用的火用只有工质的等熵膨胀火用。理论推导表明:在等熵膨胀过程中,压缩气体的膨胀功并不能全部转化为有用功(火用),气体膨胀功转化为有用功的效率取决于气体工质的内部压强和气体所处外部环境的压强。气体的内部压强越大、外部环境压强越小,气体膨胀功转化为有用功(火用)的效率越高。 相似文献
8.
依据热力学基本定律 ,本文从火用平衡的角度分析了常压锅炉的能量转换利用过程 ,并通过实例计算 ,分析比较了热平衡和火用平衡的各项火用损失。同时指出了常压锅炉节能的主要方向 (减少锅炉内部损失 )和措施。 相似文献
9.
10.
11.
12.
输元是组成传递模型的基本单元.提出三类9项输元特性准则.研究确定传热传递、能量转换传递、传质传递三大类8种典型输元的特性准则,并给出了相应的计算式或表达式,为规范建立基本工程传递模型、简化复杂系统的工程传递分析提供了基础. 相似文献
13.
In this paper, based on the fundamentals of thermodynamics and heat transfer, an analysis is made of the exergy transfer of convection heat transfer. Some exergy transfer differential equations are derived under constant thermophysical property and uncompressible laminar flow in the convection heat transfer process. Taking one‐ and two‐dimensional convection heat transfer as examples, respectively, the exergy functions are solved and calculated. Their results agree well with those results from thermodynamic analysis. © 2007 Wiley Periodicals, Inc. Heat Trans Asian Res, 36(2): 66–73, 2007; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/htj.20146 相似文献
14.
S. A. Fartaj 《国际能源研究杂志》2004,28(14):1219-1230
The energy, exergy and entropy balance methods are used to analyse a double‐stage LiBr‐water absorption heat transformer cycle. An energy balance comparing component energy transfer is used to determine energy calculations. An exergy balance is employed to evaluate exergy destruction, and an entropy balance to verify entropy generation. A comparison of the results by the second law exergy and entropy balances indicates that they are consistent in identifying the location and relative significance of key non‐idealities within the system. The results obtained clearly show the influence of irreversibilities of individual components on deterioration of the effectiveness and the coefficient of performance of the system. The second law analysis offers an alternative view of cycle performance and provides an insight that the first law analysis cannot. The differences between the first law analysis by energy balance method and second law analysis by exergy and entropy balance methods are illustrated quantitatively for the double‐stage absorption heat transformer cycle, and the limitations and advantages of these methods are presented and discussed. Copyright © 2004 John Wiley & Sons, Ltd. 相似文献
15.
Numerical simulations of temperature field of an oil pipeline when transportation is stopped
下载免费PDF全文
![点击此处可从《储能科学与技术》网站下载免费的PDF全文](/ch/ext_images/free.gif)
对于高凝点原油,管线停输后很容易出现凝管现象,确定安全停输时间是保证安全启动的重要条件.原油的储热能力,管道系统向周围土壤传热能力及土壤的温度场分布决定着管线安全停输时间,研究热油管线停输期间温降规律显得尤为重要.利用CFD软件,在非稳态传热条件下,模拟出不同停输时刻管道温度场分布及温降曲线.结果表明:停输初期管内原油自然对流传热强烈,温度下降较快,后期下降缓慢,这种变化趋势和传热方式的变化相对应.当停输21 h时,原油温度降为38 ℃(高于凝点3 ℃),即安全停输时间为21 h. 相似文献
16.
针对采用新型烟气余热深度利用技术的烟水复合回热系统,以600 MW超临界汽轮机组为例,运用热量平衡、火用平衡两种手段进行了节能分析。优化系统设置了空预器烟气旁路,布置高、低压换热器加热给水,设置回收低品位余热的前置空预器。通过定功率全系统热力计算表明,优化系统深度利用锅炉排烟余热,主蒸汽流量减少,供电标准煤耗率减小5.13 g/(k W·h)。优化系统锅炉传热火用损失、回热加热器火用损失减少。机组总火用损失减少,效率提高。工程应用表明,改造后机组实际供电标准煤耗降低了6.78 g/(k W·h)。 相似文献
17.
18.
针对余热的有效利用,建立了有机朗肯循环-复叠式制冷系统的热力学模型,其中:有机朗肯循环系统分别采用R123、R1234ze、R245fa、R600a、RC318、R141b等六种工质;复叠式制冷系统分别采用R22/R23、R404/R23、R290/R744、R717/R744等四种工质对。选择系统?效率作为性能评价指标,运用热力学第二定律研究系统运行参数对系统?效率的影响,分析了系统各部件的?损失,并指出了能量利用的薄弱环节,提出了有效提高系统性能的建议,为系统的优化提供参考。结果表明,对系统?效率而言,R141b和R717/R744是最佳工质。系统主要部件按?损失大小依次为凝汽器、膨胀机、高温级冷凝器、发生器、高温级压缩机、低温级蒸发器、蒸发冷凝器。尽可能提高压缩机的等熵效率,优化设计换热器的结构,减小传热温差,才能减少不可逆损失,提高换热器的?效率。 相似文献