Local electric discharge in liquid as a source of atomization and excitation for atomic emission spectroscopy

The article describes an atomization and excitation source for analysis of solutions by atomic spectrometry. The concentration of the energy in a pulse high-voltage discharge through a capillary in a dielectric wall separating the solution forms plasma that excites emission by atoms of compounds in the solution. The role of the electrode deposited near the aperture of the capillary and the sign of its potential in the intensity of the registered spectrum is demonstrated. The opportunities of the quantitative and qualitative analysis of solutions with element concentrations below 10 μg/L are considered. The conditions of analyte accumulation on the electrode are implemented. The opportunities for the determination of analytes in the flow mode are demonstrated.     

微波消解ICP-AES法测定ABS中Pb、Cd、Hg

以ABS塑料为研究对象,采用微波消解法进行样品的前处理,使用电感耦合等离子体发射光谱法测定ABS塑料中Pb、Cd、Hg,结果表明,Pb、Cd、Hg加标回收率均在95~105%之间,测试精密度均小于3%,该方法在缩短样品前处理时间的同时得到较高的元素消解回收率和较为理想的精确度,适用于ABS塑料中重金属含量的快速测定。     

Procedure for correcting interferences in emission spectroscopy

Summary A procedure for correcting interferences in emission spectroscopy is suggested. It is based on the use of error curves, which are a measure of the extent of the enhancing (or suppressing) effect of the interfering element upon the sought-for one. The flame-photometric determination of potassium in the presence of large amounts of sodium is described as an example.

---

Verfahren zur Korrektur von Störeinflüssen in der Emissionsspektrographie

Zusammenfassung Das beschriebene Verfahren zur Korrektur des Einflusses störender Begleitionen beruht auf dem Gebrauch von Fehlerkurven, die das Ausmaß der verstärkenden oder schwächenden Wirkung von Fremdionen angeben. Die flammenphotometrische Kaliumbestimmung in Gegenwart großer Mengen Natrium dient als Beispiel.

     

An assessment of an atmospheric pressure helium microwave plasma produced by a surfatron as an excitation source in atomic emission spectroscopy

A new microwave plasma at atmospheric pressure is described. The plasma is supported by a surface wave excitation structure called “surfatron”. Both argon and helium can be used to sustain the plasma. In this study, helium has been selected. The sample introduction system consists of an ultrasonic nebulizer associated with a dcsolvation system. The analytical performance in terms of detection limits, calibration curves and some interferences have been assessed. Because of the relatively low power and the short residence time the main problem seems to be the atomization process.     

Evaluation of dithiocarbamates and beta-diketones as chelating agents in supercritical fluid extraction of Cd, Pb, and Hg from solid samples

The use of four dithiocarbamates and three fluorinated β-diketones as potential chelating agents for three transition metal ions (Cd²⁺, Pb²⁺, and Hg²⁺) extracted from spiked sand and filter paper samples by supercritical fluid extraction (SFE) was investigated. The extractions were performed at 45°C and 250 atm for spiked sand samples and at 60°C and 200 atm for filter paper samples using supercritical carbon dioxide modified with 5% methanol. At 250 atm and using carbon dioxide modified with 5% methanol, the recoveries of Cd²⁺, Pb²⁺, and Hg²⁺ ions from spiked sand samples were 95% with lithium bis(trifluoroethyl)dithiocarbamate (LiFDDC) as the chelating agent; they ranged from 83–97% with diethylammonium diethyldithiocarbamate and from 87–97% with sodium di-ethyldithiocarbamate as chelating agents, and from 68–96% with trifluoracetylacetone, hexafluoroacetylacetone, and thenoylfluoroacetone as chelating agents. Ammonium pyrrolidinedithiocarbamate was not effective in the chelation SFE of Cd²⁺, Pb²⁺, and Hg²⁺ ions from either spiked sand or spiked filter paper samples under the extraction conditions used. Supercritical carbon dioxide alone gave consistently lower analyte recoveries than supercritical carbon dioxide modified with 5% methanol. The results suggest that the solubility of the metal chelate in the supercritical fluid plays a more important role than the solubility of the chelating agent in the supercritical fluid, as long as sufficient chelating agent is present in the fluid phase. Fluorination of the chelating agent, as in the case of LiFDDC, increases the solubility of the metal chelate, and subsequently enhances the extraction efficiency for the metal ions.     

Comparison in the analytical performance between krypton and argon glow discharge plasmas as the excitation source for atomic emission spectrometry

The emission characteristics of ionic lines of nickel, cobalt, and vanadium were investigated when argon or krypton was employed as the plasma gas in glow discharge optical emission spectrometry. A dc Grimm-style lamp was employed as the excitation source. Detection limits of the ionic lines in each iron-matrix alloy sample were compared between the krypton and the argon plasmas. Particular intense ionic lines were observed in the emission spectra as a function of the discharge gas (krypton or argon), such as the Co II 258.033 nm for krypton and the Co II 231.707 nm for argon. The explanation for this is that collisions with the plasma gases dominantly populate particular excited levels of cobalt ion, which can receive the internal energy from each gas ion selectively, for example, the 3d⁷4p ³G₅ (6.0201 eV) for krypton and the 3d⁷4p ³G₄ (8.0779 eV) for argon. In the determination of nickel as well as cobalt in iron-matrix samples, more sensitive ionic lines could be found in the krypton plasma rather than the argon plasma. Detection limits in the krypton plasma were 0.0039 mass% Ni for the Ni II 230.299-nm line and 0.002 mass% Co for the Co II 258.033-nm line. However, in the determination of vanadium, the argon plasma had better analytical performance, giving a detection limit of 0.0023 mass% V for the V II 309.310-nm line.     

Direct optical emission spectroscopy of liquid analytes using an electrolyte as a cathode discharge source (ELCAD) integrated on a micro-fluidic chip

Atomic emission detection of metallic species in aqueous solutions has been performed using a miniaturised plasma created within a planar, glass micro-fluidic chip. Detection was achieved using an Electrolyte as a Cathode Discharge source (ELCAD) in which the sample solution itself is used as the cathode for the discharge. To realise the ELCAD technique within a micro-fluidic device, a parallel liquid-gas flow was set up in a micro-channel and a glow discharge ignited between the flowing liquid sample surface and a metal wire anode. The detection of copper and sodium was achieved, using atmospheric pressure air as a carrier gas, by observation of atomic emission lines of copper at 324 nm, 327 nm, 511 nm, 515 nm and 522 nm and an atomic emission line of sodium at 589 nm using a commercially available miniaturised spectrometer. A total electrical power of less than 70 mW was required to sustain the discharge. A semi-quantitative, absolute detection limit of 17 nmol s(-1) was obtained for sodium with a sample flow rate of 100 microL min(-1) and an integration time of 100 ms in air at atmospheric pressure. The volume required for such detection is approximately 170 nL. Further analysis was performed with an Echelle spectrometer using both argon and air as a carrier gas. The geometry and flow rates used demonstrate the feasibility of integrating such micro-plasmas into other micro-fluidic devices, such as miniaturised CE devices, as a method of detection. The potential for using such micro-plasmas within highly portable miniaturised systems and mu-TAS devices is presented and discussed.     

电感耦合等离子体发射光谱法测定粗二氧化碲中 铜、铅、锑、铋、砷和硒

粗二氧化碲作为碲精炼或碲化工产品生产的重要原料,其中共存元素铜、铅、砷、锑、铋、硒含量的准确测定对于生产过程质量控制和贸易结算具有重要意义,但目前没有粗二氧化碲中铜、铅、砷、锑、铋、硒含量检测的标准分析方法。采用王水和饱和氟化氢铵分解试样,在王水和酒石酸介质中,选用Cu 327.393 nm、Pb 220.353 nm、Sb 217.582 nm、Bi 223.061 nm、As 193.696 nm、Se 196.026 nm为分析谱线,采用电感耦合等离子体发射光谱(ICP-AES)法测定粗二氧化碲中铜、铅、锑、铋、砷和硒含量。各元素校准曲线的相关系数均大于0.999;铜、铅、锑、铋、砷和硒的检出限分别为0.0004%、0.0005%、0.0006%、0.0007%、0.0004%和0.0007%,定量检出限分别为0.0012%、0.0016%、0.0020%、0.0025%、0.0013%和0.0025%。按照实验方法测定5个粗二氧化碲样品中铜、铅、锑、铋、砷和硒,测定结果的相对标准偏差(RSD,n=7)为0.79%~4.8%,加标回收率为96.0%~103%。方法简单,精密度和准确度较高,可用于测定粗二氧化碲中铜、铅、砷、锑、铋、硒含量。     

Ab initio calculations of chloride complexes of Au, Hg, Tl, Pb, and Bi in anomalous oxidation states (2S1/2 electron state)

Ab initio calculations of chloride complexes of Au, Hg, Tl, Pb, and Bi in anomalous oxidation states (²S_1/2 electron state) were carried out by the Becke-Lee-Yang-Parr density functional method using the Dunning-Hay LanL2DZ basis set. Optimum geometric parameters and electronic characteristics of MCl _n (H₂O) _m ⁿ (n=1–4 andm=0,4,5) complexes were determined. In each of the considered series the spin, population on the central metal atom decreases as its atomic number increases. The energy of transition of the unpaired electron to the lowest unoccupied MO decreases in the same order. The unpaired electron occupies an orbital that is mostly a linear combination of the s-orbital of the metal atom and the p-orbital of the Cl atom (the antibonding σ-orbital of the M−Cl bond). Distinctions in the changes in spectral properties of aquacomplexes and chloride complexes in isoelectronic series, observed as the degree of oxidation of the metal atom increases, were explained. The results of calculations are in agreement with the experimental data obtained by ESR and optical spectroscopy. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1049–1055, June, 1999.     

An assessment of a microwave-induced plasma generated in argon with a cylindrical TM010 cavity as an excitation source for emission spectrometric analysis of solutions

A cross-flow pneumatic nebulizer with spray chamber was directly coupled to a microwave-induced plasma (MIP) generated with a cylindrical TMO₀₁₀ cavity in argon flowing through an alumina capillary. The detection limits of 15 elements were determined with 23 spectral lines and the interference effect of KCl on these spectral lines was measured. The results were compared with those reported in the literature for MIP systems based on conventional or newly designed cavities, and incorporating desolvation facilities. A comparison was also made with an inductively coupled plasma (ICP) and a capacitively coupled microwave plasma (CMP) for which the reported results were obtained under spectrometric conditions that closely matched those used in the present work and for which the rate of sample injection into the plasma was approximately the same as that used here.