Polonium-210 distribution in Syrian phosphogypsum

Polonium-210 distributions in Syrian phosphogypsum and its leaching mechanisms have been evaluated. Radiochemical analyses have shown that ²¹⁰Po concentration in Syrian phosphogypsum is always higher than ²²⁶Ra concentration. ²¹⁰Po concentrations were found to vary between 373 and 589 Bq^.kg^–1 with an average value of 471 Bq^.kg^–1, which is lower than values reported in other countries. ²¹⁰Po was found to be more concentrated in smaller particles; a specific activity of 827 Bq^.kg^–1 in particles less than 250 mesh was observed. Leaching experiments using distilled water have shown that ²¹⁰Po are strongly bounded to phosphogypsum particles. The amount of ²¹⁰Po transferred to aqueous media does not exceed 5.6% and 8.4% for batch wise and continuous leaching, respectively; lowering the pH has increased this percentage to 20%. In addition, leaching with diluted sulfuric acid indicated that 80% of polonium is present as water insoluble quadrivalent polonium sulfate while 20% as soluble simple polonium sulfate. However, the obtained data could be used to explain environmental pathways of ²¹⁰Po from phosphogypsum.     

Measurement of lead-210, bismuth-210, and polonium-210 in environmental samples

Mathematical equations governing the ratio of²¹⁰Bi/²¹⁰Pb and²¹⁰Po/²¹⁰Pb activities are used to explain the ingrowth of²¹⁰Bi and²¹⁰Po in environmental samples during post collection. Procedures are described for radiochemical separation of²¹⁰Pb,²¹⁰Bi, and²¹⁰Po in a state of radioactive disequilibrium and quantification by alpha- and beta-counting. Also, the special case is considered where²¹⁰Bi is in equilibrium with²¹⁰Pb, but both are in disequilibrium with²¹⁰Po. In this case, the activities of both²¹⁰Pb and²¹⁰Po are computed by measuring²¹⁰Po activity twice, using alpha-counting.     

Determination of lead-210 in bottom sediments via bismuth-210

Determination of lead-210 in bottom sediments is applied for evaluation of sedimentation rates and sediments ages by concentration profiles of disequilibrated lead-210 from atmospheric sources. Advences in low level liquid scintillation spectrometry (LS) fitted for natural radioactivity measurements, permit to combine the possibility of immediate bismuth-210 separation with its radioactivity registration using LS spectrometer Quantulus (LKB-1220, Wallak, Finland). The method was tested on bottom sediment samples from Baltic Sea shelf, collected during the 76th cruise of RV Academician S. Vavilov. The proposed method of separation, purification and chemical yield determination is characterized by simplicity, rapidity and may be used in routine analysis.     

Zur schnellen Bestimmung von Blei-210 und Polonium-210 in organischen Probematerialien

Ohne Zusammenfassung     

A simultaneous determination of lead-210 and polonium-210 in sea water

A new radiochemical procedure is described for the determination of lead-210 and polonium-210 in sea water. These nuclides are concentrated by coprecipitation with calcium carbonate from a sea water sample of large volume and then separated from calcium by formation of the hydroxides. Polonium-210 is deposited spontaneously onto a silver disc and determined by an α-counting technique. Lead-210 is also determined by counting the activity of polonium-210 produced during storage for 3 months.     

Atmospheric residence times of strontium-90 and lead-210

The concentrations of⁸⁹Sr,⁹⁰Sr,²¹⁰Pb and²¹⁰Po were measured in a series of rain samples collected at Fayetteville (36°N, 94°W), Arkansas, after the 14th Chinese test of March 18, 1972, which occurred at Lop Nor (40°N, 90°E), China. Approximately concordant tropospheric residence times were obtained from the⁸⁹Sr/⁹⁰Sr and²¹⁰Po/²¹⁰Pb ratios in rain. The⁸⁹Sr/⁹⁰Sr ratios were also measured for the rain samples collected at Tokyo (36°N, 140°E), Japan, and at Ankara (40°N, 33°E), Turkey.     

The calculation of lead-210 dates for McKay Lake sediments

Lead-210 dates are assigned to a sediment core retrieved from McKay Lake, Ottawa, Canada. Sediment mixing is found to have little, but discernible, influence on the age/depth profile. Consideration of mixing yields lower estimates of the derived ages, in agreement with the prediction based on a mathematical model. The inferred dates support the previous assignments based on Ambrosia horizon and the known occurrence of a catastrophic event. The procedures used in the calculation of the age profiles are fully described.     

Vanadium levels in marine organisms of Onagawa Bay in Japan

Vanadium in marine organisms from Onagawa Bay in Miyagi, Japan, was determined by an instrumental neutron activation analysis (INAA) method using anti-coincidence gamma-ray spectrometry at the Dalhousie University SLOWPOKE-2 Reactor (DUSR) facility in Canada. Seaweeds, cultivated oysters, plankton, and four different species of sea squirt were collected from Onagawa Bay during 2005–2008. Vanadium levels around 20 μg g⁻¹ (dry weight) were found in Japanese tangle and hijiki seaweeds. One species of sea squirt (Ciona savignyi) contained 160–500 ppm of V and it was highest among the four species of sea squirts studied. Protein-bound V species were separated by gel permeation chromatography (GPC) and the element determined by inductively coupled plasma atomic emission spectrometry (ICP-AES).     

Radiochemical determination of lead-210 in environmental water samples using Cerenkov counting

A relatively simple method has been developed for the determination of²¹⁰Pb via its -emitting daughter,²¹⁰Bi. Lead-210 was separated from interfering elements as lead sulphate. The precipitate was dissolved in an alkaline solution of EDTA and the Cerenkov signal produced by the build-up of²¹⁰Bi was counted 30 days after storage using tritium channel of a liquid scintillation counter. Cerenkov counting efficiency was found to be approximately 20%. A lower limit of detection of 5.1 mBq/1 (based on 3 of the background with 500 minute counting time) was achieved. Chemical recoveries in the range of 70–100% were determined gravimetrically. Interference associated with currently used methods is avoided. Data from from both spiked samples and natural samples are presented.     

Fast,selective and sensitive methods for the determination of lead-210 in phosphogypsum and phosphate ore

Two methods are presented for a fast, accurate and precise determination of²¹⁰Pb in industrial samples with a calcium-phosphate and-sulphate matrix. One method combinessolid-liquid extraction on a Pb-selective column Sr^*Spec (Eichrom) with gamma-ray spectrometry of²¹⁰Pb and can be applied to samples >10 g for aselective ²¹⁰Pb determination. The yield is determined gravimetrically. The detection limit is 380 mBq for a 24 h counting period. The other method combineschromatography on Sr^*Spec with liquid scintillation counting of²¹⁰Pb for asensitive ²¹⁰Pb determination and can be applied to samples of up to 1 g. The yield is determined on-line by the UV signal of PbEDTA. The detection limit is 70 mBq for a 2 h counting period. Aspects of accuracy, precision, selectivity, sensitivity and the application of both methods to phosphogypsum and phosphate ores are presented.     

Nondestructive determination of lead-210 and radium-226 in sediments by direct photon analysis

A method is described for the non-destructive determination of²¹⁰Pb and²²⁶Ra in sediments. The procedure is based on the direct counting of the 46.5-keV -ray of²¹⁰Pb and the 351.9-keV -emission of²¹⁴Pb. The self-absorption of the 46.5-KeV -ray is corrected using a technique involving direct gamma transmission measurements on sample and efficiency calibration standard. Several reference materials when assayed by the described method yielded results in general agreement with the certified values. The application of the method is illustrated through the analysis of the excess²¹⁰Pb profile of a Lake Ontario sediment core.     

Measurements of210Pb and210Po in Japanese human hair

²¹⁰Pb and²¹⁰Po in human hair have been measured to serve as an aid in order to estimate the dietary intake and body burden of these radionuclides of Japanese. The²¹⁰Po concentrations found in 83 hair samples were ranging from 4.0 to 59.3 mBq/g with a mean (median) value of 18.2±12.2 (14.9) mBq/g as compared to the²¹⁰Pb concentrations from 0.7 to 6.5 mBq/g with a mean (median) value of 2.3±1.1 (2.0) mBq/g. The²¹⁰Po/²¹⁰Pb activity ratios (mean: 8.7±5.1, median: 7.1) were surprisingly higher compared with the available literature value of about 2. The high concentration of²¹⁰Po in human hair of Japanese may be due to the ingestion of animal protein mainly in the form of seafood.     

A biomonitoring study: 210Po and heavy metals in marine organisms from the Adriatic Sea (Italy)

In various samples of marine organisms from the central Adriatic Sea ²¹⁰Po was determined by alpha spectrometry and thirteen heavy metals (Mn, Fe, Co, Cr, V, Ni, Cu, Zn, Cd, As, Sn, Hg and Pb) by energy dispersive, polarised X ray fluorescence spectrometry (EDPXRF). ²¹⁰Po activity concentration ranged between 0.3 and 44.6 Bq kg⁻¹ fresh weight. The data obtained depend upon the type of the marine organism; among the pelagic species, anchovy displayed the highest polonium concentration. Typical concentration ( \upmu \textg·\textg_(\textfresh) ^{- 1} ) \left( {\upmu {\text{g}}\cdot{\text{g}}_{{({\text{fresh}})}}^{ - 1} } \right) ranges were as follows: Mn: <1.32–1.73; Fe: 4.11–94.27; Co < 0.13–0.23; Ni: <0.13–0.52; Cu: 0.37–145.31; Zn: 0.46–16.46; Cd: <0.10–0.25; As: 0.36–60.52; Hg: <0.13–0.70; Pb: <0.13–0.35, Sn: <0.20–12.67; V and Cr were always <1.32. The data obtained are also compared with those obtained by other authors for the same organism coming from other Italian seas.     

Anion exchange method for the sequential determination of uranium,thorium and lead-210 in coal and coal ash

A radiochemical procedure is presented for the sequential determination of uranium isotopes, thorium isotopes, and²¹⁰Pb in coal and coal ash. This procedure consists of dry ashing the sample, a nitric—hydrofluoric acid dissolution, removal of iron with ether extractions, and separation of the elements of interest by anion exchange chromatography. Uranium and thorium isotopes are measured by alpha spectrometry, while²¹⁰Pb is measured by beta counting its daugther activity,²¹⁰Bi. For 10 g coal samples and 1 g ash samples, the chemical yields for the radioactivities measured were 70–80%, and the relative standard deviations for replicate analyses were generally less than 9%. The deviations of the means from the reference values were within the combined errors of each and were usually less than ±5%. Minimum detectable activities were about 0.02 pCi for uranium and thorium isotopes and 0.2 pCi for²¹⁰Pb.     

Extraction method for arsenic speciation in marine organisms

Three extraction systems have been assayed to extract arsenic species from biological marine sample, using methanol, methanol-chloroform (1:1) and methanol-water (1:1) as solvents. From a comparative study methanol-water 1:1 was chosen. A clean-up of the raw extract using C₁₈ cartridges is proposed. The results obtained from flounder (Pleuronectes platessa), sole (Solea solea), mussel (Mytilus edulis) and cockle (Cardium edule) are reported.     

Determination of210Pb and210Po in human tissues of Japanese

To determine the levels of²¹⁰Pb and²¹⁰Po in human tissues of people in Japan, various tissue samples were obtained at autopsy from the cadavers of 22 oncologic cases, mainly in Niigata Prefecture in northern Japan, from 1986 to 1988.Wet ashing, followed by electrochemical deposition and alpha spectrometry were used to separate and determine the²¹⁰Pb and²¹⁰Po present. Among the tissues analyzed, the highest concentrations of²¹⁰Pb and²¹⁰Po were observed in bone (sternum), liver, and kidneys. The total body burden of²¹⁰Pb and²¹⁰Po was found to be approximately 427 pCi and 514 pCi, respectively. This estimated²¹⁰Po value did not differ significantly from values found in populations in the U.S.A. and European countries.     

Concentration levels and behavior of transuranium nuclides in Japanese coastal marine environment

The concentration of^239,240Pu and²⁴¹Am in different samples collected from the coastal marine environment of Ibaraki Prefecture, Japan facing the Pacific Ocean have been studied. Seawater samples have been collected since 1975 and sea-biota since 1981. The mean concentration levels of^239,240Pu and²⁴¹Am were 0.51, 0.20 for anchovy, 0.22, 0.11 for flounder, 4.9, 0.77 for brown algae, 2.0, 2.4 for shellfish, and 0.022, 0.0028 for seawater (in mBq/kl), respectively. The chronological change of^239,240Pu in seawater was influence by fallout amounts. The activity ratio between the nuclides showed steady levels after two years from the end of atmospheric nuclear explosion tests. Activity levels and the ratios for each type of sample are briefly discussed.