氢气纯度分析方法准确性的探讨

ONACCURACYOFANALYSISOFOFHYDROGEN1前言我公司目前应用的氢气纯度分析方法有两种,一种是爆炸反应法,另一种是焦性没食子酸吸收法。几年来,人们对两种分析方法的准确性曾有过褒贬不一的评论。这里我们也谈谈自己粗浅的观点。2爆炸法测定氢气纯度一定量的氢气样品与适量的空气之均匀混合物因反应后生成液体水而引起气体体积减少,减少的体积等于参加反应气体体积之和。其中l／3为氧气,2／3为氢气。根据氢气取样量和反应前后混气体体积之差,以及氢气在反应中的体积比例关系,可计算出样品的氢气纯度。计算公式式中：A一混…     

COMPARISON OF METHODS OF ANALYSIS OF GYPSUM1

The different analytical methods proposed for the evaluation of gypsum have been subjected to an experimental test. A combination method, consisting of a fusion with KHCO₃ and determination of CaO by KMnO₄ titration, the SO₃ by Andrews method of titration of BaCrO₄ has been found to give very reliable results with the least consumption of time.     

茶多酚提取方法进展

本文综述了国内外现有茶多酚提取方法的现状以及近期的研究进展，并对其优缺点进行了评价。这将有助于中低档茶的综合利用和茶多酚的进一步开发应用。     

SEDIMENTATION OF BINARY MIXTURES OF PARTICLES OF UNEQUAL DENSITIES AND OF DIFFERENT SIZES

A model is developed for the sedimentation from a suspension of two particle species of unequal densities and of different sizes. The composition and the thickness of various layers in the sediments are predicted using graphical and analytical methods. The model predictions were in excellent agreement with experimental results, when the particle size ratio was ≥ 108. When size ratio of the particles was 2.60 and 4.31 the agreement occurred in about 50 percent of the cases.     

HEASUREHENT OF INSTANTANEOUS RATES OF LOSS OF VOIATILE COMPOUNDS DURING DRYING OF DROPS

A novel technique serves to monitor instantaneous rates of loss of a volatile solute from a suspended drop during drying. A highly sensitive electron capture detector is used to monitor concentrations of SF6 released into a flowing gas stream from a suspended, drying drop. Simultaneously, the appearance and morphological development of the drop are monitored with a video camera. This provides the wherewithal of relating instantaneous rates of loss of the volatile solute to particular events during the development of particle morphology.

Initial experiments have been carried out with drops of aqueous solutions of glucose, sucrose, maltodextrin and coffee extract. The results clearly display the onset of the volatiles-retentive selective diffusion phenomenon. There is also substantial loss of the volatile component later in the drying process, when the drops undergo repeated ex ansion, bursting and cratering due to the formation of internaf bubbles. These experiments appear to be the first quantitative demonstration of major losses accompanying changes in drop morphology.     

ANALYSIS OF RECENT MEASUREMENTS OF THE VISCOSITY OF GLASSES

Viscosity of Simple Soda-Silicate 500° to 1400°C Comparison of the results given by English with those of Washburn, Shelton and Libman, indicates a discrepancy in the absolute values of log₁₀ viscosity amounting to 0.6, those of Washburn et al., being relatively too high. If correction for this is made, the isothermal curves of log₁₀ viscosity as a function of soda content are smooth up to 50% Na₂O, showing no inflection. The observations as a function of temperature T are all represented within accidental error by an equation of the type where all three constants vary regularly with the composition. Change of Viscosity of Glass (6SiO₂, 2Na₂O) due to Molecular Substitution of CaO, MgO and Al₂O₃ for Na₂O The effect is clearly brought out by plotting (from the results of English) the change of log₁₀η due to the substitution as a function of temperature. The curves each show a sharp bend at a temperature between 840° and 1050°C, which is designated the aggregation temperature T_a. If we divide these curves by the corresponding percentage substituted, we get curves for each oxide which are straight and parallel below the aggregation temperatures, the slopes (increase of change of log₁₀η per 100°C) being −0.056 (CaO), −0.055 (MgO), −0.018 (A1₂O₃) per per cent oxide substituted. For substitution of 1/2 molecule the slopes are −0.325 (CaO), −0.23 (MgO) and −0.18 (Al₂O₃) per 100°. At the aggregation temperature the change of log₁₀η per per cent is a minimum, 0.03 to 0.06 for CaO, 0.12 for MgO, 0.07 for Al₂O₃. Evidence of Aggregation in Glasses, from viscosity Measurements The sharp bends in the plots of change of log₁₀η due to substitution of an oxide for Na₂O, suggest the beginning of molecular aggregation at these temperatures. These aggregation temperatures are close to the devitrification temperatures, but the effect on the viscosity curves cannot be due to actual devitrification since it does not change with time. Taking the aggregation temperatures as equal to devitrification temperatures, additional isotherms are roughly sketched into the equilibrium triangle of the system Na₂O-CaO-SiO₂. Change of Viscosity of Glass (4SiO₂, 2Na₂O) due to of Substitution of B₂O₃ for SiO₂ The change of log₁₀η (from the results of English) is plotted as a function of temperature, and also the change of log₁₀η per per cent B₂O₃. The curves are more complex than for the substitution for Na₂O.     

环氧树脂羟基值测定方法的研究

利用乙酸酐、吡啶和浓硫酸混合的乙酰化试剂测定环氧树脂中羟基值含量的方法具有操作简便、滴定终点明显和分析结果误差小等优点。     

骑式摩托车油箱喷涂工艺的改进

面对日益激烈的市场竞争,摩托车油箱外观质量越来越成为影响销售的因素之一。文章介绍了改进工艺后的油箱涂装,该涂装体系提高了油箱外观的丰满度,降低了油箱涂装的生产成本。     

几种针状焦性能对比

针状焦分石油系和煤系两大类,这主要取决于针状焦的原料来源。在同一系列中由于原料不同和工艺条件不同 ,针状焦的各自性能也不相同。针状焦是生产超高功率石墨电极和高功率石墨电极的主要原料 ,针状焦的性能对石墨电极的质量有至关重要的影响。所以对针状焦性能以及其对石墨电极质量影响的研究十分必要的。以下是常用的几种进口针状焦和国产针状焦的性能对比。１原料性能分析对比原料试样包括４种针状焦 ,其中两种为进口针状焦：三菱针状焦和新日化针状焦;另两种为国产针状焦：鞍山针状焦和锦州针状焦。其中除锦州针状焦是石油系针状焦外…     

用两个形状指数表征粉煤灰颗粒形貌的研究

引用两个形状指数表征颗粒形状的概念,即先将颗粒形状近似为椭圆,再将椭圆图像分离:以圆为基准的颗粒宏观形状指数δ;以光滑椭圆为基准的颗粒轮廓凹凸度,即微观形状指数ζ。分析和发展了近似椭圆模型。并运用图像分析仪对粉煤灰、水泥样品进行实验。结果表明,粉煤灰颗粒的两个形状指数δ和ζ都大于水泥颗粒。证明粉煤灰颗粒的球形度、表面光滑度优于水泥,而且,随着粒径增大,δ和ζ呈下降趋势,表明磨制颗粒越粗。(?)粒形状越不规则。文中还运用近似椭圆模型再现了颗粒的模拟图像。     

典型煤碳燃烧特性研究和数值模拟

本文以三种典型煤的碳燃烧为研究对象，分别采用简单一维沉降燃烧方式和等温加热燃烧方式，实验研究了煤在快速加热条件下，其碳的初期和中，后期燃烧过程。以实验为基础，建立了煤的碳燃烧模型，变工况数值模拟了煤的碳燃烧过程，揭示了煤不同条件下的单颗粒碳燃烧特性。     

聚酰亚胺的合成法

本文评述了缩聚型聚酰亚胺的主要合成方法和近年来国际上在合成中所做的探索。     

氯苄双羰基化反应动力学模型

氯苄双羰基化反应生成苯丙酮酸钙的过程是一个多相催化反应过程。通过对反应机理的研究,推导出实际操作的等温等压条件下反应动力学方程,并用实验数据加以验证。     

热塑性塑料熔体质量流动速度测量不确定度的评定

本文分析了聚丙烯熔体质量流动速率测量过程中不确定度的来源，并对各不确定度分量进行了评估。该测量过程中所产生的测量不确定度主要来源于测量重复性。     

酚醛树脂热降解动力学研究

用热失重非等温法对不同甲醛,苯酚魔鬼洋比的酚树脂进行了热降解动力学研究。结果表明,甲醛,苯酚摩尔比为１．５时,酚醛树旨的热发活化能最高。耐热性最好。     

剪力对梁变形影响的分析

本文用材料力学的分析方法,导出了一个计入剪力时梁的挠曲线的微分方程式。为了估计剪力对梁变形的影响,在集中力作用下梁内剪力用一个单值连续的反三角函数表示。由能量法确定了截面因子数值之后,定量地给出计入剪力时梁变形的分析结果。其结果和弹性力学的结来是一致的。     

己内酰胺水解聚合过程模拟──双官能团酸调节剂与尼龙6组成分布

提出了有双官能团酸相对分子质量调节剂存在时己内酰胺水解聚合过程动力学模型 ,并进行了实验验证 .对不同温度下聚合产物组成和各影响因素对数均聚合度的影响进行了模拟 .结果表明 ,数均聚合度随进料中水、氨基己酸及相对分子质量调节剂浓度的增加而减小 ,其中水的浓度影响较显著 ,且在考察浓度范围内相对分子质量调节剂浓度 [R]0 ≤ 0 0 0 68mol·kg- 1 时数均聚合度基本不变 ,而 [R]0 >0 0 0 68mol·kg- 1 时数均聚合度则显著减小 .无氨基己酸及相对分子质量调节剂时数均聚合度亦随水浓度增加而减小 .     

HYDRODYNAMIC CHARACTERISTICS OF THE PROCESS OF DEPRESSURIZATION OF SATURATED WATER

Experiments were carried out to find the effects of dissolved gas pressure,liquid flow rateand nozzle geometry on the bubble generation when saturated water was depressurized through anozzle.A new method,high speed camera system was developed to measure the generated microbubblesdynamically.On the basis of the laws of ideal gas and solution,theoretical generated gas flow ratewas deduced,while the Smoluchowski′s equation was applied to describe the kinetics of bubblenucleation.It was found that the size distribution of nucleated bubbles was of skewed distribution.An explanation to this phenomenon was made and the Gamma function distribution was employedfor mathematical simulation.The results show good agreement between the experimental data and thepredictions by proposed model.     

直链烷烃氯磺酰化反应的光催化动力学研究

本系统采用氯气和二氧化硫作为气相原料，C18－17直链烷烃为液相原料，在光作用下进行气相氯磺酰化反应。由于该反应过程机理复杂，本研究采秀工程研究方法，对过程进行合理简化，导得该反应的动力学速率模型，并采用非线性多响应常微分模型的参数估计方法求得模型参数。模型计算值与实验结果能较好吻合，该模型可用于反应器的设计计算。     

ON THE PREDICTION OF HEATS OF VAPORIZATION OF PURE COMPOUNDS

An expression to predict the values of the latent heat of vaporization of pure compounds at their normal boiling point has been developed. A knowledge of the critical temperature, critical pressure, normal boiling point and acentric factor of the compound coupled with the use of generalized correlations for second virial coefficient and liquid molar volume allows to obtain good estimates, particularly for alcohols and ketones. Results for 71 various substances are compared with experimental values and with the results of eight other equations available in the literature. The possibility of using the calculated heats of vaporization at the normal boiling point to estimate values at other temperatures is discussed.