共查询到18条相似文献,搜索用时 609 毫秒
1.
2.
为研究井下瓦斯爆炸诱导沉积煤尘参与爆炸现象,利用独头试验巷道模拟不同体积瓦斯爆炸产生不同诱导强度的冲击气流,并对沉积煤尘的诱导飞扬能力和参与爆炸传播规律进行研究。结果表明:瓦斯爆炸产生的冲击气流能卷扬沉积煤尘飞扬,形成煤尘"二次爆炸",进一步扩大爆炸的伤害范围;当瓦斯区的气体体积从50 m3增加到200 m3时,瓦斯爆炸产生冲击气流在瓦斯段峰值压力从0.14 MPa增加到0.31 MPa,卷扬沉积煤尘的诱导卷扬能力增强;试验测试煤尘段的最大爆炸压力分别达到0.36和0.83 MPa;无煤尘火焰长度分别为75.1和115.2 m,整个爆炸过程朝更迅猛的方向发展。 相似文献
3.
4.
矿井瓦斯煤尘爆炸传播实验研究 总被引:7,自引:0,他引:7
煤矿中瓦斯爆炸容易引起煤尘参与爆炸,且掘进工作面是瓦斯煤尘爆炸事故的多发区域。在与实际矿井环境、几何条件相似的大型地下试验巷道中,进行了独头巷道瓦斯煤尘爆炸火焰、冲击波传播试验。试验中,瓦斯煤尘爆炸火焰到达各测点的时间与测点距离呈对数函数关系;爆炸火焰的传播速度在铺有煤尘段迅速上升,过了煤尘段开始下降;火焰区长度约为煤尘区长度的2倍;爆炸冲击波压力在铺有煤尘段前端降到最低值,然后迅速上升到最大值后下降。实验结论为煤矿隔抑爆装置的研制和安装提供了理论基础。瓦斯煤尘爆炸与单纯瓦斯爆炸相比,最大爆炸压力峰值大,火焰传播速度快;瓦斯煤尘爆炸的威力和破坏程度,要远远大于单纯瓦斯爆炸。因此,在煤矿实施防尘降尘技术,具有十分重要的意义。 相似文献
5.
6.
为了明确瓦斯煤尘爆炸的研究情况,以便更好地服务于煤矿安全生产,对瓦斯煤尘爆炸的研究现状进行了分析。分别从瓦斯煤尘爆炸机理、爆炸特性、爆炸传播规律几个方面,对其理论研究、实验研究和数值模拟研究的进展进行了综合论述。在此基础上,提出了该领域未来的发展趋势。 相似文献
7.
《煤炭学报》2021,46(2)
在全透明有机玻璃管道中,利用同步控制系统、高速摄像系统和高速粒子成像测速系统(PIV),从爆炸超压、火焰传播速度、火焰温度和复合火焰演化规律等方面研究了不同瓦斯爆炸强度条件下诱导沉积煤尘爆炸特性和复合火焰传播特性,并分析了煤尘卷扬湍流特征。实验结果表明:3种工况下,随着甲烷体积分数的增加,爆炸超压和压力上升速率明显增高,压力峰值来临时刻减小,且当体积分数超过8.5%后,压力曲线和压力上升速率曲线出现明显的振荡特征;复合火焰传播速度远大于纯瓦斯爆炸工况,且复合火焰传播速度-位置曲线均呈波动上升特征;甲烷的体积分数越接近当量比,爆炸超压、波前流速、火焰锋面温度及其温度上升速率越高;甲烷体积分数为9.5%和8.5%时,复合火焰呈"倒钩形",之后很快出现火焰加速;而甲烷体积分数降至8.5%后,复合火焰亮度降低,结构呈现破碎和不连续的形态特点。PIV测试表明:甲烷体积分数为9.5%时,初始爆炸强度高,波前流速快,煤粉可随冲击波整体快速运动,卷扬区整体湍流强度较高,大大加快了煤粉与空气的混合速度,促进了卷扬煤粉的燃烧。较高的冲击波波前流速和火焰锋面温度2种参数相结合是造成甲烷/煤尘复合火焰不断加速的原因。 相似文献
8.
9.
采用标准的20 L爆炸球实验装置,研究了3种不同煤质的煤尘及瓦斯煤尘混合物的爆炸特性,获得了不同实验条件下煤尘的爆炸特征参数,并给出了定量评价。研究结果显示:不同煤质特性煤尘的爆炸特性存在显著差异,在实验选定的粉尘浓度范围内,煤尘的爆炸超压及超压的上升速率随粉尘浓度基本呈先增加后降低的变化趋势;随着爆炸环境初始压力的增加,显著延长了煤尘析出的可燃性挥发分气体的火焰发展期,使得煤尘的爆炸参数随初始压力均呈现升高的变化规律;煤尘的爆炸特性随混合物中瓦斯气体的含量呈先增加后降低的趋势,初始少量瓦斯气体的加入显著改善与提高了瓦斯煤尘混合物的爆炸特性,降低了瓦斯煤尘混合物的爆炸下限。采用图像处理的方法对煤尘爆炸产物颗粒表面的结构特性进行了半定量分析,获得了产物颗粒表面的孔隙形状因子及其分布。 相似文献
10.
采用20 L钢制近球形爆炸特性测试系统,对低浓度瓦斯参与条件下、3种不同煤尘的爆炸下限变化规律进行了试验研究。研究发现:在本试验条件下,煤尘的爆炸下限浓度随瓦斯浓度的增加而逐渐下降;当瓦斯浓度在0~1.0%范围内,煤质组成成分对爆炸下限影响较大,相应的瓦斯和煤尘共存的爆炸复合体系表现为"强煤尘"性;当瓦斯浓度大于1%时,煤尘爆炸下限浓度的数值差异不大,煤质成分对煤尘爆炸下限的影响不再明显,相应的瓦斯煤尘共存的复合爆炸体系表现为"强瓦斯"性。 相似文献
11.
Combined with the experimental results from the large tunnel of the Chongqing Research Institute, the mechanism of gas and
coal dust explosion was studied. Some concepts about gas and coal dust explosion were introduced such as the form condition
and influential factors. Gas and coal dust explosion propagation was researched and the lifting process of coal dust was simulated.
When an explosion occurred due to great mixture of gas and air, the maximum explosion pressure appeared in the neighborhood
of the explosion source point. Before it propagated to the tunnel of the deposited coal dust, the maximum explosion pressure
appeared to be in declining trend. Part of the energy was lost in the process of raising the deposited coal dust through a
shock wave, so the maximum explosion pressure was smallest on the foreside of the deposited coal dust sector. On the deposited
coal dust sector, the explosion pressure rapidly increased and dropped off after achieving the largest peak value. Because
of coal dust participation in the explosion, the flame velocity rose rapidly on the deposited coal dust and achieved a basic
stable value; coal dust was ignited to explode by initial laminar flame, and the laminar flame transformed into turbulent
flame. The turbulence transformed the flame fold into a funnel shape and the shock wave interacted with the flame, so the
combustion rate rose and the pressure wave was further enhanced. The regeneration mechanism between the flame combustion rate
and the aerodynamic flowing structure achieved the final critical state for forming the detonation.
Supported by the National Basic Research Program (973) (2005CB221506); National Natural Science Foundation of Chongqing (CSTC,
2007BA6018); National Key Technology R&D Program (2006ABK03B04) 相似文献
12.
The experiment of gas and coal dust explosion propagation in a single laneway was carried out in a large experimental roadway
that is nearly the same with actual environment and geometry conditions. In the experiment, the time when the gas and coal
dust explosion flame reaches test points has a logarithmic function relation with the test point distances. The explosion
flame propagation velocity rises rapidly in the foreside of the coal dust segment and comes down after that. The length of
the flame area is about 2 times that of the original coal dust accumulation area. Shock wave pressure comes down to the rock
bottom in the coal dust segment, then reaches the maximum peak rapidly and comes down. The theoretical basis of the research
and assemble of across or explosion is supplied by the experiment conclusion. Compared with gas explosion, the force and destruction
degree of gas and coal dust explosion is much larger.
Supported by the National Basic Research Program (973) (2005CB221506); the Open Research Fund Program of Shandong University
of Science and Technology (MDPC0611) 相似文献
13.
通过阐述主动喷粉抑爆技术的技术原理,分析总结瓦斯煤尘爆炸传播规律,认为主动喷粉抑爆技术的应用效果主要与抑爆粉剂浓度、主动喷粉抑爆技术装备动作时间及瓦斯煤尘爆炸传播规律有关;并通过大型地下试验巷道,模拟实际应用主动喷粉抑爆技术及装备抑制实际发生的瓦斯煤尘爆炸传播试验,分析了主动喷粉抑爆技术对爆炸火焰及冲击波压力的抑爆效果,验证了主动喷粉抑爆技术能够在爆炸初期抑制瓦斯煤尘爆炸传播。 相似文献
14.
在1.2 m长竖直爆炸管内对不同初始条件下的甲烷-煤粉混合物进行了弱点火火焰传播实验。分别考察了甲烷浓度、煤粉浓度、煤粉粒径以及点火延迟时间对复合爆炸火焰传播特性的影响。结果表明,煤粉的存在使得纯甲烷在空气中爆炸火焰传播速度显著增大,最大火焰传播速度出现在距离点火端0.425 m(长径比等于6)处;火焰传播至长管末端壁面后,爆炸压力达到最大值;甲烷浓度越接近化学当量比,火焰传播速度越快;火焰传播速度随煤粉浓度和点火延迟时间的变化趋势为先增大后减小,最佳煤粉浓度为500 g/m3,最佳点火延迟时间为500 ms;在一定粒径范围内,火焰传播速度随着煤粉粒径的增大而减小。 相似文献
15.
16.
矿井煤尘爆炸事故往往会造成重大人员伤亡和财产损失。为了防止煤尘爆炸发生,研发高效绿色的抑爆材料,整理了国内外关于煤尘爆炸的研究情况,包括煤尘爆炸机理、爆炸特性、爆炸传播规律以及煤尘的抑爆技术,并针对煤尘爆炸方面的研究提出了未来发展趋势。分析结果表明,需对多因素及特殊环境下的煤尘爆炸特性进行深入研究,建立煤尘爆炸过程全景式分子作用机制的爆炸机理,并结合实际矿井环境对煤尘爆炸传播规律进行研究,结合爆炸机理研发新型抑爆材料,从本质上中断爆炸反应过程。 相似文献
17.
18.