新型菲涅尔线聚焦聚光太阳电池组件研究

以聚甲基丙烯酸甲脂为材料,采用热压成型工艺加工成型线聚焦菲涅尔聚光透镜(8×),可用于空间、地面光伏系统太阳电池组件的聚光系统,并对在其聚光条件下,太阳电池的电流电压特性进行测试,结果表明,该菲涅尔线聚焦棱镜能有效提高太阳电池的单位输出功率.模具的机械加工精度和光学抛光精度低,是造成其部分聚光率损失的原因.     

菲涅尔双棱镜折射率和锐角的测量

菲涅尔双棱镜折射率和锐角的测量张雄（云南师范大学物理系昆明６５００９２）用菲涅尔双棱镜测定光波长，是理工科学生的必修实验，在实验中双棱镜的折射率及两个小锐角的数值，均与相邻干涉条纹的间距、两虚光源的间距和位置等有关．本文介绍一种用分光仪测量双棱镜折射...     

菲涅尔太阳能聚光镜的设计

讨论并设计了一种超薄的菲涅尔聚光镜,根据费玛原理设计出以非球面为截面的中心折射区域和T IR(内部全反射)棱镜为锯齿部分的折反区域,用ZEMAX软件优化得到最佳聚光态,并利用ZEMAX软件模拟出菲涅尔聚光镜聚光性及其能量分布,最终得到总厚度仅为30 mm的折反复合型菲涅尔聚光镜。实验结果表明:折反复合型菲涅尔聚光镜不仅能提高太阳能的利用率,同时也使会聚到光电池表面上的能量分布更均匀,复合式菲涅尔聚光镜的性能优于传统的菲涅尔聚光镜。     

用于光伏系统新型菲涅耳线聚焦聚光透镜设计

根据边缘光线原理,优化设计太阳电池及光伏系统的菲涅耳线聚焦聚光透镜.设计光学聚光率为18×,可用于空间、地面光伏系统的聚光系统.分析了其集光角特性,表明该菲涅耳线聚焦棱镜具有大的集光角(±7°).     

干涉方法测菲涅尔双棱镜棱角及玻璃折射率

干涉方法测菲涅尔双棱镜棱角及玻璃折射率麻福厚，张建秋（乌鲁木齐八一农学院基础部乌鲁木齐８３００５２）杨氏双缝，菲涅尔双棱镜等以分割波阵面获得干涉．牛顿环，劈形膜等以分割振幅获得干涉．教学中分波阵面的干涉与分振幅的干涉均以各自独立的实验进行，互不关联．...     

菲涅尔环带放大镜浅析

根据菲涅尔环带放大在镜的结构,分析了放大率,像差等,并说明它的实际应用范围。     

菲涅尔透镜聚光对光伏发电效率的实验研究

介绍了将菲涅尔透镜前置于太阳能电池板适当位置以提高转换效率的实验研究。通过测试单晶硅、多晶硅电池单元加聚焦透镜前、后,以及改变不同入射角度照射单晶硅、多晶硅电池单元对输出伏安特性的影响,得出增加透镜聚光可以有效提升太阳能的转换效率,同时需要保证光源垂直入射。     

使用二元相位菲涅尔波带片产生轴向线聚焦

介绍了一种全新的轴向线聚焦方案.采用菲涅尔波带片，在实验中产生了沿轴向长为5mm，宽 100μm的线聚焦.光学测量表明，线聚焦轴向强度分布比较均匀.这些参数基本上可以满足激 光等离子体实验的要求. 关键词： 菲涅尔波带片 轴向线聚焦     

IPA型菲涅尔全息联想存贮器

本文提出了一种用菲涅尔全息片实现的IPA(Interpattern Association)型联想存贮器。其对不独立的存贮模式有较强的分辨能力,采用菲涅尔全息片,可以实现大神经元数目的光学联想存储,具有较大的存储能力。     

曲面和平面菲涅尔透镜的像差比较

通过一个大尺寸菲涅尔透镜的设计,比较了曲面菲涅尔透镜和平面菲涅尔透镜在光学像差方面的差异。从应用角度看,菲涅尔透镜设计属于准直系统,一般采用平面结构,但由于其成像要求的特殊性,通过运用P-W方法进行分析和比较,结果表明：曲面的设计较之于平面更具优势,并在ZEMAX中分别对2种菲涅尔透镜进行建模,验证了结果的正确性。但这不表明曲面菲涅尔透镜在像差方面一定比平面菲涅尔透镜更具优势,它还与实际应用场合有关,为此,提出了不同的结构参数设计。     

免跟踪透射式太阳聚光器的设计

针对目前太阳聚光器中因为自动跟踪系统故障率高导致使用成本大幅度增加的主要制约因素,在多年来探讨有效提高太阳能密度的基础上,提出了免跟踪线性菲涅尔透射式太阳聚光器设计的新思路,并对其结构形式和工作原理进行了阐述.     

菲涅耳聚光系统下砷化镓电池输出特性研究

对理论聚光比为676的菲涅耳聚光系统下单片砷化镓太阳电池及由六片砷化镓电池的串联组件的输出特性进行分析。建立三结砷化镓电池输出特性的单指数数学模型,并与实验进行了对比。理论计算与实验吻合较好,误差在7.6%以内。实验结果表明,在相同理论聚光比下,单片电池系统能流聚光比为390,六片电池组件系统能流聚光比为281;聚光后单片电池的短路电流与峰值功率分别放大322倍与316倍,六片电池组件系统的短路电流与峰值功率分别放大275倍与272倍;电池表面能流密度为0.321MW/m2时电池的输出功率达到最大,电池表面温度高于323K将影响其工作稳定性;聚光系统的透射率每增加0.01系统效率升高约0.227%。全天累积直射辐照度为17.212MJ/m2条件下测得单片电池全天发电量为0.015kW.h,六片电池串联组件的全天发电量为0.076kW.h。     

Solar pumped Nd:YAG laser

We report the high efficiency of solar pumped laser. The sunlight is concentrated by the concentrator system, which is composed by the Fresnel lens and the cone-channel condenser. The power density of sunlight concentrated by the concentrator system surpasses the lasing threshold for pumping laser. In the experiment, the sunlight concentrated is coupled into the conical chamber pumping Nd:YAG laser media. Laser output of 3.5 W has been achieved; the collect efficiency is 3.5 W/m². The conversion efficiency is 1.0% from solar power into laser, and the slope efficiency is achieved 1.86%.     

High frequency acoustic microscopy with Fresnel zoom lens

The acoustic field distributions and the convergent beams generated by the planar-structure Fresnel zone transducers on solid surface are investigated. Because only 0 and 180 degree phase transducers are used, an imaging system with the Fresnel zoom lens could work at very high frequency, which overcomes the frequency limit of the traditional phased array acoustic imaging system. Simulation results are given to illustrate the acoustic field distributions along the focal axis and the whole plane as well. Based on the principle of scanning of the focus with the change of frequency for the excited signal, an experimental imaging system is also built. Acoustic Fresnel zone transducers are fabricated at center frequency of 400 MHz. Measurements and detections of the known hole flaws at different depths of the fused quartz sample are presented to show that the imaging system with Fresnel zoom lens could move its focus by only changing the frequency of the excited signal.     

Design of off-axis reflective projection lens using spherical Fresnel surface

In this paper, an off-axis reflective projection lens with single Fresnel reflective surface and three aspheric surfaces were designed. The design method of reflective lens using spherical Fresnel surface is discussed. The MTF (Modulation Transfer Function) of the off-axis reflective lens, with optical magnification 100×, F-number 2.5 and field of view 120°, is over 40% at 0.6 lp/mm on the image side, the distortion is less than 2%. This design method can provide reference for application of Fresnel surface in wide field of view imaging, and possesses a bright future with the continuous development of fabrication technique.     

Diffraction of terahertz waves after passing through a Fresnel lens

The spatiotemporal and spectral characteristics of ultrawide-band terahertz pulses after passing through a Fresnel lens are studied by using the scalar diffraction theory. The simulation shows that the transmitted terahertz waveforms compress with increasing propagation distance, and the multi-frequency focusing phenomenon at different focal points is observed. Additionally, the distribution of terahertz fields in a plane perpendicular to the axis is also discussed, and it is found that the diffraction not only induces focusing on-axis but also inhibits focusing at off-axis positions. Therefore, the Fresnel lens may be a useful alternative approach to being a terahertz filter. Moreover, the terahertz pulses travelling as a basic mode of a Gaussian beam are discussed in detail.     

应用反射型球面菲涅耳波带片的成像物镜设计

设计了一种应用球面菲涅耳波带反射面与非球面反射面结合的成像物镜。对球面结构的菲涅耳波带反射面进行分析,推导了球面菲涅耳波带反射面近似替代非球面的方法,采用单片球面菲涅耳波带反射面和三片非球面反射面设计成像物镜,在放大倍数100×、视场角120°、菲涅耳数2.5情况下,调制传递函数在放大成像侧可实现0.6 lp/mm的40%以上,畸变小于2.2%。该设计方法为菲涅耳波带片应用于可见光成像提供了参考,并随着菲涅耳器件加工技术的不断发展具有良好的应用前景。     

Optimum Design of Millimeter-Wave Double-Dielectric Fresnel Zone-Plate Lens and Antenna

The microwave/millimeter-wave Fresnel-zone plate (FZP) lenses differ substantially in construction, technology and applications from their optical analogs and require specific design equations and methods of electromagnetic analysis. In this paper, optimum design equations for double-dielectric lossless FZP lens are derived. The best and worst choices of the permittivity ratio for lossless dielectrics are discussed in detail. In addition, the influence of dielectric losses on the lens thickness for given wavelength and permittivities is examined.Two versions of a 57.5-GHz double-dielectric phase-reversal zone plate are used as focusing elements of FZP lens antenna. The antenna co-polar and cross-polar radiation patterns, aperture efficiency and frequency bandwidth are analyzed numerically and contrasted with those of half-blocked FZP and horn lens antennas.     

用于太阳光泵浦激光器的菲涅耳透镜设计方法

建立并分析了太阳光点聚焦型菲涅耳透镜的理论模型。提出了适用于太阳光泵浦激光器的设计方法。综合考虑会聚总功率和功率密度提高倍数两个因素,合理设计了菲涅耳透镜口径,相对孔径以及环形小棱镜的宽度(环距)三个参数,获得了用于太阳光泵浦激光器的菲涅耳透镜。