Secondary air pollutants

The study has been performed in a supposedly clean-air region of a Northern Finnish forest with a homogeneous stand of Scots pine. Stomatal epicuticular wax layer erosion is described using a classification system of five erosion stages. The percentage of stomatal wax within each erosion stage is calculated and the results are treated statistically, which makes the morphological study of the needle surface semi-quantitative. Severe wax degradation has already been found in the current year, increasing with the age of the needles. In this area, the wax layer erosion is correlated with secondary air pollutants, as analyses have shown high trichloroacetate (TCA) levels in needles from the same trees. The wax layer analyses are in accordance with earlier findings which have demonstrated differences in tolerance to TCA.     

Urban air quality

Since 1950 the world population has more than doubled, and the global number of cars has increased by a factor of 10. In the same period the fraction of people living in urban areas has increased by a factor of 4. In year 2000 this will amount to nearly half of the world population. About 20 urban regions will each have populations above 10 million people.Seen over longer periods, pollution in major cities tends to increase during the built up phase, they pass through a maximum and are then again reduced, as abatement strategies are developed. In the industrialised western world urban air pollution is in some respects in the last stage with effectively reduced levels of sulphur dioxide and soot. In recent decades however, the increasing traffic has switched the attention to nitrogen oxides, organic compounds and small particles. In some cities photochemical air pollution is an important urban problem, but in the northern part of Europe it is a large-scale phenomenon, with ozone levels in urban streets being normally lower than in rural areas. Cities in Eastern Europe have been (and in many cases still are) heavily polluted. After the recent political upheaval, followed by a temporary recession and a subsequent introduction of new technologies, the situation appears to improve. However, the rising number of private cars is an emerging problem. In most developing countries the rapid urbanisation has so far resulted in uncontrolled growth and deteriorating environment. Air pollution levels are here still rising on many fronts.Apart from being sources of local air pollution, urban activities are significant contributors to transboundary pollution and to the rising global concentrations of greenhouse gasses. Attempts to solve urban problems by introducing cleaner, more energy-efficient technologies will generally have a beneficial impact on these large-scale problems. Attempts based on city planning with a spreading of the activities, on the other hand, may generate more traffic and may thus have the opposite effect.     

微环境新风量的检测原理及方法研究

新风量是评价室内微环境空气卫生质量的主要卫生指标之一,也是计算室内某种气体单位时间排放量的重要参数。以CO2作为示踪气体,利用于冰升华和人体呼吸产生CO2示踪气体两种测量方法对室内和车内微环境进行了检测,并考虑室内人呼出CO2量的影响,运用箱子模式的各种推导公式（稳态法、解析解法和差分法）对新风量进行了计算,并对结果进行了讨论。结果表明,没有人存在下,用箱子模式的解析解法和差分法计算的新风量值没有明显的统计差异;微环境内有人时必须考虑人释放的影响,这样箱子模式的各种推导公式都可以计算新风量值,且结果准确,准确度高。利用人体呼吸产生CO2示踪气体法,用差分法计算结果不理想,偏差很大;用稳态法计算重现性高,结果可靠。     

Removal of ammonia from contaminated air by trickle bed air biofilters

A trickle bed air biofilter (TBAB) was evaluated for the oxidation of NH3 from an airstream. Six-millimeter Celite pellets (R-635) were used for the biological attachment medium. The efficiency of the biofilter in oxidizing NH3 was evaluated using NH3 loading rates as high as 48 mol NH3/m3 hr and empty-bed residence times (EBRTs) as low as 1 min. Excess biomass was controlled through periodic backwashing of the biofilter with water at a rate sufficient to fluidize the medium. The main goal was to demonstrate that high removal efficiencies could be sustained over long periods of operation. Ammonia oxidation efficiencies in excess of 99% were consistently achieved when the pH of the liquid nutrient feed was maintained at 8.5. Quick recovery of the biofilter after backwashing was observed after only 20 min. Evaluation of biofilter performance with depth revealed that NH3 did not persist in the gas phase beyond 0.3 m into the depth of the medium (26% of total medium depth).     

Wet air oxidation and catalytic wet air oxidation for dyes degradation

Background, aim, and scope  

Textile industry produces wastewater which contributes to water pollution since it utilizes a lot of chemicals. Preliminary studies show that the wastewater from textile industries contains grease, wax, surfactant, and dyes. The objective of this study was to determine the treatment efficiency of the nickel catalysts supported on hydrotalcites in three-dye model compounds and two types of wastewater.     

Assessment of air quality benefits from national air pollution control policies in China. Part II: Evaluation of air quality predictions and air quality benefits assessment

Following the meteorological evaluation in Part I, this Part II paper presents the statistical evaluation of air quality predictions by the U.S. Environmental Protection Agency (U.S. EPA)’s Community Multi-Scale Air Quality (Models-3/CMAQ) model for the four simulated months in the base year 2005. The surface predictions were evaluated using the Air Pollution Index (API) data published by the China Ministry of Environmental Protection (MEP) for 31 capital cities and daily fine particulate matter (PM_2.5, particles with aerodiameter less than or equal to 2.5 μm) observations of an individual site in Tsinghua University (THU). To overcome the shortage in surface observations, satellite data are used to assess the column predictions including tropospheric nitrogen dioxide (NO₂) column abundance and aerosol optical depth (AOD). The result shows that CMAQ gives reasonably good predictions for the air quality.The air quality improvement that would result from the targeted sulfur dioxide (SO₂) and nitrogen oxides (NO_x) emission controls in China were assessed for the objective year 2010. The results show that the emission controls can lead to significant air quality benefits. SO₂ concentrations in highly polluted areas of East China in 2010 are estimated to be decreased by 30–60% compared to the levels in the 2010 Business-As-Usual (BAU) case. The annual PM_2.5 can also decline by 3–15 μg m^?3 (4–25%) due to the lower SO₂ and sulfate concentrations. If similar controls are implemented for NO_x emissions, NO_x concentrations are estimated to decrease by 30–60% as compared with the 2010 BAU scenario. The annual mean PM_2.5 concentrations will also decline by 2–14 μg m^?3 (3–12%). In addition, the number of ozone (O₃) non-attainment areas in the northern China is projected to be much lower, with the maximum 1-h average O₃ concentrations in the summer reduced by 8–30 ppb.     

Performance analysis of photovoltaic-thermal air collectors combined with a water to air heat exchanger for renewed air conditioning in building

Environmental Science and Pollution Research - In this work, a new solar system that includes photovoltaic-thermal (PVT) air collectors coupled to a water-to-air heat exchanger is investigated. The...     

Evaluation of air quality zone classification methods based on ambient air concentration exposure

Air quality zones are used by regulatory authorities to implement ambient air standards in order to protect human health. Air quality measurements at discrete air monitoring stations are critical tools to determine whether an air quality zone complies with local air quality standards or is noncompliant. This study presents a novel approach for evaluation of air quality zone classification methods by breaking the concentration distribution of a pollutant measured at an air monitoring station into compliance and exceedance probability density functions (PDFs) and then using Monte Carlo analysis with the Central Limit Theorem to estimate long-term exposure. The purpose of this paper is to compare the risk associated with selecting one ambient air classification approach over another by testing the possible exposure an individual living within a zone may face. The chronic daily intake (CDI) is utilized to compare different pollutant exposures over the classification duration of 3 years between two classification methods. Historical data collected from air monitoring stations in Kuwait are used to build representative models of 1-hr NO₂ and 8-hr O₃ within a zone that meets the compliance requirements of each method. The first method, the “3 Strike” method, is a conservative approach based on a winner-take-all approach common with most compliance classification methods, while the second, the 99% Rule method, allows for more robust analyses and incorporates long-term trends. A Monte Carlo analysis is used to model the CDI for each pollutant and each method with the zone at a single station and with multiple stations. The model assumes that the zone is already in compliance with air quality standards over the 3 years under the different classification methodologies. The model shows that while the CDI of the two methods differs by 2.7% over the exposure period for the single station case, the large number of samples taken over the duration period impacts the sensitivity of the statistical tests, causing the null hypothesis to fail. Local air quality managers can use either methodology to classify the compliance of an air zone, but must accept that the 99% Rule method may cause exposures that are statistically more significant than the 3 Strike method.

Implications: A novel method using the Central Limit Theorem and Monte Carlo analysis is used to directly compare different air standard compliance classification methods by estimating the chronic daily intake of pollutants. This method allows air quality managers to rapidly see how individual classification methods may impact individual population groups, as well as to evaluate different pollutants based on dosage and exposure when complete health impacts are not known.     

采用Design-Expert软件优化高频气力分选机风量配合设计

采用Design-Expert 7.1.3软件对高频气力分选机的3个风量进行试验方案设计和结果分析.结果表明:在其他操作条件一定的前提下,3个风量对分选效率的影响均为显著;采用Design-Expert 7.1.3软件对3个风量进行正交试验设计,可以有效分析3个风量对高频气力分选机分选效率的影响,并通过试验结果分析建立数学模型,最终得到满足试验要求的风量配合比,最优风量配合比为55∶60∶80.     

Sequential box models for indoor air quality: Application to airliner cabin air quality

In this paper we present the development and application of a model for indoor air quality. The model represents a departure from the standard box models typically used for indoor environments which has applicability in residences and office buildings. The model has been developed for a physical system consisting of sequential compartments which communicate only with adjacent compartments. Each compartment may contain various source and sink terms for a pollutant as well as leakage, and air transfer from adjacent compartments. The mathematical derivation affords rapid calculation of equilibrium concentrations in an essentially unlimited number of compartments. The model has been applied to air quality in the passenger cabin of three commercial aircraft. Simulations have been performed for environmental tobacco smoke (ETS) under two scenarios, CO₂ and water vapor. Additionally, concentrations in one aircraft have been simulated under conditions different from the standard configuration. Results of the simulations suggest the potential for elevated concentrations of ETS in smoking sections of non-air-recirculating aircraft and throughout the aircraft when air is recirculated. Concentrations of CO₂ and water vapor are consistent with expected results. We conclude that this model may be a useful tool in understanding indoor air quality in general and on aircraft in particular.     

interpretation of air quality data with respect to the national ambient air quality standards

San Diego Gas &; Electric has developed a quality assurance program for continuous emission monitors (CEM). Extractive, rather than in situ, monitors were selected as a result of an in-house evaluation program. Two extractive systems have been certified and a good operating and maintenance record has been established on these systems. A successful program requires the involvement and support of all affected personnel. It is desirable to have one or two key personnel coordinate the development of the program. It is also highly desirable to have good in-house source testing capabilities.