初始频率啁啾的高斯光脉冲在线性色散光纤中的传播

研究了线性光纤中色散导致初始频率啁啾的高斯光脉冲展宽的详细物理过程,以此为光纤中光孤子产生的物理过程做准备。     

频率啁啾高斯光脉冲在线性色散光纤中的传播

研究了线性光纤中色散导致初始频率啁啾的高斯光脉冲展宽的详细物理过程。     

啁啾高斯脉冲在光纤中传输的脉冲展宽研究

通过求解非线性薛定谔方程,研究了线性光纤中色散导致的具有初始频率啁啾的高斯脉冲展宽的详细物理过程。得到高斯脉冲在光纤中色散所致的脉冲展宽的特性,啁啾因子对脉冲展宽的影响,并讨论了光纤色散对不同宽度脉）中的影响,对色散补偿等技术的研究具有一定的参考价值。     

无初始啁啾高斯光脉冲的色散展宽及色散补偿

对无初始啁啾高斯脉冲在普通单模光纤中的传输特性及线性啁啾光纤光栅的色散补偿特性进行了理论分析和数值模拟。结果表明,光纤的色散导致了传输脉冲的展宽,线性啁啾光纤光栅能够实现对展宽脉冲的良好补偿,啁啾光栅时延曲线的平滑度和线性度都是影响其色散补偿性能的重要因素。本文对啁啾光纤光栅的制作及其在色散补偿中的应用有一定的指导意义。     

采用啁啾光纤光栅补偿带啁啾的超高斯脉冲在光纤中传输的色散

利用啁啾光纤光栅,对带啁啾的超高斯脉冲的色散补偿特性进行了理论分析和数值模拟。数值模拟结果表明,光脉冲在普通单模光纤中传输了一定距离后,由于色散的作用,脉冲发生展宽,超高斯脉冲比高斯脉冲展得更宽。若初始脉冲含有啁啾,展宽后的脉冲还出现小调制。用啁啾光纤光栅进行色散补偿后,高斯型脉冲能够较好的恢复初始脉冲形状,带啁啾的超高斯脉冲的脉宽可恢复到接近初始脉冲的宽度,但脉冲形状发生了畸变,并出现了旁瓣,脉冲峰值功率与超高斯脉冲阶数和啁啾参数有关。     

预啁啾对偏复用孤子技术的补偿

在导出自相位调制和交叉相位调制共同作用所致相位调制频率啁啾的基础上,数值研究了相位调制频率啁啾与初始啁啾的关系,并对有和无初始啁啾40Gbit/s归零码(RZ)在二阶和三阶色散完全补偿(路径平均色散为0)的色散管理偏振复用孤子传输系统中的传输效果进行计算。结果表明,在输入功率达到一定值时,初始啁啾参量C对相位调制频率啁啾的作用,决定着系统偏振复用孤子技术的成效及传输性能,适当选取初始啁啾参量C能够有效抑制偏振模色散,提高孤子脉冲稳定传输距离。     

色散缓变光纤中的脉冲宽度研究

计算了高斯型脉冲宽度在色散缓变光纤中的传播特性和初始啁啾对脉宽演变的影响。讨论发现与单模光纤相比，色散缓变光纤中脉冲展宽较慢，并能有效抑制脉冲展宽；初始啁啾对脉宽有较大影响，初始啁啾参量C过大会造成脉冲严重展宽。     

啁啾指数脉冲的非线性传输研究

数值研究了初始线性啁啾指数光脉冲在单模光纤反常色散区的非线性传输特性,并将这种特性与双曲正割脉冲的相关特性作了比较.脉冲振幅A=1时,负啁啾对脉冲时域宽度展宽的影响比正啁啾大;指数脉冲受啁啾影响比双曲正割脉冲更敏感.A＞1.2时,脉宽在演化过程中呈周期性衰减振荡,振荡周期和振幅随啁啾|C|(|C|≤2)的增大而增大,最后能演化成光孤子.脉冲演化成光孤子所需的最小振幅A比啁啾双曲正割脉冲的大.     

光参量效应中低阶色散对超短高斯脉冲展宽的影响

以宽度为50 fs的超短脉冲和负单轴晶体CsLiB6O10(CLBO)为例,对非线性光学晶体中低阶群速度色散(GVD)导致的超短高斯脉冲和超高斯脉冲的脉冲展宽进行了理论分析.在光参量相互作用过程中,对初始无啁啾和有啁啾调制的超短高斯脉冲的脉冲展宽机制和因素进行了数值计算,得出群速度色散导致超短脉冲的寻常光比非寻常光脉冲展宽更严重;波长越短,脉冲展宽越大;当晶体长度等于色散长度时,脉冲宽度增加为初始时的2倍,色散长度越短,超短脉冲展宽越明显.     

超高斯啁啾光脉冲在单模光纤中传输的演化行为

本文从激光脉冲在单模光纤中传输所满足的非线性薛定谔方程出发,通过分步傅里叶变换方法,数值研究了超高斯啁啾光脉冲在单模光纤中脉冲形状的演化.研究表明,超高斯脉冲在单模光纤中传输将经历一个从近平顶、多峰、最后到单峰的演变过程,且高阶色散将引起脉冲形状发生畸变;在GVD和SPM效应的共同作用下,无啁啾的超高斯脉冲在特定条件下将出现孤子演变,具有正啁啾的超高斯脉冲在传输的初始阶段,脉冲形状的变化非常剧烈,而由于负初始啁啾减弱了非线性与色散效应引起的频率啁啾,所以其脉冲波形的变化平缓一些.研究表明,SPM产生的啁啾对入射脉冲的初始啁啾有一定的补偿作用.     

Cost-effective test solutions for smart card and other integrated flash applications

From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.     

An improved parallel thinning algorithm with two subiterations

The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.     

Theoretical analysis of the relationship between the Brillouin gain coefficient and the strain in the optical-fiber sensors

The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.     

Novel fiber-optical interferometer with miniaturized probe for in-hole measurements

Today, micro-system technology and the development of new MEMS （Micro-Electro-Mechanical Systems） are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.     

Teleportation of an arbitrary unknown N-qubit entangled state under the controlling of M controllers

A new quantum protocol to teleport an arbitrary unknown N-qubit entangled state from a sender to a fixed receiver under M controllers(M < N) is proposed. The quantum resources required are M non-maximally entangled Greenberger-Home-Zeilinger (GHZ) state and N-M non-maximally entangled Einstein-Podolsky-Rosen (EPR) pairs. The sender performs N generalized Bell-state measurements on the 2N particles. Controllers take M single-particle measurement along x-axis, and the receiver needs to introduce one auxiliary two-level particle to extract quantum information probabilistically with the fidelity unit if controllers cooperate with it.     

Diode-end-pumped Nd:YVO4/LBO lasers with 4.2W continuous-wave output at 457 nm

A continuous-wave (CW) 457 nm blue laser operating at the power of 4.2 W is demonstrated by using a fiber coupled laser diode module pumped Nd: YVO4 and using LBO as the intra-cavity SHG crystal With the optimization of laser cavity and crystal parameters, the laser operates at a very high efficiency. When the pumping power is about 31 W, the output at 457nm reaches 4.2 W, and the optical to optical conversion efficiency is about 13.5% accordingly. The stability of the out putpower is better than 1.2% for 8 h continuously working.     

Call for Papers

正Wireless Body-area Networks The last decade has witnessed the convergence of three giant worlds:electronics,computer science and telecommunications.The next decade should follow this convergence in most of our activities with the generalization of sensor networks.In particular with the progress in medicine,people live longer and the aging of population will push the development of wireless personal networks     

Call for Papers—Feature Topic,Vol.12,No.7,2015

正Information Centric Networking Information-Centric Networking(ICN) is an emerging direction in Future Internet architecture research,gaining significant tractions among academia and industry.Aiming to replace the conventional host-to-host communication model by a data-centric model,ICN treats data content as the first     

JOURNAL OF ELECTRONICS(CHINA)

正~~     

NEXT GENERATION WIRELESS NETWORKS–ESPECIALLY THE USE OF MILLI-MICROWAVE BANDS

The global bandwidth shortage of wireless communications has motivated the exploration of the naillimeter wave （ram-wave） frequency spectrum for the next generation wireless communications. Recent advances in RF CMOS technology and high speed baseband signal processing technologies have enabled tile extensive research and development of turn-wave wireless communications. The multi gigabit per second data rate of ram-wave system will lead to applications in many important scenarios, such as WPAN, WLAN,back-haul for cellular system. And the frequency bands include 28 GHz, 38 GHz, 45GHz, 60GHz, E-BAND and even beyond 100 GHz. The propagation and the imitation of the RF circuits design in these frequency bands make the directional antennas be inevitable for mm-wave communications.