Adsorption of Malachite Green from Aqueous Solution Using Hydroxyethyl Starch Hydrogel Improved by Graphene Oxide

Journal of Polymers and the Environment - This study is the first report of the preparation of hydroxyethyl starch (HES) hydrogels rapidly crosslinked with divinyl sulfone in a single step and...     

Bisphenol A Adsorption from Aqueous Solution Using Graphene Oxide-Alginate Beads

Journal of Polymers and the Environment - In this study, the potential of graphene oxide-alginate beads (GO-AB) as an adsorbent for bisphenol A (BPA) removal from aqueous solution was investigated....     

Removal of Heavy Metals from Aqueous Solution Using Starch Nanocrystals

Journal of Polymers and the Environment - In this paper, the starch nanocrystals (SNCs) were prepared by enzymatic pre-hydrolysis combined with sulfuric acid hydrolysis and used to remove the heavy...     

花生壳活性炭吸附溶液中的铀

以农林废弃物花生壳为原料、氢氧化钾为活化剂、微波为热源,制备了花生壳活性炭。以花生壳活性炭为吸附剂吸附溶液中的U(VI),考察了初始U(VI)质量浓度、活性炭加入量、溶液pH、吸附时间对U(VI)去除效果的影响。实验结果表明,在溶液中初始U(VI)质量浓度为30mg/L、活性炭加入量为0.5g/L、溶液pH为5.5、吸附时间为150min的较佳条件下,活性炭对U(VI)的吸附量为56.37mg/g,U(VI)去除率为93.94％。     

失效磷酸基化学抛光液的再生

采用氟铝酸钠沉淀法去除失效磷酸基化学抛光液中的铝杂质,并对溶液再生利用的工艺条件进行了研究.实验结果表明,在氢氧化钠和氢氟酸加入量与理论值的比均为1.2(即n(氢氧化钠):n(Al~(3+)):2:1、n(氢氟酸):n(Al~(3+))=28:5)的条件下,采用二步法过滤后,抛光液中磷酸质量分数大于50%,磷酸回收率为79.5%,Al~(3+)去除率为97.1%,剩余Al~(3+)质量分数为0.05%.滤渣经处理后成为新的有价物质,滤液在补加磷酸和其他有效成分后可再生循环使用.     

中孔活性炭对水溶液中Cr3+的吸附

采用模板法和氢氧化钾化学活化法制备出不同中孔率的中孔活性炭并用于水中Cr3+的静态吸附,探讨了中孔活性炭吸附Cr3+的影响因素.实验结果表明,当溶液pH为6.0、吸附温度为50℃、吸附时间为120min、活性炭加入量为2.0g/L以及活性炭中孔率为80.0％～90.0％时.中孔活性炭对溶液中Cr3+的去除率达到98.5％.分别采用Langmuir和Freundlich方程拟合活性炭对Cr3+吸附的等温线,发现Langmuir等温吸附模型对活性炭吸附Cr3+拟合程度更好.活性炭中孔率的增大有利于提高Cr3+的平衡吸附量,但同时还受到活性炭表面酸总量的影响.吸附Cr3+前、后活性炭的FTIR谱图表明,Cr3+与活性炭表面含氧官能团发生了离子交换反应.     

pH Mediated L-cysteine Aqueous Solution for Wool Reduction and Urea-Free Keratin Extraction

Journal of Polymers and the Environment - Regenerated keratin from waste wool is one of the most critical modern biomaterials due to its intrinsic biodegradability, biocompatibility, and mechanical...     

Removal of Linear and Branched p-Alkylphenols from Aqueous Solution by Combined Use of melB Tyrosinase and Chitosan Beads

In this study, melB tyrosinase was applied for enzymatic removal of linear and branched p-alkylphenols from aqueous solutions. First, systematic studies were carried out to estimate the effects of the process parameters such as the temperature, pH value, and enzyme dose on quinone conversion of p-cresol as a model phenol compound. A variety of p-alkylphenols were removed from aqueous solutions through the tyrosinase-catalyzed quinone conversion and subsequent nonenzymatic adsorption of quinone derivatives on chitosan beads at pH 6.0 and 30 °C under the optimum conditions determined for p-cresol. The % removal values of 98–100 were obtained for p-n-alkylphenols. Branched p-alkylphenols with a weak estrogenic activity containing 4-tert-butylphenol and 4-tert-pentylphenol, which underwent no quinone conversion by commercially available mushroom tyrosinase in the absence of H₂O₂, were also effectively removed by further increasing either the melB tyrosinase concentration or the amount of added chitosan beads. The present technique is much effective in the fact that a series of reactions rapidly progress under mild conditions and the chitosan beads can be readily separated from the reaction medium after the enzymatic treatment.     

Properties of Glauconite/Polyaniline Composite Prepared in Aqueous Solution of Citric Acid

Hybrid composite made of glauconite and polyaniline was prepared in aqueous solution of citric acid. Scanning electron microscopy combined with energy dispersive X-ray analysis shows uniform aggregates made of glauconite microparticles and polyaniline matrix. The results of X-ray powder diffraction suggest that: (1) citric acid used for the polymerisation of aniline causes formation of emeraldine salt where macromolecular ordering in the amorphous polymer takes place; (2) no chemical interaction between glauconite and emeraldine takes place in the prepared composite. FT-IR spectra of the prepared polymer and composite show features indicating all the functional groups that are present in the diiminoquinone–diaminobenzene state of polyaniline. Thermal stability of the composite was higher than the prepared polymer suggesting the occurrence of an interphase interaction between glauconite and emeraldine. After pyrolysis in purified nitrogen the composite still remained glauconite, and ε-Fe3N together with amorphous and graphitic carbon were found as reaction products. The values of electrical conductivity and magnetization of the composite suggest that optimization of these values might be achieved based upon the relationship between glauconite and polyaniline.     

从水溶液中分离回收醋酸方法的评述

评述了从水溶液中分离回收醋酸的普通精馏法、共沸精馏法、酯化法和溶剂萃取法，具体分析了各种方法 特点及适用范围。建议在工业上对较高浓度的醋酸用低沸点溶剂萃取－共沸精馏联合法，对低浓度醋酸溶液采用有机胺溶剂萃取法进行分离。     

日光/H2O2/草酸铁络合物光解水溶液中的直接耐酸大红

以H2O2/草酸铁络合物作光氧化剂,利用太阳光对水溶液中的直接耐酸大红进行了光氧化降解试验研究。结果表明,在日光照射下,H2O2/草酸铁络合物能使溶液中直接耐酸大红迅速光解,晴天光照15min或阴天光照30-40min,溶液（直接耐酸大红的质量浓度为50mg/L）可褪至无色;溶液的初始pH对染料光解有显著影响;pH为2-4时光解效果最佳;提高H2O2浓度可以提高光解速率,但H2O2的利用率会降低。     

臭氧氧化—A/O工艺处理PVA废水

采用臭氧氧化—A/O工艺处理聚乙烯醇（PVA）废水,研究了臭氧氧化时间、臭氧流量以及废水pH等因素对臭氧氧化效果的影响。实验结果表明：当气体臭氧质量浓度为30 mg/L、臭氧氧化时间为45 min、臭氧流量为4 L/min、废水pH为8时,PVA质量浓度从进水的93.2 mg/L降至4.5 mg/L;PVA溶液的BOD₅/COD从0.014增加至0.310,可生化性明显改善;臭氧氧化—A/O工艺处理后出水COD降至50 mg/L左右,达到GB 8978—1996《污水综合排放标准》中的一级排放标准;出水PVA质量浓度为1.6 mg/L,明显优于A/O工艺（33.1 mg/L）。     

Biodegradation by Composting of Surface Modified Starch and PVA Blended Films

Several starch/PVA/glycerol polymer blends were prepared by a solution casting technique and examined for biodegradation by composting over 45 days. Within this time frame, the starch and glycerol components were fully degraded, leaving the PVA component essentially intact. The lowest PVA content film (20%) was selected as a polymer with enough PVA to impart important physical characteristics, but also enough starch to be considered biodegradable. The film characteristics were further improved by surface modification with chitosan. This modification did not interfere with the biodegradation of the starch component. Furthermore, there was slight evidence that PVA biodegradation had been initiated in composted, surface modified starch/PVA blends.     

Preparation of Lignin Sulfonate Based/Organo-Montmorillonite Composite Hydrogel for Adsorbing Methylene Blue from Aqueous Solution

Journal of Polymers and the Environment - In this study, an environmentally friendly lignin-based hybrid hydrogel (LS/OMMT) was prepared by grafting of acrylamide (AM) and acrylic acid (AA) onto...     

污泥活性炭的制备及其对溶液中Cr6+的吸附

以城市污水厂剩余污泥为原料,采用ZnCl2作活化剂,热解制备污泥活性炭。实验结果表明,制备污泥活性炭的最佳条件热解温度为550℃,ZnCl2溶液浓度为3mol／L,ZnCl2溶液体积与污泥质量比（mL／g）为2．5：1,热解时间为25min。用所制备的污泥活性炭吸附溶液中的Cr6＋最佳吸附条件为：吸附时间90min,Cr6＋初始质量浓度50mg／L,污泥活性炭加入量0．2g,溶液pH2,在此条件下,Cr6＋去除率达99．9％。污泥活性炭对溶液中Cr6＋的吸附等温线属于I型,等温吸附方程可用Langmuir模型和Freundlich模型来拟合。     

Facile Preparation of Chitosan Films for High Performance Removal of Reactive Blue 19 Dye from Aqueous Solution

This study aimed at finding effective strategies for high-performance removal of reactive blue 19 (RB19) dye from aqueous solution. Chitosan (CS) films had been prepared by using solvent casting with mild drying for this purpose. The CS films were characterized by X-ray diffraction, field-emission scanning electron microscopy, and Fourier transform infrared (FTIR) spectroscopy. The performance of RB19 removal using CS were evaluated by varying contact time, solution pH, initial dye concentration, and adsorbent dosage. Adsorption isotherms, kinetics, and desorption were investigated by batch experiments. Results showed that CS films exhibited the optimal adsorption performance for RB19 removal and high maximum adsorption capacities of RB19, which were 799 and 822.4 mg g^?1 at 20 and 40 °C, respectively. Adsorption kinetic data were well described by the pseudo-second-order kinetic model. FTIR analyses further indicated that interactions between RB19 and the CS film occurred during adsorption. The CS films also exhibited satisfactory desorption of RB19 at about 80 % after 30 min of desorption at pH 11. Our study demonstrated that the CS films can be easily prepared and applied for effective removal of RB19 in treatment of wastewater.     

Highly Efficient Removal of Uranium(VI) From Aqueous Solution Using the Polyethyleneimine Modified Magnetic Chitosan

Journal of Polymers and the Environment - In this study, Polyethyleneimine modified magnetic chitosan (MCS-PEI) was synthesized by grafting polyethyleneimine onto chitosan and adding magnetic Fe3O4...     

Removal of Methylene Blue Dye from Aqueous Solution using PDADMAC Modified ZSM-5 Zeolite as a Novel Adsorbent

Journal of Polymers and the Environment - In the present work, we modified ZSM-5 zeolite using a bio polymer poly (diallyl dimethyl ammonium chloride) and employed it for the removal of cationic...     

日光/H2O2/草酸铁络合物光解水溶液中的直接耐酸大红

以H     

Diethylenetriaminepentaacetic Acid (DPTA)-modified Magnetic Cellulose Nanocrystals can Efficiently Remove Pb(II) from Aqueous Solution

Journal of Polymers and the Environment - Surface modification of cellulose nanocrystals (CNC) is essential for improving their reactivity and adsorption capacity. Oxidation, as a conventional...