永磁同步电机直接转矩控制系统的仿真研究

文章分析了永磁同步电机直接转矩控制的原理,阐述传统直接转矩控制系统转矩脉动的缺点,本文将空间矢量脉宽调制技术引入永磁同步电机的直接转矩控制系统中,利用空间矢量的调制过程,可在相同的系统硬件条件下得到更多的、连续的电压空间矢量,进而得到对电机更准确的控制。仿真结果表明,该方案既保持了直接转矩控制快速动态响应,又减小了电机转矩的脉动。     

基于SVPWM的永磁同步电机直接转矩控制系统的建模与仿真

文章介绍了永磁同步电机直接转矩控制的原理,分析了传统直接转矩控制系统转矩脉动的缺点,并且将空间矢量脉宽调制技术引入永磁同步电机的直接转矩控制系统中,利用空间矢量的调制过程,可在相同的系统硬件条件下得到更多的、连续的电压空间矢量,进而得到对电机更准确的控制。仿真结果表明,该方案既保持了直接转矩控制快速动态响应,又减小了电机转矩的脉动。     

基于空间矢量调制的PMSM直接转矩控制研究

针对传统的直接转矩控制（DTC）出现的开关频率不恒定,磁链和转矩脉动大的问题,提出一种基于空间矢量调制的直接转矩控制（SVM-DTC）方法。该方法集合了直接转矩控制响应快、矢量控制连续平滑的优点,以永磁同步电机（PMSM）数学模型为基础,建立转矩、磁链双闭环PI控制回路。采用空间电压矢量调制策略,将转矩和磁链作为控制量。仿真结果表明,相对于传统的直接转矩控制,基于空间矢量调制的直接转矩控制方案的开关频率恒定,转矩、磁链脉动小,系统具有良好的动、静态性能,验证了该方法的可行性和有效性。     

基于TMS320LF2407的永磁同步电机直接转矩控制

直接转矩控制是一种高性能的电机控制方法,它根据磁通和转矩的要求,直接选择逆变器的开头顺序,使电机在最佳状态下运行。本文提出了一套基于TMS320LF2407DSP的永磁同步电机直接转矩控制系统的设计方案,介绍了其硬件结构、控制策略及软件设计,并建立永磁同步电机的数学模型,计算出定子电压、磁链、转矩方程。在此基础上,通过仿真实验分析比较了基本电压矢量直接转矩控制和矢量细分直接转矩控制的原理,实验结果表明该方案合理、结构通用,能够满足系统的各项要求指标。     

基于MRAS的永磁同步电机直接转矩控制系统的研究

研究了一种基于模型参考自适应无速度传感器的永磁同步电机直接转矩控制系统:将永磁同步电机的磁链模型作为参考模型,估算的定子磁链模型作为可调模型,设计了自适应定律对电机的转速与定子电阻同时进行跟踪辨识,使用空间电压矢量调制技术组成了永磁同步电机无速度传感器直接转矩控制系统。仿真实验结果表明该系统获得了近似圆形的定子磁链,在转速与转矩变化时均能准确的估算出电机转速,具有良好的动、静态性能。     

基于滑模控制的永磁同步电机直接转矩控制研究

针对永磁同步电机直接转矩控制(DTC)存在较大的电磁转矩脉动、磁链脉动、低速性能不理想等问题,文中引入滑模控制策略对永磁同步电机进行直接转矩控制。通过建立PMSM的矢量数学模型,设计基于滑模控制的直接转矩控制器,利用MATLAB/Simulink进行建模仿真分析。结果表明,与传统DTC相比,基于滑模控制策略的永磁同步电机直接转矩控制系统中电磁转矩脉动幅值更低,且具有更好的动态性能和抗扰动能力,可以更加有效地改善系统特性,满足实际电机控制的需要。     

一种新型永磁同步电动机的直接转矩控制方法

基于永磁同步电动机的转矩和磁链方程，介绍了一种改进的直接转矩控制方法。在该控制方法中，引入了一种新的电压空间矢量调制技术，这种调制技术的特点是把电动机的转速作为开关表的一个输入量，实现了定子电压空间矢量的精确选择，有效的降低了转矩、定子磁链和定子电流的波动。仿真实验结果验证了这种控制方法的有效性。     

内置式永磁同步电机直接转矩控制的仿真研究

在永磁同步电机直接转矩控制系统的基础上,分析了内置式永磁同步电机的最大转矩电流比动态磁链控制。设计了基于SVPWM的磁链给定的直接转矩控制系统,通过电压空间矢量连续调节,减小了直接转矩中转矩脉动。在MATLAB/SIMULINK仿真模型下,对该系统进行仿真,验证控制系统的有效性。     

基于SVPWM的永磁同步电机直接转矩控制系统的研究

将空间矢量脉宽调制技术(SVPWM)引入到了永磁同步电机的直接转矩控制(DTC)当中,实现了电压空间矢量的连续调节。定子磁链近似为圆形,有效地解决了常规DTC系统电磁转矩脉动较大的问题。在MATLAB/Simulink环境下搭建了永磁同步电机基于SVPWM的直接转矩控制系统的模型,对电机的多种运行状态进行了仿真,验证了控制理论的正确性和有效性。     

基于扩展滑膜控制器的PMSM无速度传感器研究

本文设计了一种基于永磁同步电机（PMSM）直接转矩控制（DTC）的扩展滑膜观测器,通过测量定子电压与电流,获得电机的转速和转子位置。MATLAB仿真结果表明,扩展的滑膜观测器在空间矢量电压直接转矩控制（SVPWM-DTC）中,所得转速更接近实际转速。     

Cost-effective test solutions for smart card and other integrated flash applications

From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.     

An improved parallel thinning algorithm with two subiterations

The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.     

Theoretical analysis of the relationship between the Brillouin gain coefficient and the strain in the optical-fiber sensors

The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.     

Novel fiber-optical interferometer with miniaturized probe for in-hole measurements

Today, micro-system technology and the development of new MEMS （Micro-Electro-Mechanical Systems） are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.     

Teleportation of an arbitrary unknown N-qubit entangled state under the controlling of M controllers

A new quantum protocol to teleport an arbitrary unknown N-qubit entangled state from a sender to a fixed receiver under M controllers(M < N) is proposed. The quantum resources required are M non-maximally entangled Greenberger-Home-Zeilinger (GHZ) state and N-M non-maximally entangled Einstein-Podolsky-Rosen (EPR) pairs. The sender performs N generalized Bell-state measurements on the 2N particles. Controllers take M single-particle measurement along x-axis, and the receiver needs to introduce one auxiliary two-level particle to extract quantum information probabilistically with the fidelity unit if controllers cooperate with it.     

Diode-end-pumped Nd:YVO4/LBO lasers with 4.2W continuous-wave output at 457 nm

A continuous-wave (CW) 457 nm blue laser operating at the power of 4.2 W is demonstrated by using a fiber coupled laser diode module pumped Nd: YVO4 and using LBO as the intra-cavity SHG crystal With the optimization of laser cavity and crystal parameters, the laser operates at a very high efficiency. When the pumping power is about 31 W, the output at 457nm reaches 4.2 W, and the optical to optical conversion efficiency is about 13.5% accordingly. The stability of the out putpower is better than 1.2% for 8 h continuously working.     

Call for Papers

正Wireless Body-area Networks The last decade has witnessed the convergence of three giant worlds:electronics,computer science and telecommunications.The next decade should follow this convergence in most of our activities with the generalization of sensor networks.In particular with the progress in medicine,people live longer and the aging of population will push the development of wireless personal networks     

Call for Papers—Feature Topic,Vol.12,No.7,2015

正Information Centric Networking Information-Centric Networking(ICN) is an emerging direction in Future Internet architecture research,gaining significant tractions among academia and industry.Aiming to replace the conventional host-to-host communication model by a data-centric model,ICN treats data content as the first     

JOURNAL OF ELECTRONICS(CHINA)

正~~     

NEXT GENERATION WIRELESS NETWORKS–ESPECIALLY THE USE OF MILLI-MICROWAVE BANDS

The global bandwidth shortage of wireless communications has motivated the exploration of the naillimeter wave （ram-wave） frequency spectrum for the next generation wireless communications. Recent advances in RF CMOS technology and high speed baseband signal processing technologies have enabled tile extensive research and development of turn-wave wireless communications. The multi gigabit per second data rate of ram-wave system will lead to applications in many important scenarios, such as WPAN, WLAN,back-haul for cellular system. And the frequency bands include 28 GHz, 38 GHz, 45GHz, 60GHz, E-BAND and even beyond 100 GHz. The propagation and the imitation of the RF circuits design in these frequency bands make the directional antennas be inevitable for mm-wave communications.