| 基于CAE分析的螺纹抽芯机构注射模结构设计 |
| |
| 引用本文： | 刘琼、林富坤、林永南.基于CAE分析的螺纹抽芯机构注射模结构设计[J].福建工程学院学报,2020,0(1):1-5. |
| |
| 作者姓名： | 刘琼、林富坤、林永南 |
| |
| 作者单位： | 福建工程学院材料科学与工程学院 |
| |
| 摘 要： | 以塑料管接头为研究对象，运用Moldflow软件对两种不同形状的流道设计方案进行了模流分析对比。在模流分析结果的基础上运用CAD及UGNX软件进行了注射模的设计。结果表明，经过Moldflow的模拟分析，采用S型流道的设计能够使塑料熔体及时充满型腔，塑件表面的波状纹路及翘曲变形都明显得到改善，提高了塑料连接管的成型质量。
|
| 关 键 词： | Moldflow 管接头 螺纹抽芯 侧浇口 |
Design of injection mold structure for thread core-pulling mechanism based on CAE analysis |
| |
| LIU Qiong,LIN Fukun,LIN Yongnan.Design of injection mold structure for thread core-pulling mechanism based on CAE analysis[J].Journal of Fujian University of Technology,2020,0(1):1-5. |
| |
| Authors: | LIU Qiong LIN Fukun LIN Yongnan |
| |
| Affiliation: | School of Materials Science and Engineering, Fujian University of Technology |
| |
| Abstract: | The plastic pipe joint is taken as the research object. Moldflow software was used to analyze and compare the flow patterns of plastic pipe joints of two different shapes. Based on the analysis results of the Moldflow, the injection mould was designed by using CAD and UGNX software. Results show that after Moldflow simulation, the design of S-shaped flow passage can allow plastic melts to fill the cavity in time. The wavy lines and warpage deformation on the surface of the plastic parts are obviously improved, and the forming quality of the plastic connecting pipes is improved |
| |
| Keywords: | Moldflow pipe joint thread core-pulling side gate |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《福建工程学院学报》浏览原始摘要信息 |
|
点击此处可从《福建工程学院学报》下载全文 |
