| 基于LabVIEW的电火花线切割放电加工状态的研究 |
| |
| 引用本文： | 杨蕾,蔡安江.基于LabVIEW的电火花线切割放电加工状态的研究[J].仪表技术与传感器,2012(3):41-43. |
| |
| 作者姓名： | 杨蕾 蔡安江 |
| |
| 作者单位： | 西安建筑科技大学机电工程学院,陕西西安,710055 |
| |
| 基金项目： | 西安市工业攻关计划项目(CXY08015-1) |
| |
| 摘 要： | 电火花线切割加工时放电加工状态决定着加工的质量和速度,电极丝和工件之间的放电电压是对放电加工过程进行实时检测的重要参数.以LabVIEW为开发平台,以放电电压为检测参数,构建了电火花线切割放电加工状态识别仿真系统.该系统主要包括线切割放电状态识别模块、BP神经网络放电预测模块以及加工稳定性分析模块,对提高电火花线切割加工质量、加工效率及智能化加工有良好的效果.
|
| 关 键 词： | LabVIEW WEDM 放电电压 BP神经网络 |
Research on Discharge Processing Status of WEDM Based on LabVIEW |
| |
| YANG Lei
,
CAI An-jiang.Research on Discharge Processing Status of WEDM Based on LabVIEW[J].Instrument Technique and Sensor,2012(3):41-43. |
| |
| Authors: | YANG Lei CAI An-jiang |
| |
| Affiliation: | (Xi’an University of Architecture and Technology,Xi’an 710055,China) |
| |
| Abstract: | In WEDM processing,discharge machining status decided the machining quality and speed.Voltage between took and workpiece was an important parameter in the on-line monintoring of wire electrical discharge machining process.This paper took discharge voltage as detect parameters,constructed the WEDM discharge recognition simulation system based on LabVIEW.The system mainly included discharge status identification module,BP neural network discharge forecasting module and processing stability analysis module.The system has a good effect in improving quality efficiency and intelligent processing in WEDM. |
| |
| Keywords: | LabVIEW WEDM discharge voltage BP neural network |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
