Study of Thermal Conductivity and Geometry Wall Contact Resistance Effect of Granular Active Carbon for Refrigeration and Heat Pumping Systems

The commercial success of sorption refrigeration and heat pump systems depends on a good heat and mass transfer in the adsorbent bed, which allows higher coefficients of performance and greater specific heating or cooling power that reduce capital costs. In this study the thermal conductivity and thermal contact resistance of vibrated and compressed granular active carbon and binary mixtures of active carbon are investigated using two types of conductivity measurements: a steady-state measurement between flat plates and a transient hot tube measurement. With these results is possible to draw conclusions on how the wall geometry, particle size distribution, and bulk density affect the overall thermal performance. Results show that using binary mixtures of grains and powder gives results superior to those of either grains or powder alone. The conductivity of the binary mixtures increases roughly linearly with bulk density and the 2/3 grain mixture achieves the highest densities. The method used to achieve compaction (vibration or compression) did not seem to affect the result. Thermal contact resistances reduce with increasing density but do vary with the mixture ratio, also appearing to be best with a 2/3 grain–1/3 powder mixture.