| 成形压力对SiCp/2024铝基复合材料性能的影响 |
| |
| 引用本文： | 王振,阎峰云,陈体军,张芳芳,李小红.成形压力对SiCp/2024铝基复合材料性能的影响[J].特种铸造及有色合金,2020(1):88-91. |
| |
| 作者姓名： | 王振 阎峰云 陈体军 张芳芳 李小红 |
| |
| 作者单位： | 兰州理工大学省部共建有色金属先进加工与再利用国家重点实验室;甘肃省有色金属及复合材料工程研究中心 |
| |
| 摘 要： | 采用直热法粉末触变成形工艺制备了SiCp体积分数为60%的SiCp/2024铝基复合材料,研究了成形压力对其孔隙率、抗弯强度、热膨胀系数的影响。结果表明,成形压力过大不利于提高复合材料的密度;成形压力为60 MPa时,复合材料的抗弯强度最大,为289.33MPa;随着成形压力增加,复合材料的热膨胀系数先增加后减小。在成形压力为60 MPa时,复合材料在200℃的热膨胀系数最小,为6.687×10^-6 K^-1。
|
| 关 键 词： | 触变成形 颗粒增强 复合材料 成形压力 |
Effects of Forming Pressure on Properties of SiCp/2024 Composites |
| |
| Wang Zhen,Yan Fengyun,Chen Tijun,Zhang Fangfang,Li Xiaohong.Effects of Forming Pressure on Properties of SiCp/2024 Composites[J].Special Casting & Nonferrous Alloys,2020(1):88-91. |
| |
| Authors: | Wang Zhen Yan Fengyun Chen Tijun Zhang Fangfang Li Xiaohong |
| |
| Affiliation: | (State Key Laboratory of Advanced Processing and Recycling of Non-ferrous Metals,Lanzhou University of Technology;Gansu Nonferrous Metals and Composites Engineering Research Center) |
| |
| Abstract: | SiCp/2024 composites with high volume fraction(60%)were prepared by direct thermal powder thixoforming.The effects of forming pressure on porosity,flexural strength and thermal expansion coefficient of the composites prepared were investigated.The results reveal that a higher forming pressure is harmful for the improvement of density of the composites.With the forming pressure of 60 MPa,the flexural strength of the composites reaches 289.33 MPa.With the increase of forming pressure,the thermal expansion coefficient of the composites is increased firstly and then decreased When the forming pressure is 60 MPa,the thermal expansion coefficient of the composites reaches 6.687×10^-6 K^-1 at 200℃. |
| |
| Keywords: | Thixoforming Particle Reinforced Composites Forming Pressure |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
